Miele W 1514 User Manual

							The following are selected via the
display:
–wash temperature
–spin speed
–programmable functions
–cancellation of a programme
–safety lock
The display also shows:
–the programme duration
–
the programme sequenceProgramme duration
After the start of a programme, the
estimated programme duration will
appear in the display in hours and
minutes.
During the first 8 minutes the washing
machine measures how much water is
being absorbed by the laundry and
uses this to calculate the load. The
programme duration may be longer or
shorter depending on this absorbency
rate.
Programmable functions
The programmable functions can be
used to tailor washing programmes to
suit your individual requirements. In
programming mode, the display will
show the function selected.
Operating the washing machine
11 
						

							Before using the machine for the first
time ensure that it is correctly
installed and connected. See
Installation and connection. Also
check that the drain filter is securely
tightened to prevent the risk of water
leaks during use.
For safety reasons, spinning is not
possible until the machine has been
prepared for using for the first time. To
activate the spinning function you must
run a wash programme without laundry
and without detergent.
Using detergent could result in an
excessive build-up of foam.
This also activates the ball valve. The
ball valve prevents detergent escaping
from the suds container into the sump
during a wash programme, thus making
maximum use of the detergent.
^Press theI-On/0-Offbutton in.
If the washing machine is being
switched on for the first time, the
welcome screen will appear.
The welcome screen will appear in
the display every time the machine is
switched on until a programme
lasting longer than 1 hour has been
completed.
Setting the language
You will be asked to select the
language you require for the display. It
is possible to change the language at
any time via the programmable
functions.
!deutsch
^If the language shown is not the one
you want, select the language you do
want by turning the programme
selector. Confirm your selection by
pressing theStart/Stopbutton.
Reminder to remove transit bars
To avoid the risk of damage, the
transit bars must be removed before
the machine is used for the first time.
See Installation and connection for
instructions on how to do this.
^After removing the transit bars (if this
has not already been done by your
fitter), press theStart/Stopbutton.
Running your first programme
Run a Cottons 60°C programme without
any laundry and without detergent.
^Open the stopcock.
^
Press theStart/Stopbutton.
^
At the end of the programme switch
the machine off.
The machine is now ready for use.
Before using for the first time
12 
						

							Energy and water consumption
–Water consumption and energy
usage are determined by the size of
the load.
To make the most out of your
machine, load the maximum dry load
for the programme you are using.
–Use theAutomaticandExpress
programmes for small loads.
–When smaller amounts of laundry are
washed using theCottons
programme, the automatic load
recognition system will reduce the
amount of water, time and energy
used. This may mean that the time
left shown in the display is adjusted
during the course of the wash
programme.
–Using theCottons 60°Cprogramme,
instead of theCottons 95°C
programme will give energy savings
of between 35% and 45%. This is
sufficient for most levels of soiling.Detergent
–Do not exceed the amounts of
detergent recommended by the
manufacturer on the packaging.
–Adjust the dosage to the degree of
soiling of the laundry.
–Reduce the amount of detergent with
smaller loads (approx.
1/3less than
the amount recommended can be
used when washing a half load).
Choosing the correct extra option
(Short and Pre-wash)
Select:
–A wash programme together with the
Shortextra option for light to normal
soilingwhere there are no obvious
marks.
–A wash programme without any extra
options for normal to heavy soiling
with visible staining.
–ThePre-washextra option for laundry
with large amounts of dirt(e.g. dust,
sand).
When drying with a tumble dryer
–
Selecting the highest possible spin
speed for the wash programme will
save energy when drying in a tumble
dryer afterwards.
Washing environmentally and economically
13 
						

