Mitsubishi Electronics XD430U Projector User Manual
Here you can view all the pages of manual Mitsubishi Electronics XD430U Projector User Manual. The Mitsubishi Electronics manuals for Projector are available online for free. You can easily download all the documents as PDF.
Page 21
EN-21 ENGLISH Password function This projector is equipped with the password function that is designed for prevention of wrong operation by children and restriction on operation by other than specified users. MENU ACCESS ........ All the buttons except for the POWER button on the projector are disabled. (The buttons on the remote control are enabled.) You can use this mode as a measure of prevention of wrong operation by children and restriction on operation by other than specified users. To...
Page 22
EN-22 Lamp replacement When the lamp no longer functions, replace it with a new one. Caution: Do not remove the lamp immediately after using the projector. You may get burned because the lamp very hot after use. Before replacing the lamp, press the POWER button to turn off the lamp and wait for two minutes for lamp to cool down. Unplug the power cord from wall outlet and wait one hour for the lamp to cool down completely. Do not remove the lamp except for replacement. Careless han- dling can...
Page 23
EN-23 ENGLISH Troubleshooting The following offers solutions to some of the common problems you may encounter. We suggest that you consult this chart before contacting your dealer. Images aren’t projected on the screen. ProblemCause and solution Power isn’t turned on. Check the states of the indicators. Images aren’t projected on the screen. Cancel the AV mute by pressing the MUTE button. Remove the lens cap. The lamp sometimes takes about one minute to light up. On rare occasion, the...
Page 24
EN-24 Troubleshooting (continued) Images aren’t projected correctly. ProblemCause and solution Projected images are shaking. Projected images are displaced. Check that the cable connected to the external device isn’t intermittent. Connect the cable’s plug with the external device’s connector firmly. Press the AUTO POSITION button. Some computers output out-of-spec signals on rare occasion. Adjust the SIGNAL menu. (See page 19.) Projected images are distorted. Adjust the projector and the...
Page 25
EN-25 ENGLISH Others When the problems below occur after the lamp is replaced, check the following. Maintenance Caution: Be sure to turn off the lamp and unplug the power cord from the wall outlet before you perform any maintenance on the projector. Cleaning of the projector and the ventilation slots Use a soft cloth to clean the projector and the ventilation grilles. When the grilles become dirty, wipe them with a soft cloth dampened with diluted mild detergent, and then wipe them with a dry cloth....
Page 26
EN-26 Indicators This projector has two indicators, each of which shows the operation condition of the projector. The following offer solutions to possible problems. If these problem persist, turn the projector off and consult your dealer. Normal condition Abnormal condition POWERSTATUSCONDITIONNOTE Stand-by Lamp stand-by (about 1 minute)The POWER button cannot be used to switch between on and off. The power is on. (Normal condition) STATUS indicatorPOWER indicator Steady redOff Steady greenBlinking...
Page 27
EN-27 ENGLISH Specifications The specifications and outside appearance of the projector are subject to change without prior notice. Ty p e D L P ™ D ATA p r o j e c t o r Model XD430U/SD430U Rated power supply 100 - 240 V AC, 50 / 60 Hz Rated input 2.9 A (XD430U/SD430U) Display Technology0.55-inch Single chip Digital Micromirror Device (DMD) with R,G,B,W color wheel Pixels 1024 x 768 = 786432 pixels (XD430U) Pixels 800 x 600 = 480000 pixels (SD430U) Colors 16770000 colors Projection lens F...
Page 28
EN-28
Specifications (continued)
Connectors
Dimensional drawings (unit : mm)
What’s included in the box
Replacement part
15 11
610 15
pin No.Spec.
1 R(RED)/C
R
2 G(GREEN)/Y
3B(BLUE)/C
B
4GND
5GND
6GND
7GND
8GND
9DDC5V
10 GND
11 GND
12 DDC Data
13 HD/CS
14 VD
15 DDC Clock
pin No.Spec.
1R(RED)/C
R
2G(GREEN)/Y
3B(BLUE)/C
B
4-
5GND
6GND
7GND
8GND
9-
10 GND
11 -
12 -
13 HD/CS
14 VD
15 -
COMPUTER IN/OUT (Mini D-SUB 15-pin)
IN OUT
AC power cord
1 RGB cable for PC
1 VIDEO cablefor US 02552-0063-01
for EU...
Page 29
EN-29 ENGLISH Specification of RGB signals in each computer mode of the projector Important: Some computers aren’t compatible with the projector. The projector’s maximum resolution is 1024 x 768 pixels (800 x 600 pixels for SD430U). It may not display images of higher reso- lutions than 1024 x 768 (or 800 x 600) correctly. Images with SYNC on G (Green) signal may jitter. Images with SYNC on G (Green) signal may be tinged with green. If the resolution and frequency of your computer aren’t...
Page 30
North AmericaMESCA (Mitsubishi Electric Sales Canada Inc.) http://www.mitsubishielectric.ca Information Technologies Group, 4299 14th Avenue, Markham, Ontario L3R 0J2, Canada Sales & Technical Inquires Phone :+1-(800) 450-6487 Fax :+1-(905) 475-7958 E-mail :[email protected] Customer Care E-mail :[email protected] MDEA (Mitsubishi Digital Electronics America, Inc.) (Warranty Registration) http://www.mitsubishi-presentations.com/ Presentation Products Division, 9351 Jeronimo...