Miele Stb 2053 Manual

Park-System
(Unable to be used with the
powerbrush SEB 236)
A Park-System has been designed to
conveniently park the telescopic wand
at the vacuum cleaner during pauses.
^ A special parking attachment is fitted
to all floor brushes. Insert the lower
clip on the floor brush into the slot on
the end of the vacuum cleaner from
above.
Turning on and off with the
Park-System
Parking the floor brush while
vacuuming automatically turns the
vacuum off. Lifting the floor brush out of
the Park-System turns the...

Transport and storage
^For easier transportation and storage
stand the vacuum cleaner vertically.
^ Insert both clips of the floor brush
into the two point holder on either
side of the vacuum (this function
cannot be used with the Powerbrush
SEB 236).
To use one of the following floor tools,
the supplied extension wand, a, must
be inserted between the floor tool and
electro telescopic wand.
– Standard floor brush
– Turbobrush
– Hard floor brush
This makes the vacuum easier to carry
and store. Push the...

,Turn off and unplug the vacuum
cleaner before performing any
maintenance work.
The Miele filter system consists of the
following three components.
– Dustbag
– Exhaust filter
– Dust compartment filter
Each of these filters must be changed
periodically to maintain the vacuum
cleaner’s efficiency.
,Use only Miele dustbags with the
Miele quality signet and an original
Miele filter. This ensures optimum
performance of the suction power
and also ensures that the bag is
used to capacity.
The use of non-Miele...

When to change the dustbag
Change the dustbag when the colored
marker in the airflow indicator fills the
display.
Miele dust bags are disposable and
made to be used only once. Do not
attempt to reuse.
Checking the airflow indicator
^ Attach the floor tool to the vacuum
cleaner. Perform this test with the
floor tool only, since other
attachments can affect the function of
the airflow indicator.
^ Turn the vacuum cleaner on and
select the highest power setting.
^ Lift the floor brush slightly off the...

How to change the dustbag
^Lift the release button for the dust
compartment, raise the lid until it
clicks into place.
The dustbag has a closing flap which
closes automatically when the dust
compartment lid is raised to prevent
any dust from escaping.
Grasp the collar and remove the
dustbag from the holder.
^ Insert the new dust bag as far as it
will go into the dustbag holder. Do
not unfold the dustbag when taking it
out of the box. Keeping it folded will
prevent it from getting caught when
the dust...

When to change the exhaust
filter
Always change the ACTIVE HEPA filter
when the filter change indicator (Reset
button) lights. It is designed to light
after approximately 50 hours of
operation which is about a year of
average use. You can continue to
vacuum. However, the suction power
will be reduced as will the effectiveness
of the filter if it is not replaced.
You can replace the ACTIVE HEPA
filter supplied with the cleaner with a
SUPER air clean or an ACTIVE air
clean filter (see Exchanging exhaust...

Replacing the ACTIVE HEPA
filter
^Open the dust compartment lid.
Do not use more than one filter at a
time.
^ Lift and remove the filter.
^ Insert a new filter and press it
downwards.
If you wish to replace the SUPER air
clean filter with an ActiveAirClean
filter or Active HEPA filter see
Maintenance and care -
Exchanging exhaust filters.
^ Close the dust compartment lid firmly
until it clicks into place.
Resetting the filter change indicator
The filter change indicator (Reset
button) must be reset each...

Exchanging Exhaust Filters
You can replace thecACTIVE HEPA
filter which is fitted as standard to your
vacuum cleaner with either the:
a Super Air Clean
b Active Air Clean (black)
If replacing c with a, please note:
If you are using exhaust filter ayou
have to insert it into a filter frame, see
Optional accessories.
Do not use more than one filter at a
time.
The dust filter reset button is
designed for the changing cycle of
the Active Air Clean filter and the
Active HEPA filter.
If a Super Air Clean...

When to change the dust
compartment filter
Change the filter each time you open a
new box of genuine Miele dustbags. A
dust compartment filter is supplied with
every box of Miele dustbags.
How to change the exhaust
filter
^Open the dust compartment lid.
^ Lift the filter frame and remove the
used exhaust filter at the clean side.
^ Insert the new filter.
^ Close the filter frame.
Maintenance and care
29 

When to change the thread
catcher
The thread catcher pads on the bottom
of the rug and floor tool and the
upholstery tool should be replaced as
soon as they appear worn.
Changing the thread catcher
^Use a knife or similar object to
remove the thread catcher pads from
the slots.
^ Press the new thread catcher into the
slots.
Servicing the floor roller
^ Use a coin to release the roller pin
and pull it out.
^ Push and take out the roller axle.
^ Take out the roller.
^ Remove all threads, hair, etc. and...