Miele F 123 Ui Operating And Installation Instructions

In normal use, ice and frost will form on
the evaporator plates. If allowed to
accumulate, this will impair the
efficiency of the freezer and increase
the consumption of electricity.
Do not scrape ice and frost off the
evaporator plates as this can
damage them and render the
appliance unusable.
The freezer should be defrosted from
time to time. It must be defrosted if a
layer of ice approx. 0.5 cm thick has
accumulated. It is best to defrost when
only very little food or no food at all is
left in the...

After defrosting
^Take the bottom drawer out of the
appliance and empty it.
^Use a sponge or towel to soak up
any water from defrosting still in the
appliance.
^Clean the appliance, and then dry it
thoroughly.
^Plug the appliance in again, and
switch on using the On/Off button.
The indicator light will come on.
^Switch on the Super freeze function
so that the freezer can cool down
quickly.
The indicator light will come on.
^Once the temperature in the freezer
has reached the required
temperature, place...

Never use cleaning agents
containing abrasive substances
such as sand, soda, acids or
chlorides or chemical solvents.
Non-abrasive cleaning agents are
also unsuitable as they can cause
matt areas to appear.
Make sure that water cannot get into
the electronic unit or into the
ventilation gaps.
Do not use steam cleaning
apparatus to clean the appliance.
Steam could reach the electrical
components and cause a short
circuit.
The data plate located inside the
appliance must not be removed. It
contains...

After cleaning
^Close the door to the appliance.
^Plug the appliance in again, and
switch on using the On/Off button.
The indicator light will come on.
^Switch on the Super freeze function
so that the freezer can cool down
quickly.
The indicator light will come on.
^Once the temperature in the freezer
has reached the required
temperature, place the food back in
the freezer drawers and put them
back in the freezer.
^Switch the Super freeze function off
after 15 minutes.
The indicator light will then go...

Repairs to electrical appliances
should only be carried out by a
suitably qualified and competent
person in strict accordance with
current local and national safety
regulations. Repairs and other work
by unqualified persons could be
dangerous. The manufacturer
cannot be held liable for
unauthorised work.
Ensure that current is not supplied to
the appliance until after
maintenance or repair work has
been carried out.
What to do if...
. . . the appliance does not get cool.
^Make sure that the temperature...

. . . the On/Off button indicator light
is not on.
^Check if the Super freeze indicator
light comes on when you press the
Super freeze button.
If it does, then the indicator light for
the On/Off button is defective.
Call the Service Department.
^If the Super freeze indicator light
does not come on either, then check
whether
- the plug is correctly inserted in the
socket.
- the mains fuse has tripped. If it has
there is a fault. Call the Service
Department.
. . . the Super freeze indicator light
does not...

Normal noises What causes them
Brrrrr...Humming noise made by the motor (compressor). This noise can
get louder for brief periods when the motor is switching on.
Blubb, blubb....A gurgling noise can be heard when coolant is circulating
through the pipes.
Click....Clicking sounds are made when the thermostat switches the
motor on and off.
Sssrrrrr....On multi-zone and frost-free appliances you can sometimes just
hear the movement of air circulating inside the appliance.
Remember that the noise of the...

In the event of a fault which you cannot
correct yourself, or if the appliance is
under guarantee, please contact:
–your Miele Dealer
or
–the Miele Service Department
(see back cover for contact details).
When contacting your Dealer or Miele,
please quote the model and serial
number of your appliance. This
information is given on the data plate
inside your appliance.
Please note that telephone calls may
be monitored and recorded for
training purposes.
N.B. A call-out charge will be applied
for service...

Electrical connection U.K.
All electrical work should be carried out
by a suitably qualified and competent
person in strict accordance with current
local and national safety (BS 7671 in
the UK).
The appliance is supplied with a mains
cable and moulded plug ready for
connection to an a.c. single phase
220-240 V 50 Hz supply.
The voltage and frequency are given on
the data plate. Please ensure that these
match the household mains supply. The
fuse rating is quoted on the plug.
Connection should be made via...

This appliance must be built in,
otherwise it could tip up.
Location
The appliance should be installed in a
dry, well-ventilated room.
The room temperature should not go
above or below the climate range for
which the appliance is designed.
The higher the ambient temperature of
the room, the more energy the
appliance requires to operate.
It should not be installed where it is
exposed to direct sunlight or directly
adjacent to a heat-producing appliance
such as an oven or a radiator.
Important: tropical /...