Miele Kfns 3917 Sded Operating And Installation Instructions

							The StayFresh zone is divided into two
areas:
–Thedry compartmenthas a relative
humidity level of approx. 45 %.
–Thehumidity controlled
compartmenthas a control for
setting the humidity level between
45 % and 90 %. Slide the control to
the humidity level you require.
The humidity level will also be affected
by the moisture content of the food
being stored and how often the
compartment is opened.
Low humidity level,
^To set a humidity level of approx.
45 %, slide the control for the
humidity controlled compartment
over to the left,.
This humidity level is suitable for storing
particularly delicate food such as fresh
fish, shell fish, meat, poultry, sausage,
dairy products and salads.
Keep food covered or packaged in
this compartment with the exception
of meat.High humidity level-
^To set a humidity level of approx.
90 %, slide the control for the
humidity controlled compartment
over to the right-.
This humidity level is suitable for storing
fresh produce such as vegetables,
salad, herbs, and seasonal fruit.
Store these types of food uncovered
in the compartment.
Food which should not be
stored in a refrigerator
Not all food is suitable for storing in the
refrigerator. These include:
– Fruit and vegetables which are
sensitive to cold, such as bananas,
avocado pears, papaya, passion
fruit, aubergines/eggplant,
peppers/capsicum, tomatoes and
cucumbers
–
Fruit which is not yet ripe
–
Potatoes
–
Some hard cheeses, e.g. Parmesan
Using the refrigerator efficiently
21
 
						

							Storing food correctly
Store food covered or packaged. This
will prevent food smells or tastes from
affecting other foods, and prevent food
from drying out and also any
cross-contamination of bacteria. The
growth of bacteria, such as salmonella,
can be avoided by setting the correct
temperature and maintaining good
standards of hygiene.
Fruit and vegetables
Fruit and vegetables can be stored
loose in the vegetable containers.
However, you should bear in mind that
some types of vegetables give off a
natural gas which speeds up the rate at
which food perishes. Some fruit and
vegetables react strongly to this gas
and should not be stored together.
Examples of fruit which produce a
large amount of this natural gas are:
Apples, apricots, pears, nectarines,
peaches, plums, avocado pears and
figs.
Examples of fruit and vegetables
which react strongly to the natural
gases given off by other types of fruit
and vegetables are:
Kiwis, broccoli, cauliflower, Brussels
sprouts, mangos, honeydew melons,
apples, apricots, cucumbers, tomatoes,
pears, nectarines and peaches.Different types of unpacked meats
and vegetables must be kept
separate.
To avoid any microbiological
cross-contamination, these foods may
only be stored together if they are
wrapped.
Protein rich foods
Please note that foods rich in protein
deteriorate faster than others.
Shell fish for example deteriorates
faster than fish, and fish deteriorates
faster than meat.
Meat
Store meat in suitable containers, but
uncovered in the low humidity
compartment. (Undo wrappings and
leave containers open). The surface of
the meat will dry out slightly and protect
it from bacterial growth thus increasing
its storage qualities. To prevent the risk
of bacterial contamination keep meat
stored in suitable containers and do not
let different types of meat come into
direct contact with each other.
Take food out of the StayFresh zone
approx. 30 - 60 minutes before using
it. The aroma and taste do not fully
develop until the food has reached
room temperature.
Using the refrigerator efficiently
22
 
						

							Moving the shelves
The shelves can be adjusted according
to the height of the food.
^Pull the shelf forward as far as it will
go; then lift it upwards to remove it.
^With the rear barrier facing upwards,
place the shelf at the required
position.
The rear barrier must face upwards to
prevent food from touching the back
of the appliance and freezing to it.
Split shelf
In order to accommodate tall items in
the appliance, one of the shelves is
divided. The front section can be
pushed under the rear section.
^Pull the front half of the glass shelf
forwards slightly and then push it
carefully under the rear half.
Adjusting the door shelves
^Push the door shelf upwards, then
remove it by pulling it forwards.
^Replace the door shelf at the
required position. Ensure that it is
securely pushed back into position.
Moving the bottle divider
(Depending on model)
The bottle divider can be moved to the
left or right to ensure that bottles are
held securely in position when the door
is opened and shut.
StayFresh zone compartments
^When loading and unloading items,
pull the compartment right out by
taking hold of it at the back and lifting
it up to remove it.
^
To put it back in, pull the runnersa
right out and place the compartment
on top of the runners.The front of
the runners must be right up
against the front of the
compartmentb. Push the
compartment back inc.
Adjusting the interior fittings
23
 
