Miele T 8823 C Manual

							Adjusting the dryers
electronics for very soft water
Extremely soft water can affect
the sensitivity of the control
electronics.
Important
If the dryer is installed in an area with
very soft water, you should contact your
local water supplier for information and
advice regarding water hardness and
water conductivity.
If the water conductivity is less than 150
µS, the following programmable
function will need to be activated.
This programmable function should
not be activated if, despite the water
being extremely soft (as would be
the case if a water softener were
used), its conductivity is greater
than 150 µS.
Otherwise, the drying result will not
be satisfactory.
Follow steps (
,,...) to
programme and store in memory.
Before you begin, first ensure that:
–
The dryer is switched off.
–
The door is closed.

Press theStart/Stopbutton and keep
it pressed in whilst carrying out steps
-.
Switch the dryer on.
Wait until the indicator light for
theStart/Stopbutton lights up
constantly.... . . and then release theStart/Stop
button.
Press theLow temperaturebutton
ten times.
–The indicator lightLow temperature
will flash on and off slowly once and
will then flash on and off quickly
twice.
The option selected will be displayed
by anumberwhich will alternate with
P.
0Default setting
IAdjusted for very soft water(with
low conductivity)
(TheAutomatic plusindicator light
will also flash.)
Pressing theStart/Stopbutton
switches from one to the other.
Switch the dryer off.
The settings have been changed. You
can alter the settings again at any time.
Control

Repeat steps
to.

Switch the dryer off after step.
Programmable functions
61 
						

							Extending the drying level
range
You can extend the range of the
drying levels for many of the
programmes:
Machine iron plus
(drier than Machine iron).
Slightly dry
(drier than Hand iron).
Normal plus
(drier than Normal).
You can use this programming function
only for programmes which allow you to
select the drying levels.
Follow steps (
,,...) to
programme and store in memory.
Before you begin, first ensure that:
– The dryer is switched off.
– The door is closed.

Press theStart/Stopbutton and keep
it pressed in whilst carrying out steps
-.
Switch the dryer on.
Wait until the indicator light for the
Start/Stopbutton lights up constantly
...
. . . and then release theStart/Stop
button.
Press theLow temperaturebutton
eleven times.
–
The indicator lightLow temperature
flashes short once and long three
times.
The option selected will be displayed
by anumberwhich will alternate with
P.
0Default setting
iDrying level range extended
(TheAutomatic plusindicator light
will also flash.)
Pressing theStart/Stopbutton
switches from one to the other.
Switch the dryer off.
The settings have been changed. You
can alter the settings again at any time.
Control
Repeat steps
to.
Switch the dryer off after step.
To select the extended drying level
Select a programme.

Press the drying level button
repeatedly until one or two indicator
lights come on.
–
Indicator lightsExtra dryandNormal
= Normal plus
–
Indicator lightsHand ironand
Normal= Slightly dry
–
Indicator lightsMachine ironand
Hand iron= Machine iron plus
Programmable functions
62 
						

							63 
						

							M.-Nr. 07 847 190 / 01Alteration rights reserved/1912