Mitsubishi Electric Lt 40164 Owners Guide

 Appendices 81
For assistance call 1(800) 332-2119
If prompted for a name, 4. 
highlight a name for the 
device and press ENTER to 
add a check.  The device 
itself may later override the 
name assigned.
Highlight 5. On and press 
ENTER to add a check.
Highlight 7. EXIT and press ENTER to close the New 
Device Found screen.
Note:  At any time after completing Auto Input Sens-
ing, you can set the TV’s HDMI control on or off 
in the Inputs > HDMI Control menu.
265 Series.8.   To supplement HDMI control...

82 Appendices
For assistance call 1(800) 332-2119
HDMI Control of an HDMI A/V 
Receiver and Connected Devices
Note: Connect the A/V receiver to the TV with an 
HDMI cable before making other connections.
Enable HDMI Control for the A /V receiver as 1. 
described in “Enabling HDMI Control of CEC 
Devices” on the previous page.
Power on the HDMI device you wish to connect to 2. 
the A /V receiver (such as a disc player, cable box, 
or satellite receiver).  Allow the device to complete 
the power-on...

 Appendices 83
For assistance call 1(800) 332-2119
Using HDMI Control
As an example of using HDMI Control, press P L AY on 
the device itself to:
Power on the TV•	
Switch to the device (no need to display the •	
Input Selection menu)
Begin play of the device•	
Direct Keys
Test your equipment with the TV’s remote control to 
find additional supported commands.  See the table 
below for commands that may be available, depending 
on the individual device.
CEC-enabled VCR, DVD, and DVR functions that 
may be...

84 Appendices
For assistance call 1(800) 332-2119
Cleaning Recommendations
Normally, light dusting with a dry, non-scratching duster 
will keep your TV clean.  If cleaning beyond this is 
needed, please use the following guidelines:
First, turn off the TV and unplug the power cord from 
the power outlet.
Occasionally clean dust build-up from the air-intake 
grilles on the back and sides of the TV.  Clean using a 
vacuum cleaner with a brush attachment.
Top and Sides of the TV 
Gently wipe down your TV...

 Appendices 85
For assistance call 1(800) 332-2119
Reset NameWhen to UseHow to UseResulting Action
FormatIf the picture shape 
(aspect ratio) seems 
incorrect, use the 
FORMAT key to change 
the shape of the 
picture.
Press FORMAT to cycle through the 
aspect ratios available for the signal.
The last-used format for a signal 
type is memorized for each input.  
The next time the same input and 
signal type are viewed, the last-
used format will be recalled.
PerfectColor™/ 
PerfecTint™ 
Reset (265...

86 Appendices
For assistance call 1(800) 332-2119
Reset NameWhen to UseHow to UseResulting Action
A /V Reset
(for all inputs)
To reset audio and 
video adjustments for 
all inputs to the original 
factory settings.
While viewing the TV, press the 
control-panel buttons INPUT and 
VOLUME DOWN at the same time for at 
least two seconds.
All Audio and Video settings are 
returned to the original factory 
settings, including global settings 
not affected by Picture > Reset.
Channel 
Memorization
To erase and...

 Appendices 87
For assistance call 1(800) 332-2119
Appendix E:  Troubleshooting, continued
General TV Operation
SymptomRemarks
 1.The TV remote control does not work.Check that the batteries are fresh and installed correctly.•	
Check that the control mode on the remote is set to TV.•	
Be no more than 20 feet from the TV when using the remote control.•	
Program the remote control to operate the TV or other device.•	
Reset the remote control.  See •	“Resetting the Remote Control,”  
page 84.
 2.When I try...

88 Appendices
For assistance call 1(800) 332-2119
Appendix E:  Troubleshooting, continued
TV Channels
SymptomRemarks
 1.The TV takes several seconds to respond to 
channel changes.
It is normal for digital channels to take longer to tune in.•	
Press •	ENTER after entering a channel number to minimize 
delays.
Use a 4-digit number for an over-the-air digital channel.•	
Use a 6-digit number for digital cable channels if your cable •	
service is able to recognize 6-digit channel numbers.
 2.You cannot...

 Appendices 89
For assistance call 1(800) 332-2119
Appendix E:  Troubleshooting, continued
Picture
SymptomRemarks
 1.Picture does not look like a high-definition 
picture.
Not all signals are high-definition signals.  To receive high-defini-
tion programming from your cable or satellite provider, you must 
subscribe to the provider’s high-definition service.   Some over-
the-air broadcasts are in high-definition and can be received with 
a high-quality antenna suited to your location.
 2.TV has sound but...

90 Appendices
For assistance call 1(800) 332-2119
Appendix E:  Troubleshooting, continued
Sound 
SymptomRemarks
 1.There is no sound even when the 
volume is turned up.
•	 Check	if	the	MUTE key is on.
•	 The	TV’s	analog	Listen to setting may be set to SAP (analog 
program from the ANT input) but no SAP is being broadcast.
•	 Check	that	the		Sound > Audio > TV Speakers option is set to On 
to hear sound from the TV speakers.  Possibly the TV Speakers 
option is Off or set to Center but there is no A /V...