Miele W 4144 Wps Operating Instructions

The following are selected via the
display:
– wash temperature
– spin speed
– delay start
– cancellation of a programme
– safety lock
– programmable functions
The display also shows:
–
the programme duration
–
the programme sequenceProgramme duration
After the start of a programme, the
estimated programme duration will
appear in the display in hours and
minutes.
When delay start is being used, the
programme duration will appear after
the delay start time has elapsed.
During the first 8 minutes the...

Before using the machine for the first
time ensure that it is correctly
installed and connected. See
Installation and connection. Also
check that the drain filter is securely
tightened to prevent the risk of water
leaks during use.
This washing machine has
undergone a thorough functional test
in the factory and there will be some
residual water in the drum from this
process.
For safety reasons, spinning is not
possible until the machine has been
prepared for using for the first time. To
activate the...

Energy and water consumption
–Water consumption and energy
usage are determined by the size of
the load.
To make the most out of your
machine, load the maximum dry load
for the programme you are using.
–Use theAutomaticandExpress
programmes for small loads.
–When smaller amounts of laundry are
washed using theCottons
programme, the automatic load
recognition system will reduce the
amount of water, time and energy
used. This may mean that the time
left shown in the display is adjusted
during the course of...

Brief instructions
The headings numbered,
,,...
show the operating sequence and can
be used as brief instructions.
Sort the laundry
Empty all pockets.
Foreign objects (e.g. nails,
coins, paper clips, etc.) can cause
damage to garments and
components in the machine.

Badly soiled areas, stains etc. should
be cleaned as soon as possible,
preferably whilst still fresh. Spillages
should be carefully dabbed off using
a soft colourfast cloth. Do not rub!
Badly soiled areas can be pre-treated
with liquid...

Switch on the washing machine
Load the drum
Press theDoorbutton to open the
drum door.
Unfold the laundry and load loosely
in the drum. Mixing both large and
small items gives better wash results
and also helps distribute the load
evenly during spinning.
The most efficient use of energy and
water is achieved when a full load is
washed. However, do not overload as
this causes creases and reduces
cleaning efficiency.
Make sure that no garments are
caught between the drum door and
seal.

Shut the door...

Select an extra option(s)
Select any extra options by pressing
the appropriate button. The relevant
indicator light will come on to show
which extra option has been
selected.
Not all the extra options are suitable for
use with every programme.
You can only select extra options which
are compatible with the basic
programme being used.
Short
For light to normal soiling with no visible
staining.
The duration of the main wash is
reduced.Water plus
The water level in the main wash and
the rinses will be...

Add detergent
It is important to dispense the correct
amount, because...
. . . too little detergent results in:
–Laundry not getting properly clean
and with time it may become grey
and hard to the touch.
–Greasy particles clinging to the
laundry.
–Limescale deposits on the heater
elements.
. . . too much detergent results in:
– Excessive foam which causes a low
level of agitation and poor wash,
rinse and spin results.
– Higher water consumption (an
additional rinse cycle will
automatically switch in).
–...

Start the programme
Press the flashingStart/Stopbutton.
If a delay start time has been selected,
then this will count down in the display.
At the end of the delay start time or im
-
mediately after the programme has
started (if no delay start time has been
selected) the estimated programme
duration will appear in the display.
During the first 8 minutes the machine
measures how much water is being
absorbed by the laundry. The
programme duration may be longer or
shorter depending on this absorbency...

Final spin speed
Programme rpm
Cottons 1400
Minimum iron 1200
Delicates 600
Woollens 1200
Silks 400
Express 1400
Automatic 1200
Shirts 600
Denim 900
Outerwear 800
Dark garments 1200
Spin 1400
You can reduce the final spin speed.
However, you cannot select a final spin
speed higher than that shown in the
chart above.
Rinse and interim spin
There is a spin after the main wash and
between the rinses. A reduction in the
final spin speed will also reduce the
interim spin speed. If a spin speed of
less than...

Delay start allows you to choose when
you want the programme to start. The
start of a programme can be delayed
from 30 minutes up to a maximum of 24
hours, allowing you to make use of
night-time economy electricity rates, for
example.
Selecting delay start
Press theDelay startbutton. The
following will appear in the display:
0:3060° 1400
Each press on theDelay startbutton
increases the delay start time:
– in 30 minute steps up to 10 hours,
– in 1 hour steps from 10 hours
upwards.
If you keep theDelay...