Miele Kf 9757 Id Operating And Installation Instructions

~Do not store explosive materials in
the appliance or any products
containing propellants (e.g. spray
cans). Thermostats switching on may
produce sparks which could present a
fire hazard. Flammable compounds
could explode.
~Do not operate any electrical
equipment (e.g. an electric ice-cream
maker) inside the appliance. Danger of
sparking and explosion.
~If storing alcohol with a high
percentage proof, make sure it is tightly
closed and stored upright. Danger of
explosion.
~Do not store cans or bottles...

~The appliance is designed for use
within certain climate ranges (ambient
temperatures), and should not be used
outside this range. The climate range
for your appliance is stated on the data
plate inside the appliance.
Installing it in a room with too low an
ambient temperature, e.g. a garage,
can lead to the appliance switching off
for longer periods so that it cannot
maintain the required temperature.
~Never use a steam-cleaning
appliance to defrost or clean this
appliance. Pressurised steam could...

Normal energy
consumptionIncreased energy
consumption
Installation siteIn a ventilated room. In an enclosed, unventilated room.
Protected from direct sunlight. In direct sunlight.
Not situated near to a heat source
(radiator, oven).Situated near to a heat source
(radiator, oven).
Where the ideal ambient room
temperature is approx. 20°C.Where there is a high ambient
room temperature.
Temperature setting with
a thermostat which is
approximate
(set in stages).With a medium setting of 2 to 3. With a high...

Before using for the first time
The stainless steel trim to the interior
shelves and the door shelves has a
layer of protective foil to prevent
scratching during transportation.
^Do not remove this foil until the
appliance has been built in.
^Treat the stainless steel surfaces with
a proprietary stainless steel
conditioner immediately after
removing the foil (available from the
Miele Spare Parts department or via
the internet on www.miele.co.uk).
Important! A stainless steel
conditioner gives long...

Switching off
^Press the master switch on the right
hand side of the control panel until
both temperature displays go out.
The cooling system is switched off. If
this does not happen, then the safety
lock has been activated.
To switch the refrigerator
section/PerfectFresh zone off
separately
The refrigerator section/PerfectFresh
zone can be switched off without
having to switch off the freezer section.
This is useful e.g. whilst on holiday.
^Press the On/Off button for the
refrigerator...

^Press the master switch on the right
hand side of the control panel to
come out of the setting mode.
If you do not do this, the electronics will
switch over to normal operation
automatically after a couple of minutes.
Switching off for longer
periods of time
If the appliance is not going to be used
for a longer period of time, e.g. whilst
on holiday:
^switch the appliance off,
^switch off at the wall socket and
withdraw the plug,
^defrost the freezer, clean the
appliance and
^leave the doors ajar to air...

It is very important to set the correct
temperature for storing food in the
appliance. Micro-organisms will cause
food which is not stored at the correct
temperature to deteriorate rapidly.
Temperature influences the growth rate
of these micro-organisms. Reducing
the temperature reduces their growth
rate.
The temperature in the appliance will
rise:
–the more often the door is opened
and the longer it is kept open,
– the more food that is stored in the
appliance,
– the warmer the food is which is being...

Setting the temperature in the
refrigerator section / freezer
section
Use the two buttons underneath the
respective temperature displays to set
the temperature for the refrigerator and
freezer sections.
Press the
+ button: to raise the temperature
(it gets warmer)
– button: to reduce the temperature
(it gets cooler).
The temperature being set will flash in
the display.
When pressing the buttons, the
following information shows in the
display:
– When first pressed, thelast
temperature selectedflashes.
–...

^Press one of the temperature selector
buttons repeatedly until a
=appears
in the display. Then press the Super
freeze button again.
=lights up in the display.
^You can now adjust the temperature
in the PerfectFresh zone by pressing
the temperature selector buttons. You
can choose from settings1to9:
1: lowest temperature,
9: highest temperature.
=5is the default setting for the
PerfectFresh zone. If a setting of
=1
to
=4is selected, the temperature
can fall below 0°C. Food could
freeze!
^Press the Super...

Temperature display brightness
The appliance is supplied with the
brightness of the temperature display
set as low as possible. However, if the
door is opened, a setting changed or if
the alarm is sounding, the temperature
display will appear much brighter for
approx. 1 minute.
The level of brightness can be
adjusted:
^Press and hold the Super freeze
button for approx. 5 seconds.
The Super freeze indicator light flashes
and a
;flashes in the temperature
display.
^
Press one of the temperature selector...