Miele G 1222 Sci Operating Instructions

Cleaning the filters in the wash
cabinet
The filter combination in the base of the
wash cabinet retains coarse soil from
the suds solution, preventing it
accessing the circulation system and
re-entering the cabinet through the
spray arms.
,The dishwasher must not be
used without all the filters in place.
Collection of coarse soil may cause the
filters to clog. The level of soiling and
time it takes before the filters need
cleaning will vary depending on use.
Check the condition of the filters
regularly...

To clean the inside of the filter, the flap
must be opened:
^Press together the catches in the
direction of the arrowsaas shown,
and open the filterb.
^Rinse all the filters under running
water.
^Then close the flap so that the catch
engages.^Replace the filter combination so that
it lies flat in the base of the wash
cabinet.
^Then turn the handle clockwise to
lock the filter combination in place.
,Take care when you are fitting
the filter combination that it is
secured in position correctly.
Otherwise...

Cleaning the spray arms
Particles of food can get stuck in the
spray arm jets and bearings. The spray
arms should therefore be inspected
and cleaned regularly (approx. every
4 - 6 months).
^Switch the dishwasher off.
Remove the spray arms as follows:
^Take out the cutlery tray (if your
dishwasher is fitted with one).
^Push thetopspray arm upwards to
engage the inner ratchet. Then
unscrew the spray arm.
^
Push themiddlespray arm upwards
ato engage the ratchet. Then
unscrew the spray armb.^Remove the lower...

With the aid of the following guide, minor problems can be easily corrected
without calling in a Miele service technician, saving you both time and money.
The following guide may help you to find the reason for a fault, and to correct it.
You should, however, note the following:
,Repairs should only be carried out by a suitably qualified and trained
person in accordance with current local and national safety regulations.
Unauthorised or incorrect repairs could cause personal injury or damage the...

Problem Possible cause Remedy
The Wash/Rinse,
Drying and End
indicator lights flash
simultaneously.
Fault code FXX shows
in the display.There may be a
technical fault.–Switch the dishwasher off
with the On/Off buttons.
After a few seconds:
–Switch the dishwasher back
on.
–Select the programme
required with the
programme selector button.
–Press the Start/Stop button.
If the programme sequence
indicator lights flash again,
there is a technical fault.
–Call the Service
Department.
The drain pump works
even...

The dishwasher does not fill/drain
Problem Possible cause Remedy
The Inlet/Drain
check indicator
flashes.The stopcock is
closed.Open the stopcock fully.
The dishwasher
stops during a
programme.
The Inlet/Drain
check indicator
flashes.
Fault code FXX
shows in the display.Before rectifying the problem
you must:
–Switch the dishwasher off with
the On/Off buttons.
Fault F12/F13:
Water inlet restricted.–Open the stopcock fully.
–Clean the water inlet filter (see
Problem solving).
–The water pressure at the...

General problems
Problem Possible cause Remedy
Detergent residue is left
in the dispenser at the
end of a programme.The dispenser was still
damp when detergent was
added.Make sure the dispenser
is dry before adding
detergent.
The detergent lid
cannot be closed
properly.Clogged detergent
residue is blocking the
catch.Clean the detergent from
the catch.
At the end of a
programme there is a
film of moisture on the
inside of the door and
the interior walls.This is caused by the
drying system and does
not...

Noises
Problem Possible cause Remedy
Knocking noise in the
wash cabinet.A spray arm is knocking
against an item in a
basket.Interrupt the programme,
and rearrange the items
which are obstructing the
spray arm.
Rattling noise in the
wash cabinet.Items of crockery are
insecure in the wash
cabinet.Interrupt the programme,
and rearrange the items of
crockery.
Knocking noise in the
water pipes.This may be caused by
the on-site installation or
the cross-section of the
piping.This has no influence on
dishwasher...

Unsatisfactory washing result
Problem Possible cause Remedy
The dishes are not
clean.The dishes were not loaded
correctly.See notes in Loading the
dishwasher
The programme was not
powerful enough.Select a more intensive
programme. See
Programme chart.
There is some stubborn
soiling although most of the
crockery is only lightly soiled
(e.g. with tea stains).Use the Adjust sensor wash
function (see Additional
functions).
Not enough detergent was
dispensed.Use more detergent, or
change your detergent.
Items...

Problem Possible cause Remedy
Dishes, cutlery
and glasses are
not dry or are
flecked.The rinse aid amount may
be insufficient or the rinse
aid reservoir empty.Replenish the reservoir,
increase the dosage or
change the brand of rinse aid.
See Before using for the first
time.
Crockery was taken out of
the cabinet too soon.Leave it in for longer. See
Operation.
You are using 2 in 1 or
3 in 1 tablets, which do
not have a strong enough
drying performance.Set the Tab function (if
present) to Normal, and...