Home
>
Motorola
>
Portable Radio
>
Motorola Astro Digital Spectra Digital Spectra Plus Basic 6881076c20 E Manual
Motorola Astro Digital Spectra Digital Spectra Plus Basic 6881076c20 E Manual
Here you can view all the pages of manual Motorola Astro Digital Spectra Digital Spectra Plus Basic 6881076c20 E Manual. The Motorola manuals for Portable Radio are available online for free. You can easily download all the documents as PDF.
Page 61
6881076C20-EFebruary 3, 2003 Test Equipment, Service Aids, and Tools: Service Aids and Recommended Tools 4-3 Table 4-4. Common Service Aids for Board-Level Troubleshooting Motorola Part NumberDescriptionApplication 30-80370E06 Extender Cable Provides extension cable for VOCON Board (connectors P501/J501) RPX-4725A (includes 30-80370E05 Extender Cable)Command and Control Service Cable KitProvides extension cables for servicing digital and analog circuits RPX-4724A (includes:RF Service Cable...
Page 62
February 3, 20036881076C20-E 4-4Test Equipment, Service Aids, and Tools: Service Aids and Recommended Tools Table 4-5 lists additional service aids that can be used in troubleshooting ASTRO Digital Spectra radios. Table 4-6 lists additional service aids that can be used in troubleshooting ASTRO Digital Spectra Plus radios.Table 4-5. Service Aids for ASTRO Digital Spectra Board-Level Troubleshooting Motorola Part NumberDescriptionApplication RLN-4008_ Radio Interface Box (RIB) Enables communications...
Page 63
6881076C20-EFebruary 3, 2003 Test Equipment, Service Aids, and Tools: Field Programming Equipment 4-5 4.3 Field Programming Equipment The ASTRO family of radios can be aligned and programmed in the field. This requires specific equipment and special instructions. For ASTRO Digital Spectra radios, refer to the applicable Radio Service Software User’s Guide for complete field programming information. For ASTRO Digital Spectra Plus radios, refer to the online help in the Customer Programming Software....
Page 64
February 3, 20036881076C20-E 4-6Test Equipment, Service Aids, and Tools: Field Programming Equipment The following items, available through the Customer Care and Services Division (except the computer), are required when programming ASTRO Digital Spectra Model radios. 4.3.1.1 ASTRO Digital Spectra W3 Smart RIB Issue When flashing a Model W3 mobile radio, the smart RIB box tends to reset if the correct power-up sequence is not observed. To avoid this problem, you must power up the radio before you use...
Page 65
6881076C20-EFebruary 3, 2003 Test Equipment, Service Aids, and Tools: Field Programming Equipment 4-7 In mid-power radios, when this cable is used, programming must be done through the rear accessory connector. 4.3.2 ASTRO Digital Spectra Plus The ASTRO Digital Spectra Plus radios use a flash memory device to store information on frequencies, squelch codes, signaling codes, time-out timer durations, and other parameters. The ASTRO Digital Spectra Plus radios can be programmed in the field any number of...
Page 66
February 3, 20036881076C20-E Notes 4-8Test Equipment, Service Aids, and Tools: Field Programming Equipment
Page 67
Chapter 5 Performance Checks 5.1 Introduction This section covers performance checks used to verify that the radio meets published specifications. The recommended test equipment listed in the previous section approaches the accuracy of the manufacturing equipment, with a few exceptions. Accuracy of the equipment must be maintained in compliance with the manufacturer’s recommended calibration schedule. 5.2 Test Setup The equipment required for performance checks is connected as shown in the following...
Page 68
February 3, 20036881076C20-E 5-2Performance Checks: Test Mode 5.2.2 ASTRO Digital Spectra Plus Figure 5-2. ASTRO Digital Spectra Plus Performance Checks Test Setup 5.3 Test Mode NOTE:The test mode for the ASTRO Spectra radio is different from the standard Spectra radio, but is similar to the ASTRO portable test mode. Be sure to transmit into a load when keying a radio under test. 5.3.1 Entering Test Mode 1. To enter test mode, turn the radio on. 2. Within 10 seconds after Self Test is complete, press...
Page 69
6881076C20-EFebruary 3, 2003 Performance Checks: Test Mode5-3 4. Pressing the Mode rocker will cause the displays to stop. The test mode menu, CH TEST, will be displayed. 5. Pressing the Home button will cause the displays to stop. The RF test mode will be entered. The display will show 1 CSQ, indicating test frequency 1, Carrier SQuelch mode. 6. Go to the RF Test Mode section. 5.3.2 RF Test Mode A special routine, called RF TEST MODE or air test, has been incorporated in the radio. 1.Enter the RF...
Page 70
February 3, 20036881076C20-E 5-4Performance Checks: Test Mode 2. In RF test mode, press the Vo l u m e rocker to adjust the volume. The volume display for the ASTRO Digital Spectra will be in 256 increments, not the usual 16, while in the test mode. This allows for precise setting of rated audio, etc. For the ASTRO Digital Spectra Plus, the volume is still displayed as a value between 0 to 15. 3. Press the Home button to move the cursor back and forth between the frequency and signaling type (See...