LG Gw P227 Ytqk Owners Manual

d
 

2
Entry
Important safety instruction
Identification of parts
Where to install
Door removal
Door replacement
Feed water pipe installation
Height adjustment
Starting
Adjusting the temperatures and functions
Refreshment center (Applicable to some models only)
Shelf (Applicable to some models only)
Wine holder (Applicable to some models only)
Egg box 
Humidity control in the vegetable compartment
Convert into a vegetable or meat compartment (Applicable to some models only)
Deodorizer (Applicable to some...

Entry
The model and serial numbers are found on the inner case or back of refrigerator
compartment of this unit. These numbers are unique to this unit and not
available to others. You should record requested information here and retain
this guide as a permanent record of your purchase. Staple your receipt here.
Date of purchase : 
Dealer purchased from :
Dealer address :
Dealer phone no. :
Model no. :
Serial no. :
Before it is used, this refrigerator must be properly installed and located in accordance...

4
Introduction
This appliance contains a small amount of isobutane refrigerant (R600a),
natural gas with high environmental compatibility, but it is also combustible.
When transporting and installing the appliance, care should be taken to ensure
that no parts of the refrigerating circuit are damaged. Refrigerant squirting out
of the pipes could ignite or cause an eye injury. If a leak is detected, avoid any
naked flames or potential sources of ignition and air the room in which the
appliance is standing...

5
Introduction
DANGER: Risk of child entrapment.
Before you throw  away your old refrigerator or freezer :
Take off the doors but leave the shelves in place so that children may not easily climb
inside.
The appliance is not intended for use by young children or infirm persons without
supervision.
Young children should be supervised to ensure that they do not play with the appliance.
Don’t store or use gasoline or other flammable vapor and liquids in the vicinity of this or
any other appliance.
In the...

6
*Dispenser model 
•Parts, features, and options vary by model. Your model may not include every option.
NOTE
Freezer 
CompartmentRefrigerator 
Compartment
Milk product corner
LampShelf
Lamp Automatic
Icemaker
Shelf or Drawer
Shelf or Drawer
Door rack
Drawer (2 or 3)
Door rack
Lower coverShelf
Refreshment center (Optional)
Can Server (Optional)
Egg Box
Vegetable Drawer
(1 or 2) Door Rack
Wine holder (Plastic or wire)
Door Rack
Conversion switch
(Meats/Vegetables)
(Optional)
DrawerSnack drawer...

7
Installation
1. Place your appliance where it is easy to
use.
2. Avoid placing the unit near heat sources,
direct sunlight or moisture.
3. To ensure proper air circulation around the
fridge -freezer, please maintain sufficient
space on both the sides as well as top and
maintain at least 2 inches (5 cm) from the
rear wall.
4. To avoid vibrations, the appliance must
be leveled.
5. Dont install the appliance below 5°C. It may cause affect the performance. Select a good
location
Where to Install
Disposal...

8
Installation
Door removal
Failure to do so could result in death or serious injury.
If your access door is too narrow for the
refrigerator to pass through, remove the
refrigerator door and pass the refrigerator laterally. 
Electric Shock Hazard 
Disconnect electrical supply to refrigerator before installing. 
Remove the lower cover by lifting upward, and
remove clip, and then pull up the feed water tube
while pressing area 
shown in the figure to the
right.
Remove lower
cover and
then feed water
tube...

9
Installation
Door replacement
Feed water pipe installation
(*Dispenser model only)
Pass the refrigerator laterally through the access
door as shown in the right figure.

Automatic ice maker operation needs water pressure of 147~834 kPa (1.5~8.5
kgf/cm2) (That is, an instant paper cup (180 cc) will be fully filled within 3 sec.).

If water pressure does not reach the rating 147 kPa (1.5 kgf/cm2) or below, it is
necessary to purchase a separate pressure pump for normal automatic icing and
cool water...

10
Height adjustment
Level the door by inserting flat (-type) driver into the groove of the left height adjusting
screw and rotate it clockwise ().
Level the door by inserting flat (
-type) driver into the groove of the right height
adjusting screw and rotate it clockwise ().
The refrigerator doors will close smoothly by heightening the front side by adjusting
the height adjusting screw. If the doors do not close correctly, performance may be
affected.
If the freezer
compartment door
is lower than the...