Miele G 1262 Scvi Operating Instructions

							Problem Possible fault Solution
Glasses are
discolored and
the film cannot
be wiped off.Detergent deposits. Use a different detergent.
Clouding or
etching on
glasses.Possible causes may be :
excessive rinse aid, incorrect
water hardness level set, type
and amount of detergent.
Any one or a combination of
these faults may be to blame.See the relevant section of
this manual to:
–adjust the rinse aid
dosage,
–adjust the water
hardness level,
–change the type and/or
adjust the amount of
detergent used,
– connect the dishwasher
to a cold water supply.
Glasses are dull
and discolored,
film cannot be
wiped off.Glasses are not dishwasher safe. There is no remedy. Only
wash dishwasher safe
glasses in the dishwasher.
Tea or lipstick
stains have not
been completely
removed.The wash temperature of the
selected program was too low.Select a program with a
higher temperature.
The detergent has a low
bleaching effect.Use a different detergent.
Plastics are
discolored.Natural dyes e.g. from
vegetables may be the cause.
Not enough detergent was used
to break down natural dyes.Use more detergent, see
Adding detergent.
Discoloration is
permanent.
There are rust
stains on cutlery.The affected items are not
corrosion resistant.There is no remedy. Only
wash dishwasher safe
cutlery in the dishwasher.
A program was not run after
refilling salt (depending on
model). Salt residuals got into the
wash cycle.Start the Express
program (empty and
without the Turbo function)
after refilling the salt.
The salt container lid was not
screwed on properly (depending
on model).Reseat and screw the lid
on firmly.
Frequently asked questions
41
 
						

							10 place settings, Standard program:Normal
Upper basket Lower basket
Cutlery tray
Comparison tests
42
 
						

							Repairs
In the event of a fault which you cannot
correct yourself please contact the
Miele Service Department at the phone
number on the back of this booklet.
Please quote the model type and
number of your appliance.
These can be found on the data plate
along the right edge of the door.
PC Update
The Program Correction (PC) allows a
technician to update the dishwasher to
make use of new technology.
When, for example, technological
developments offer advanced
modifications to your existing program
cycles a service technician will be able
to input these into your machine
controls via the indicator light marked
PC. Miele will provide information when
such possibilities become available.
MieleCare
(USA only)
MieleCare, our Extended Service
Contract program, gives you the
assurance of knowing that your
appliance investment is covered by
5 years of worry free ownership.
MieleCareis the only Extended Service
Contract in the industry that guarantees
repairs by a Miele Authorized Service
Provider using genuine Miele parts.
Only genuine Miele parts installed by
factory trained professionals can
guarantee the safety, reliability, and
longevity of your Miele appliance.
Please note that unless expressly
approved in writing by Miele’s Service
department, Extended Service
Contracts offered by other providers for
Miele products will not be recognized
by Miele. Our goal is to prevent
unauthorized (and untrained) service
personnel from working on your Miele
products, possibly doing further
damage to them, you and/or your
home.
To learn more aboutMieleCare
Extended Service Contracts, please
contact your appliance dealer or visit
us online at:
http://mieleusa.com/mielecare
After sales service
43
 
						

							To transport the dishwasher, e.g. when
moving to a new home, note the
following:
–Empty the dishwasher.
–Secure any loose parts, e.g. hoses,
cables, cutlery baskets.
–Transport the dishwasher in the
upright position. If unavoidable it
may be transported on its back. Do
not transport it on its side or on the
door. Residual water in the machine
could leak and cause electrical
damage.
Transport
44
 
						

							User Maintenance Instructions
To prevent accidents
and appliance damage,
read these instructions
before
installation or use.
 
						

							Check and clean your dishwasher
regularly. This will help avoid faults
and problems.
Abrasive cleaning agents,
all-purpose cleaners, thinner or
ammonium cleaners should not be
used on the dishwasher.
Theywilldamage the surface.
Wash cabinet
Generally, the wash cabinet is self
cleaning if the correct amount of
detergent is used.
The wash cabinet can be cleaned with
a dishwasher cleaner such as Dis
Cleaner available from your Miele
dealer, Miele or online at
www.miele.com.
Door and the door seal
Wipe the door seals regularly with a
damp cloth to remove food deposits.

Food residue and spilled liquids
should be wiped from the sides of the
dishwasher door. These are outside
of the wash cabinet and are not
cleaned by water from the spray
arms.
Exterior
Use a conditioner suitable for your
kitchen cabinetry.
Clean wood with a damp cloth and
wipe dry.
Clean the exterior with a solution of
warm water and liquid soap applied
with a soft sponge. Dry with a soft
cloth.
Glass cleaners may be used to
clean the exterior. Howeverdo not
allow them to sit or puddle, this can
cause damage to the surface.
Remove the cleaner promptly.
To better maintain your appliance
avoid the following:
– cleaners containing soda, ammonia,
thinners, or chlorides
– cleaners containing descaling
agents or lime removers,
–
abrasive cleaners,
–
stainless steel cleaners,
–
dishwasher soap (powder),
–
caustic (oven) cleaners,
–
scouring pads, steel wool, hard
brushes,
–
metal scrapers.
Cleaning and Care
46
 
						

							Indicator reflector
The reflector of the optical interface is
located in the steam deflector beneath
the counter top.
Clean as necessary with a damp
cloth.
Control panel
Clean the control panel as necessary
with adamp cloth.
The appliance front and controls
are not scratch proof.
Remove spills immediately.
Cleaning and Care
47
 
						

							Triple filter system
The triple filter system in the base of the
wash cabinet prevents food from being
redeposited on dishes. It also protects
the circulation pump from damage
caused by foreign objects (e.g. broken
glass, bones). During normal use, the
filter system is self-cleaning.
The machine must not be used
without all the filters in place!
Check and clean the filter system
periodically for any trapped or
foreign objects.
The level of soiling and time it takes
before the filters need cleaning will vary
depending on your household usage.
Turn off the dishwasher before
cleaning.Turn the handle counterclockwise to
release the triple filter system.
Lift the filter combination out of the
machine. Remove any solid
particles and rinse under running
water. Scrub with a nylon brush if
necessary.
Cleaning and Care
48
 
						

							To clean the inside of the filter, the flap
must be opened.
Push the clips togetherand open
the flap.
Rinse under running water.
Close the flap so that the clip
engages.Return the filter so it lies flat in the
base of the wash cabinet.
Lock the filter by turning the handle
clockwise.
The triple filter system must be
inserted and locked into place.
Large particles could get in the
circulation system and cause a
blockage.
Cleaning and Care
49
 
						

							Cleaning the spray arms
Sometimes particles of food get stuck
in the spray arm jets. The spray arms
should be inspected and cleaned every
4 - 6 months.
Turn off the dishwasher before
cleaning.
Removing the spray arms
Remove the cutlery tray (if present).
Push theupperspray arm up to
engage the inner ratchet and
unscrew the spray arm.

Lift up themiddlespray arm,,to
engage the ratchet and unscrew the
spray arm,.

Remove the lower basket.Pull thelowerspray arm firmly
upwards to remove.

Use a pointed object such as a
toothpick to push food particles into
the spray arm jets.

Rinse thoroughly under running
water.

Return the spray arms and check that
they rotate freely.
Cleaning and Care
50