Mountfield 4000 Series Instructions Manual

8211-0561-01
INSTRUCTIONS FOR USE
92 cm - 107 cm cutting deckfor Mountfield 4000 series 

2
125 Combi Pro
ABDB
M
5 mm
10 mm13 mm
13 mm
1
J
K
L
C
1/3
3
5 
71
4 
6 
82 

3
Q 9,8 Nm
P 24 Nm
24 Nm
11
13 9
1210  

4
ENGLISHEN
1 GENERAL
This symbol indicates WARNING. Seri-
ous personal injury and/or damage to 
property may result if the instructions 
are not followed carefully.
You must read these instructions for use 
and the machine’s safety instructions 
carefully.
1.1 SymbolsThe following symbols appear on the machine. 
They are there to remind you of the care and atten-
tion required in use.
This is what the symbols mean:
Warning!
Read the instruction manual and the safety 
manual before using the machine....

5
ENGLISHEN
4. Force the belt onto the cutting deck’s belt pul-
ley.
5. Grip the belt tensioner’s lever with your left 
hand. Pull the lever and apply the tensioner to 
the outside of the belt with your right hand. See 
fig. 5.
6. Fit the belt cover. See fig. 2.
7. Lift up the cutting deck so that it locks in the 
catches (6:L).
3.2 Tyre pressureAdjust the air pressure in the tyres as follows:
Front: 0.6 bar (9 psi).
Rear: 0.4 bar (6 psi). 
3.3 Basic settingIn order for the cutting deck to cut optimally,...

6
ENGLISHEN
5.3 Washing position1. Activate the parking brake.
2. Set the implement lifter in transport position.
3. Set the highest cutting height.
4. Lift up the rear section of the cutting deck, undo 
the catches (6:L) and lower.
5. Grip the front edge of the deck and lift up. Hook 
on the chain so that the deck is pointing diago-
nally upwards. See fig. 9.
It is absolutely forbidden to start the 
engine when the deck is in the washing 
position.
Reset in accordance with 3.1.1, point 7.
5.4 Service...

Manufactured by GGP Sweden AB