							Brief instructions
The headings numberedA,B,C,...
show the operating sequence and can
be used as brief instructions.
ASort the laundry
^Empty all pockets.
,Foreign objects (e.g. nails,
coins, paper clips, etc.) can cause
damage to garments and
components in the machine.
^
Badly soiled areas, stains etc. should
be cleaned as soon as possible,
preferably whilst still fresh. Spillages
should be carefully dabbed off using
a soft colourfast cloth. Do not rub!
Badly soiled areas can be pre-treated
with liquid detergent, stain removers
etc. first, following the manufacturers
instructions. With particularly stubborn
stains ask your dry cleaner for advice.
,If you use a solvent-based clean
-
ing agent (e.g. one containing ben
-
zene) to pre-treat a stain, make sure
that any plastic parts (e.g. buttons)
are protected, and that the cleaning
agent is rinsed off before washing the
garment in the machine.
,Do not use solvent-based
cleaning agents in this machine.
^Sort the laundry by colour and by
care label. Most garments have a
textile care label in the collar or side
seam.
Dark textiles often contain excess dye
and should be washed separately
several times before being included in
a mixed load. Always wash whites and
coloureds separately.
–Curtains: Remove lead weights first
or place in a laundry bag.
–
Underwiring and collar stiffeners:
Any loose wiring in bras, shirt collar
stiffeners, etc. should be removed or
sewn in.
–
Knitted garments, trousers and
jeans, T-shirts and sweat shirts: Turn
inside out, if recommended by the
manufacturer.
–
Close any zips, fasten hooks and
eyes etc before washing.
–
Fasten duvet covers etc. to prevent
small items from being rolled up
inside them.
Do not wash any items in this machine
which are specified by the
manufacturer asnot washableon the
care label. (hsymbol)
How to wash correctly
14 
						

							BSwitch on the washing machine
CLoad the drum
^Press theDoorbutton to open the
drum door.
^Unfold the laundry and load loosely
in the drum. Mixing both large and
small items gives better wash results
and also helps distribute the load
evenly during spinning.
The most efficient use of energy and
water is achieved when a full load is
washed. However, do not overload as
this causes creases and reduces
cleaning efficiency.
Make sure that no garments are
caught between the drum door and
seal.
^
Shut the door with a gentle swing.DSelect a programme
^Turn the programme selector
clockwise or anti-clockwise to the
required programme. The
programme indicator light for the
programme selected will come on.
ESelect a temperature / spin speed
The suggested temperature and/or spin
speed can be changed.
1:49 60° 1400
^
Press theTemperaturebutton to alter
the temperature and press theSpin
speedbutton to alter the spin speed.
How to wash correctly
15 
						

							FSelect an extra option(s)
^Select any extra options by pressing
the appropriate button. The relevant
indicator light will come on to show
which extra option has been
selected.
Not all the extra options are suitable for
use with every programme.
You can only select extra options which
are compatible with the basic
programme being used.
Short
For light to normal soiling with no visible
staining.
The duration of the main wash is
reduced.Water plus
The water level in the main wash and
the rinses will be increased if theWater
plusoption is selected.
However, you can select other settings
forWater plus. These are described in
Programmable functions.
Pre-wash
For laundry with large amounts of dirt
e.g. dust, sand.
Buzzer
An audible tone sounds repeatedly at
the end of a programme and when
Rinse hold is reached. The buzzer will
sound repeatedly until the machine is
switched off. The volume of the buzzer
can be changed, see Programmable
functions.
How to wash correctly
16 
						

							GAdd detergent
It is important to dispense the correct
amount, because...
. . . too little detergent results in:
–Laundry not getting properly clean
and with time it may become grey
and hard to the touch.
–Greasy particles clinging to the
laundry.
–Limescale deposits on the heater
elements.
. . . too much detergent results in:
–Excessive foam which causes a low
level of agitation and poor wash,
rinse and spin results.
–Higher water consumption (an
additional rinse cycle will
automatically switch in).
–A burden to the environment.^Pull out the detergent drawer and
place detergent in the compartments
as follows:
i
Detergent for the pre-wash (divide
the total recommended amount as
follows: add
1/3to compartmenti
and2/3to compartmentj)
j
Detergent for the main wash
§
Fabric conditioner or liquid starch
^
Close the detergent drawer.
See Detergent for further information.
How to wash correctly
17 
						

