Lucent Technologies MDW 9031/9031DCP Wireless Pocket Phone Quick Reference Manual

							MDW 9031/9031DCP Wireless Pocket Phone Quick Reference
503-801-165
 Quick Reference
Issue 2  February 1999 7
Preselecting a Line or Button
After Line Preselection is enabled, proceed as follows:
1  If the display is blank, press 
.
2  If necessary, press 
    to move the Selection rectangle. 
3  Press      corresponding to the line or button you want.
4  Press 
O to access the line or button.
Accessing Certain Voice Mail Systems 
with a DEFINITY System
Note:This section only applies to the MDW 9031 Pocket Phone.
After dialing into some voice mail systems (for example, Octel 200/250, 
300/350), the MDW 9031 Pocket Phone may not provide touch tones in 
order to access the voice mail system prompts. 
If you experience this problem after dialing into your voice mail system, 
press the 
Feat/Pbutton twice. After pressing the Feat/P button twice, your 
Pocket Phone will generate touch tones and you will be able to navigate 
within your voice mail system. When you end your call to your voice mail 
system, or press any non-dialpad button on your Pocket Phone (that is, Conf, 
Trans, Hold, Redial, Mute), your MDW 9031 will stop generating touch 
tones behind the voice mail system. You will need to re-enter 
Feat/Pwhenever you dial into these voice mail systems or after you have 
pressed a non-dialpad button.
qrtitle.book  Page 7  Friday, December 18, 1998  9:52 AM 
						

							 Quick Reference 
MDW 9031/9031DCP Wireless Pocket Phone Quick Reference
503-801-165 8 Issue 2  February 1999 
Changing Settings or Performing Tests in Local Mode
1  Make sure the handset is turned off.
2  Press and hold 
    for 3 seconds.
3  While still holding 
,   press 
O.
4  Press one of the following:
A (2) to enable or disable the alerter.
L (5) to enable or disable backlighting.
P (7) for 3 seconds, then     to enable or disable
Line Preselection.
V (8) to enable or disable the vibrator.
W (9) to enter Wireless Test Mode, then 1 for signal strength 2 
for voice quality 3 for matching radio module and slot number 5 
for handset power settings # to enter Local Test Mode.
5  Press 
O to exit.
!CAUTION:
The MDW 9031/9031DCP handset is a radio device and, like all radio 
devices, should not be placed next to a pacemaker.  See “Guidelines 
for Safe and Efficient Operation” in the MDW 9031/9031DCP Wireless 
Pocket Phone Installation and Use guide for more information.
qrtitle.book  Page 8  Friday, December 18, 1998  9:52 AM