Midway The Grid Single Header Installation Manual

							The Grid - Header Installation Single Header
12
34
TR SCREW
GROUND LUG
RETAINER
FLUORESCENT
ESN NUT
TR SCREW
TR SCREW
FLANGE
KEPS NUT
STUD
RETAINER
ARTWORK
PLEXIGLAS
TR SCREW
Remove all items from carton. Inspect for damage.
Align Retainer holes with holes at bottom of Header 
Housing. Fasten with tamper resistant screws.
Align Fluorescent Lamp Assembly with studs in rear 
of Header Housing. Fasten with ESN nuts, but leave 
a nut off the bottom left stud.
Connect Extender Cable to main harness and run it 
through holes in top of cabinet and bottom of 
Header Housing. Connect it to Lamp Assembly.
Place ground lug over bottom left stud on Lamp 
Assembly and fasten with ESN nut.
Align Housing with holes atop cabinet and fasten 
with tamper resistant screws.
Bend artwork and Plexiglas to conform to shape of 
Header Housing. Slide artwork and Plexiglas into 
Housing.
Align top Retainer with top panel of Header Housing 
and fasten with tamper resistant screws. Fasten studs on left and right Walls to Header 
Housing with KEPS nuts. Fasten Wall flanges to 
cabinet with tamper resistant screws.
Peel off transparent protective layer on each Wall.
HEADER HOUSING
EXTENDER
RIGHT WALL
UNUSED HOLE LEFT WALL
Before installing any header, all cabinets must be stable and level and in their final location.
Turn off AC power and unplug line cords. Lay out all components before installation to ensure you know what 
each part is. Seek assistance when lifting headers atop cabinets. Observe grounding precautions.
As an alternative to these instructions, you may assemble headers atop cabinets to avoid lifting after assembly.
Single Header Installation
LAMP ASSEMBLYCABLE
OCTOBER 2000
16-11177 
						

							Triple Header Midway Amusement Games, LLC
1
2
3
Triple Header Installation
CENTER BRACE RIGHT PANEL
LEFT PANEL
RETAINER
TR SCREW
ARTWORK RETAINER
EXTENDER TOP PANEL
ESN NUT
TR SCREW
LAMP ASSEMBLY
PLEXIGLAS
ARTWORK RETAINER
GROUND LUG
KEPS NUT
Remove all items from cartons and inspect 
for damage.
Note that you may wish to install this 
directly on top of the cabinets, rather than 
lifting the assembly in step 2.
Otherwise, align Bases on flat surface.
Align Retainer holes with holes in front of 
Bases. Fasten with tamper proof screws 
from beneath.
Align Center Braces on Base posts where 
Bases meet. Align right and left Panels on 
far ends of Bases. Fasten with ESN nuts.
Align Top Panel holes over left and right Pan-
els and Center Braces. Fasten with tamper 
proof screws from above.
Lift assembled header atop aligned cabinets 
with open side facing front.
Align lower retainer to cabinet front.
Attach Bases to cabinet with tamper proof 
screws.
Connect Extender Cables to AC cables 
through holes in front tops of cabinets.
Bend artwork and Plexiglas slightly to conform 
to shape of header. Slide into front of assembly.
Align Retainer holes with Top Panel holes and 
fasten with tamper resistant screws from 
above.
Smooth out artwork from behind.
Hold Fluorescent Lamp Assemblies in position 
above headers to attach Extender Cables to 
Lamp connectors.
Place ground lugs over studs on Lamp Assem-
blies and Base panels. Fasten with KEPS nuts.
Place Fluorescent Lamp Assemblies on Top 
Panels with bulbs inside header assembly. Fas-
ten with tamper proof screws.
BASE
ESN NUT