							HStart the programme
^Press the flashingStart/Stopbutton.
The estimated programme duration will
appear in the display once the
programme has started. During the first
8 minutes the machine measures how
much water is being absorbed by the
laundry. The programme duration may
be longer or shorter depending on this
absorbency rate.
The programme sequence is also
shown in the display. The washing
machine shows you when each section
of the programme is reached.
IRemove the laundry when the
programme has finished
In the anti-crease phase after the
programme has finished, the following
will appear alternately in the display:
0:00 Anti-crease
and
0:00 Finish
^
Press theDoorbutton to open the
drum door.
^
Remove the laundry.
Check that all items have been
removed from the drum. Items left in
the drum could discolour other items
in the next wash or become
discoloured themselves.
^Check the folds in the door seal for
any small articles, e.g. buttons which
might be lodged there.
^Switch the machine off with the
I-On/0-Offbutton.
^
Close the drum door. Otherwise there
is the danger of objects being placed
inadvertently in the drum. If these
remained unnoticed and were
washed in the next load, they could
damage the laundry.
How to wash correctly
18 
						

							Final spin speed
Programme rpm
Cottons 1400
Minimum iron 1200
Delicates 600
Woollens 1200
Express 1400
Automatic 1200
Shirts 600
Denim 900
Dark garments 1200
Spin 1400
You can reduce the final spin speed.
However, you cannot select a final spin
speed higher than that shown in the
chart above.
Rinse and interim spin
There is a spin after the main wash and
between the rinses. A reduction in the
final spin speed will also reduce the
interim spin speed. If a spin speed of
less than 700 rpm is selected for a
Cottonsprogramme, an additional rinse
is introduced.To omit the final spin (Rinse hold)
^Select theesetting using theSpin
speedbutton. The laundry will not be
spun and will remain suspended in
the final rinse water. This reduces
creasing if the laundry is not going to
be removed from the drum immedi
-
ately after the end of the programme.
–To start the final spin
:
The washing machine will display the
maximum spin speed possible. You
can select a spin speed lower than
this. Start the final spin by pressing
theStart/Stopbutton.
–To end the programme
:
Press theDoorbutton. The water will
drain away. Press theDoorbutton
again to open the door.
To omit rinse and interim spin and
the final spin (Nou)
^Select theNousetting using the
Spin speedbutton. The laundry is not
spun after the final rinse. The water
will drain away and the machine will
go straight into the anti-crease stage.
An additional rinse is introduced if
this setting is selected with the
Cottons,Minimum iron,Expressand
Automaticprogrammes.
Spinning
19 
						

							Cottons987630°C to 95°C Max. load 5.0 kg
Fabric Cottons, linens or cotton mix fabrics, e.g. table linen, towelling,
underwear, T-shirts etc.
Extra options Short, Water plus, Pre-wash
Note for test institutes:
Short programme: 2.5 kg load andShortextra option
Minimum iron
42187630°C to 60°C Max. load 2.5 kg
Fabric Synthetics, mixed fibres and easy care cottons. If fabrics have a
high proportion of man-made fibres, it is advisable to programme
the machine for Gentle action. See Programmable functions.
Note Reduce the spin speed for fabrics which crease easily.
Extra options Short, Water plus, Pre-wash
Delicates421accold to 60°C Max. load 1.0 kg
FabricFor delicate garments made of synthetic fibres, mixed fibres, rayon
and easy care cottons. Also suitable for machine-washable silks.
Curtains, including net curtains, specified as machine-washable
by the manufacturer.
Notes–Dust in curtains usually makes using a programme with a
Pre-wash advisable.
–
For curtains which crease easily, reduce the spin speed or
deselect the spin.
Extra options Short, Pre-wash
Woollens/accold to 40°C Max. load 2.0 kg
Fabric Machine-washable or hand-washable wool or wool blend fabrics.
If the care label does not specify a temperature, wash using the
cold setting.
Also suitable for hand-washable silks. Reduce the spin speed.
Express76cold to 40°C Max. load 2.5 kg
Fabric Small loads of items which require freshening up and which can
be washed in aCottonsprogramme.
Note This programme can be used for rinsing individual items. Select
the cold setting, and do not add any detergent.
Extra option Water plus
Programme chart
20