Home > Lyman > Firearms > Lyman Sizer And Lubricator Instructions Manual

Lyman Sizer And Lubricator Instructions Manual

Add to Favourites
    Download as PDF

    View the Lyman Sizer And Lubricator Instructions Manual for free. All the Lyman manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 #4500 BULLET SIZER & LUBRICATOR Assembly Your new #4500 Bullet Sizer and Lubricator has been fully assembled at the factory, However, to facilitate packaging and shipping, the handle has been dismounted. Installation of the handle is quick and easy - simply align the handle with the link (Figure 21) and turn in the handle until it stops. No other assembly steps are required. NOTE: Lyman’s #4500 is intended only for the sizing and lubrication of bullets cast of lead - tin - antimony alloy and the...
    Page 2 Removing the Sizing Die If you wish to remove the sizing die, unscrew the die retaining nut. Place your flat box wrench (on its edge) under the push rod and on top of the knockout link. Holding the wrench in this position as you pull up on the operating handle will eject the sizing die. Inserting Lubricant Lyman Bullet Lubricant is recommended for use in your new Sizer and Lubricator. The lubricant is supplied specifically moulded to fit the reservoir of the #4500 tool. Figure 23shows how to insert a...
    Page 3 ing grease, lower the threaded push rod adjustment screw shown in Figure 24. Repeat the adjustment, a little at a time, until the driving bands are sized and all the grooves between them are properly filled with lubricant. Care should be used when adjusting depth to insure that the lube does not run over onto the nose of the bullet. When the setting is correct, tighten the adjusting screw lock nut and pro- ceed with your sizing and lubricating. Note:Do not operate in cold weather or until lubricant has...
    Page 4 #4500 LUBRICATOR/SIZER Key Part Description Part # Key Part Description Part # 1Lubricant Reservoir Cover 2990598 2Pressure Nut 2990146 3O-Ring (2) 2990689 4Ram 2745818 5Set Screw 2990622 6Body Casting 2990594 7Retaining Screw for Heater 7990121 8Lubricant Heater 110V* 2745896 8Lubricant Heater 220V* 2745898 9Pressure Screw 2990559 10 Adjusting Screw 2745807 11 Adjusting Screw Locknut 2745808 12 Push Out Rod 2990306 13 Spring Washer (3) 2990202 14 Hex Head Bolt (3) 2990620P15 Gas Check Seater...
    Start reading Lyman Sizer And Lubricator Instructions Manual

    Related Manuals for Lyman Sizer And Lubricator Instructions Manual

    All Lyman manuals