Miele Kf 8582 Sded Operating And Installation Instructions

							^Remove coverg, and unscrew hinge
bracketh.
^Fit hinge piniin the second hole of
hinge bracketh.
^Refit bracketjand coverkturned
through 180° on the opposite side.
^
Screw hinge brackethinto the
opposite side.
TheM4 screwhas to be screwed into
the left hole of the hinge bracket.
^
Turn covergthrough 180°, and fit it
on the other side.
^
Exchange coverlin the middle of
the appliance with bracketm. To do
this:
Unscrew coverland bracketm,
turn them around and screw in on the
opposite side.
^
Pull bearing bushndownwards out
of hinge bracketmand refit it from
above into the bracket.^Remove the plugs from the door
bearing bushes in the top of the
doors and refit on the opposite side.
^Hang the upper appliance door on
hinge piniand close the appliance
door.
^Push middle pinefrom below
through bracketminto the upper
appliance door.
^Check that the upper door is
correctly aligned. If necessary, align
it using the long slots in bracketm.
^
Hang the lower door on pineand
then close the appliance door.
^
Fit lower hinge bracketbin the door
bearing bush of the lower door. Then
screw it securely to the housing.
^
Refit covera.
Changing the door hinging
41
 
						

							Refitting the handles:
Please make sure you follow the
instructions below carefully when
you refit the handle. The door seal
will be damaged if the handle is
fitted incorrectly.
^Loosely attach the handle to the
opposite side of the door with the two
front screwsb.
Mounting platecmust be positioned
on the side of the door so that when the
door isclosedit is flush with the side of
the appliance.
If this is not the case
^
Tighten the two grub screwsawith
the allen key provided until mounting
plateclines up correctly.
^
Then tighten all 4 fixing screwsb.^Slide the side section of the handle
dinto the guides on the mounting
plate until it clicks into place.
It is important to check that the side
section of the handleddoes not
come into contact with the door seal
when opening the door, as this
would damage the door seal
permanently.
If, after you have refitted the handle,
you find that the side section does
touch the door seal when the door is
opened:
^Realign mounting platecwith grub
screwsauntil the mounting plate
and the side section of the handled
are at the correct angle and the side
section does not touch the seal when
the door is opened.
Changing the door hinging
42
 
						

							The appliance can be installed in a
kitchen run. To match the height of the
rest of the kitchen, the appliance can
be fitted with a suitable top boxa.
A ventilation gap of at least 50 mm
depth must be allowed for behind the
appliance and top box, if fitted, for air
to circulate.
A gap of at least 40 mm is required
between the top of the appliance (or
top box) and the ceiling to ensure that
air can circulate without hindrance.
Otherwise the appliance has to work
harder, resulting in an increase in
electricity consumption. The larger the
cross-section, the more efficient the
appliance.
The air inlet and outlet must not be
covered or blocked in any way.
They should be dusted on a regular
basis.
Wheninstalled next to a wallca
distance of approx. 50 mm is needed
on the hinge side between the wall and
the applianceb, so that the doors and
the handles have sufficient space for
opening.
Building in the appliance
43
 
						

							Änderungen vorbehalten / 4705
KF 8582 SD edM.-Nr. 06 779 200 / 00
en-GB