Miele G 4700 Manual

Programme options
51Delay start
You can set the start time for a pro‐
gr
amme, e.g. to take advantage of night
time electricity tariffs. The start time
can be delayed between 30 minutes
and 24 hours. 
The delay period is shown in 30-minute
increments for a delay period between
30 minutes and 9 hours 30 minutes. It is
shown in hours for periods longer than
this. When using the Delay start function,
mak

e sure that the detergent com‐
partment is dry before adding deter‐
gent. Wipe dry with a cloth if...

Programme options
52 If "Optimise standby" is switched on
(see "P
rogramme options - Optimise
standby"), the display will go out after
a few minutes, leaving just the  Start
indicat

or light flashing slowly. Press any button to switch the display
back on aga
 in for a few minutes.The time up until the programme starts
will appear counting down in the dis‐
play in hou

rs for durations above
10 hours, and in hours and minutes for
durations below this. When the set time is reached, the...

Programme options
53Adjust Sensor wash
You can adjust the  Sensor wash pr
o‐
gramme so that it will remove stubborn
soiling in a lightly soiled load. 
Switch the dishwasher off with the 
butt
 on, if it is switched on.
P
ress the  Start button in and, whilst
holding it in, switch the dishwasher
on using the   button.
Keep the  Start 
button pressed in for
at least 4 seconds until the  Start indi‐
cat

or light comes on. If this does not happen, start the proce‐
dur
 e from the beginning again. 
P...

Programme options
54Optimise standby
"Optimise standby" is activated by de‐
fault. To save energy, the dishwasher will
switch off aut
omatically a few minutes
after the last time a button has been
pressed or after the end of a pro‐
gramme. The dishwasher will not switch off
whilst a pr

ogramme is running, during
the Delay start period or if there is a
fault. "Optimise standby" can be switched off
if you pr

efer. If you do this, the duration
before the dishwasher switches off in‐
creases...

Programme options
55Factory default settings
If you have altered any settings from
the fact
ory default, you can reset them
back to the factory default settings as
follows: 
Switch the dishwasher off with the 
butt
 on, if it is switched on.
P
ress the  Start button in and, whilst
holding it in, switch the dishwasher
on using the   button.
Keep the  Start 
button pressed in for
at least 4 seconds until the  Start indi‐
cat

or light comes on. If this does not happen, start the proce‐
dur
 e from the...

Programme chart
56 Programme Programme sequence
Pre-wash Main wash Interim rinse Final rinse Drying
     
    °C   °C  
ECO 
1) X 48 X 46 X
Sensor wash Variable programme sequence,
senso
r-controlled adjustment according to amount of crockery and soiling If 
r

equired 47-55 If 
r
equired 65 X
Light soiling
55°C X 55 X 68 X
Intensive
75°C 2X 75 X 68 X
Sensor wash
gentle 
 X 44 X 65 X
Quick wash
40°C   40 X 45 X
1)
T
 his programme is the most efficient in terms of its combined energy and water con‐...

Programme chart
57Consumption 
2) Duration 
2) Electricity Water
Cold water Hot water Litres Cold water Hot water
kWh kWh   h:min h:min
0.60 0.35 9.4 2:37 2:33
0.70 
3)
 -1.15  4) 0.55 
3)
 -0.75  4) 6.5 
3)
 -14.0  4) 1:25-2:40 1:20-2:30
       
1.15 0.65 13.0 1:59 1:47
1.30 0.90 14.0 2:54 2:42
0.85 0.50 11.5 1:41 1:32
0.55 0.20 9.5 0:46 0:36
2)
In pr
 actice there may be variations to these figures due to variable conditions and data
recorded by the sensors. The durations displayed in your dishwasher...

Programme chart
58Mixed, 
everyday crockery
Heat-sensitive glasses and  plastic
Mixed crockery
Pots, pans, everyday porcelain and cutlery
All fresh to dried-on  food deposits
Fresh, easily removed food  deposits
Fresh food deposits which have begun to dry on
Burnt-on, stubborn, dried-
on food deposits containing  starch or protein 
1)
Variable, sensor-controlled programme sequence
Shorter duration
This needs a short programme 
Shorter duration
This needs a gentle  
programme with glass care
Shorter...

Programme chart
59-25 ml or 
1 tabSensor wash
+short
-20 ml  or 
1 tab 
3)
Quick wash 40°C
+short
-20 ml  or 
1 tabSensor wash gentle 
+short
-25 ml  or 
1 tab
ECO
-25 ml  or 
1 tabLight soiling 55°C
+short
10 ml25 ml  or 
1 tabIntensive 75°C
+short
2) see "Detergent"3) In some cases, tabs may not dissolve complet ely.
Detergent
Compartment I 
2)Compartment II 2)
Programme  

Cleaning and care
60 Check your dishwasher regularly (ap‐
pr
ox. every 4-6 months). This way
faults and problems can be avoided. 
The e
xternal surfaces of this ap‐
pliance are all susceptible to
scratching. Contact with unsuitable cleaning
ag

ents can alter or discolour the ex‐
ternal surfaces. Cleaning the wash cabinet
The wash cabinet is largely self-clean‐
in
 g, provided that the correct amount of
detergent is always used. If, however, there are limescale or
gr
 ease deposits in the cabinet,...