Miele Kdn 9713 Id Operating And Installation Instructions

							All building-in instructions given are
for aright hand hingedappliance.
If you have converted the appliance
to left hand hinging you will need to
adapt these instructions
accordingly.
Building into a peninsular run
When built into a peninsular run, the
rear of the building in niche must be
fitted with a kitchen furniture panel.
Aligning the housing unit
Before installing the appliance, the
housing unit must be carefully aligned
using a spirit level. The housing unit
corners must be at right angles, as
otherwise the appliance furniture door
will not align correctly with the 4
corners of the unit. Align the furniture
door with the hinges.
Preparing the appliance
^Slide cover stripainto the holder as
shown, with the bumps facing
downwards. The bumps will fit into
keyhole slotsb. The cover strip is
then flush with the side of the
appliance on which the door is
openedc.
Building in the appliance
41
 
						

							Building in the appliance
^Attach sealing stripato the door
opening side so that it sits flush at the
front with the side of the appliance. If
necessary the sealing strip can be
trimmed to size along the lower edge
of bracketb.
^
Remove coverscandd.
^
Secure bracketbwith screwse
(4.8 x 16 mm).
^
Push the appliance into the
building-in niche, leaving a gap of
approx. 4 mm.
Take care not to trap the mains
cable.^Push in the appliance until the front
edges of bracketband hinge plates
fandgare flush with the front
edge of the housing.
^Align the appliance height from
above on both sides using adjusting
screwh.
^Carefully unscrew adjusting screwi
in the middle of hinge platejuntil it
touches the side wall of the furniture
housing unit.
Building in the appliance
42
 
						

							Securing the appliance and
fitting the furniture door
^
Push the appliance against the
housing wall on the side on which the
door opens so that the sealing strip is
pressed into the housing wallk.
^
Secure the appliance at the top with
screwl(4 x 19 mm) into bracketb,
pushing the appliance against the
furniture wall as you do so.
^
Then secure the appliance in the
middle by fitting screwmthrough the
adjusting screw.
^
Then secure the appliance at the
bottom by fitting screwsn
(4 x 36 mm) through the adjusting
screws in the hinge plates.^Tighten all the screws.
^If necessary, align cover stripoby
pushing it parallel to the top of the
unit - it should not protrude.
^Fold in the side section of bracketb.
^Replace coverscandd.
^Cap the holes with stopperspand
q.
^Secure door fixingsrto the
appliance doors with screwss
(3.9 x 9.5 mm), to suit the position of
the handles.
With divided doors, several door fixings
may be required.
^Open the doors right out, and push
fixing guidestinto door fixingsr.
^Position the furniture door onto the
appliance door, and secure fixing
guidestto the furniture door using
screwsu(4 x 14 mm). Maintain a
distance d (= the thickness of the
housing unit walls) between the edge
of the appliance door and outer edge
of the furniture door.
^
Align the door fixing so that the
furniture door on the side with the
handle does not lie against the
housing unit wall when the door is
shut. Aminimum distance of 1 mm
must be maintained.
Building in the appliance
43
 
						

							Alteration rights reserved / 4810
KDN 9713 iD, KDN 9713 i-1M.-Nr. 07 927 230 / 00