Miele Kfn 9755 Ide Operating And Installation Instructions

							^Break off the protruding end of
bottom covere. It is no longer
required.
^Fit angled covergonto bottom fixing
bracketc.
^Close the appliance doors.
Fitting the furniture doors
^
A gap of 8 mmamust be set
between the appliance door and the
central fixing bracket.
^
Push fitting aidsbup to the height of
the furniture door: the lower edge X
of the fitting aids must be at the same
height as the upper edge of the
furniture door being fitted (see-on
the diagram).
^
Undo nutscand take fixing bracket
doff together with the fitting aids.^Using a pencil, lightly mark a line
down the centre of the inside of the
furniture door.
^Hang fixing bracketdwith the fitting
aids onto theinsideof the furniture
door. Align the fixing bracket
centrally.
^Attach the fixing bracket securely
using at least 6 short4x14mm
chipboard screwse. (On cassette
doors only use 4 screws on the
edges).
^
Pull the fitting aids upwards to
remove themf.
^
Turn them around and fit them into
the middle slots on fixing bracketg
for safe keeping.
61
Building in the appliance
 
						

							^Hang the furniture door onto
adjusting boltsh.
^Loosely attach nutscon the
adjusting bolts.
^Close the door and check the
distance between the door and
neighbouring furniture doors.
^Align to match neigbouring doors if
necessary:
Side adjustments X are made by
sliding the furniture door, and height
adjustments Y by turning adjusting
boltshwith a screwdriver.
^
Tighten nutsc.Securing the appliance doors to the
furniture doors:
^Drill fixing holesain the furniture
doors and screw in the4x14mm
screwsb.
Make sure the two metal edges are
alligned (SymbolII).
– Align depth Z on the furniture door:
Loosen screwscat the top of the
appliance door, and loosen the
hexagon-headed screwdat the
bottom of the fixing bracket. By
moving the furniture doors, create a
gap of 2 mm between the furniture
doors and the front edge of the
housing unit.
Building in the appliance
62
 
						

							^Close both of the doors, and align
them with the neighbouring furniture
doors.
^Whilst counterholding adjusting bolts
gwith a screwdriver, tighten nutse
on the appliance doors with ring
spannerf.
^
Cover striphmust be completely
hidden in the niche, and must not
protrude.
^
Tighten all screws again.^Replace top coveri, and snap it
into place.
^Replace side coversj, making sure
they snap into place.
^Replace side coversk, making sure
they snap into place.
To make sure the appliance is
correctly fitted:
–
The doors must close properly.
–
The doors must not touch the
housing unit.
–
The seals at the top edge of the
handle side must fit properly.
^
To double check place a torch in the
appliance and close the doors. Turn
the lights out in the room. If you can
see any light shining out from the
sides double check the installation.
Building in the appliance
63
 
						

							Alteration rights reserved / 1712
KFN 9755 iDEM.-Nr. 09 307 600 / 01