						

							Refrigerator section and
StayFresh zone
Condensate and frost can build up on
the back wall of the refrigerator section
and the StayFresh zone whilst in use.
These are automatically removed and
defrosted by the appliance.
The condensate is drained away via a
channel and drain hole into an
evaporation system at the back of the
appliance.
Ensure that the condensate channel
and drain hole are kept clean and
are never blocked so that
condensate can flow away without
hindrance.
Automatic defrost
24
 
						

							Never use cleaning agents
containing abrasive substances
such as sand, soda, acids or
chemical solvents.
Non-abrasive cleaning agents are
also unsuitable as they can cause
matt areas to appear.
Stainless steel surfaces should be
cleaned with a proprietary stainless
steel cleaner following the
manufacturer’s instructions on the
packaging.
Make sure that no water can
penetrate into the electronic unit or
into the light.
Do not let water get into the
drainage channel and drain hole
when cleaning.
Do not use steam cleaning
apparatus to clean the appliance.
Steam could reach the electrical
components and cause a short
circuit.
The data plate located inside the
appliance must not be removed. It
contains information which is
required in the event of a service
call.
Before cleaning
^
Switch the appliance off, switch off at
the socket and remove the plug.
^
Take any food out of the appliance
and store it in a cool place.^Take out any removable parts e.g.
shelves for cleaning.
^The stainless steel trim can be pulled
off the front edge of the refrigerator
section shelves for cleaning.
Cleaning the outer casing, the
interior and accessories
^Clean the refrigerator section and the
StayFresh zone at least once a
month.
^Accessories and shelves should all
be hand-washed. The butter dish is,
however, dishwasher safe.
^Clean the condensate channel and
drain hole frequently, so that
condensate can drain away
unhindered. Use a straw or similar to
clear the drain if necessary.
^Clean stainless steel surfaces with a
suitable cleaning agent following the
manufacturer’s instructions on the
packaging.
^
After cleaning, wipe the interior and
accessories with a damp cloth and
dry with a soft cloth. Leave the door
open to air the appliance for a short
while.
E-Cloth
^
A microfibre E-Cloth is available
from the Miele UK Spare Parts
Department which is suitable for
cleaning surfaces such as stainless
steel, glass, plastic and chrome
without the use of chemicals.
Cleaning and care
25
 
						

							Ventilation gaps
^The ventilation gaps should be
cleaned on a regular basis with a
brush or vacuum cleaner. A build up
of dust will increase the energy
consumption of the appliance.
Door seal
Do not use any oils or grease on the
door seal as these will cause the
seal to deteriorate and become
porous over time.
The door seal should be cleaned
regularly with clean water and then
wiped dry with a soft cloth.
Metal grille at the back of the
appliance
The metal grille at the back of the
appliance (heat exchanger) should be
dusted at least once a year. A build-up
of dust will increase the energy
consumption of the appliance.
When cleaning the grille, make sure
that the pipework and other
components do not get broken or
damaged in any way.
After cleaning
^
Replace all shelves and accessories
in the refrigerator section and the
StayFresh zone and put your food
back into the appliance.
^
Close the appliance door, insert the
plug in the socket and switch the
appliance back on.
Cleaning and care
26
 
						

							Repairs to electrical appliances
should only be carried out by a
suitably qualified and competent
person in accordance with local and
national safety regulations. Repairs
and other work by unqualified
persons could be dangerous. The
manufacturer cannot be held liable
for unauthorised work.
Some minor problems can be corrected
without contacting the Miele Service
Department.
What to do if . . .
. . . the appliance does not get cold.
^Check whether the appliance has
been switched on. The temperature
display must be lit up.
^Check that the plug is correctly
inserted in the socket and switched
on.
^
Check that the fuse is not defective
and that the mains fuse has not
blown. If it has, contact the Miele Ser-
vice Department.
. . . the temperature in the refrigerator
section is too low.
^
Select a warmer temperature.
. . . the appliance is switching in too
frequently and for too long.
^
Check whether the ventilation gaps
have been covered over or become
dusty.^Check whether the metal grille (heat
exchanger) at the back of the
appliance has become too dusty.
^The door has been opened too
frequently, or a large amount of food
has been put in at once.
^Check that the door has been closed
properly.
. . . The temperature display is
flashing.
The temperature has risen by several
degrees in the refrigerator section
because
^large quantities of food which are too
warm have been placed in the
appliance.
^the door was left open for too long
whilst putting food into the appliance
or rearranging it.
When you finish putting food into the
appliance or rearranging it the
electronics automatically adjust the
temperature to the one last set. A loss
of coldness for a short period will not
affect the food in the appliance.
. . . the following messages show in
the temperature display F0 to F5.
There is a fault. Call the Service
Department.
. . the alarm sounds.
Has the appliance door been open for
longer than 60 seconds?
^
Close the door.
Problem solving guide
27
 
						

							. . . the floor of the refrigerator
section or the StayFresh zone is wet.
The drain hole is blocked.
^Clean the condensate channel and
drain hole.
. . . the interior lighting in the
refrigerator section is not working.
^Was the door left open for too long?
The lighting switches itself off
automatically after approx. 15
minutes.
If the door has not been left open for
this length of time the interior lighting is
defective.
To change it follow the instructions
below. The lighting component
required (cool touch lamp with light
diodes) is available from the Miele
Spare Parts Department.
Take care when removing the lamp
cover.
Do not look at the LEDs with optical
instruments.
^
Disconnect the appliance from the
mains. Switch off at the wall and
withdraw the plug from the socket, or
disconnect the mains fuse or remove
the screw-out fuse in countries where
this is applicable.^Press the lamp coverato the ceiling
and then pull it forward to release it.
^Unscrew the lighting componentb
and disconnect the cable and plug
connectorsc.
^
Fit the new lighting component by
reversing the above procedure.
If you still cannot remedy the fault
having followed these suggestions,
please contact the Miele Service
Department.
To prevent unnecessary loss of
temperature it is advisable not to
open the door while waiting for the
appliance to be serviced.
Problem solving guide
28
 
						

							Normal noises What causes them
Brrrrr...Humming noise made by the motor (compressor). This noise can
get louder for brief periods when the motor is switching on.
Blubb, blubb....A gurgling noise can be heard when coolant is circulating
through the pipes.
Click....Clicking sounds are made when the thermostat switches the
motor on and off.
Sssrrrrr....On multi-zone and frost-free appliances you can sometimes just
hear the movement of air circulating inside the appliance.
Remember that the noise of the compressor and the coolant circulating in the
system is unavoidable.
Noises that you can
easily rectifyWhat causes them, and what can you do about
them?
Rattling, vibrating The appliance is uneven:Realign the appliance using a spirit
level,  by raising or lowering the screw feet underneath the
appliance.
The appliance is touching another appliance or piece of
furniture:Move it away.
Drawers, baskets or shelves are unstable or sticking:Check
all removable items and refit them correctly.
Are any bottles or containers unstable or knocking against
each other?Separate them.
The transport cable clips are hanging loose at the back of
the appliance:Remove the clips.
Noises
29
 
						

							In the event of a fault which you cannot
correct yourself, or if the appliance is
under guarantee, please contact:
–your Miele Dealer
or
–the Miele Service Department (see
back cover for address).
When contacting your Dealer or the
Service Department, please quote the
model and serial number of your
appliance. This information is given on
the data plate.
Please note that telephone calls may
be monitored and recorded for
training purposes.
After sales service
30