LG Gw B207 Fvqa Owners Manual


Door replacement
Installation
3) Remove the freezer compartment door 
by lifting it upward. The door should be 
lifted high enough for the feed water 
pipe tube to be completely pulled out.
1) Loosen the hinge cover screws and 
remove the cover. Remove  
connection wires, if any, except for 
the earth line.
2) Remove keeper by rotating it  
clockwise (   ) and then remove the 
upper hinge by lifting it up (   ).
3) Remove the refrigerator  
compartment door by lifting it up.
Pass the refrigerator...


Feed water pipe installation (Dispenser model only)
Height adjustment
Installation
/ÏAutomatic ice maker operation needs water pressure of 147~834kPa 
(1.5~8.5kgf/cm2) (The pressure is correct when an instant paper cup (180cc) is 
filled in 3 sec.).
/ÏIf water pressure does not reach the rating 147kPa(1.5kgf/cm
2) or below, it 
is necessary to purchase a separate pressure pump for normal automatic icing 
and cool water feed.
/ÏKeep the total length of the feed water pipe tube within 8m and be...


Installation
The refrigerator doors will close smoothly by adjusting the front side using the 
height adjustment screw. If the doors do not close correctly, performance may be 
affected.
1. Wipe off all dust accumulated during shipping and clean your appliance  
thoroughly.
2. Install accessories such as the ice cube box, cover evaporating tray, etc., in their
proper places. They are packed together to prevent possible damage during ship-
ping.
3. Connect the power supply cord (or plug) to the outlet....

1212
Function display board
Optional
Type-1
Type-2
Type-3
NOTE Your model may not include every option.ay Type - 3: The contrarated by touch. Excvre on the ay panel maction. Pay panel clean and dry.
Starting
A
temperaturc
Operation
When your rrigeratd, allow it tze at normal operating
temperaturrior trrozen ood.
Iranterrupted, wait 5 minutore rrting.
 Type 1ENGLISH
 

13
Display Power Saving Mode
Operation
*Non dispenser model - Type 2
on
Refreshment Centre 
Button
Refreshment Centre 
(Applicable to some 
models only)
Function display board Optional
Type-1
Type-2
NOTE
t Your model may not include every option.
ENGLISH
ENGLISH
ENGLISH
ENGLISH
 

1414
LIGHT/
LIGHT/
Operation
*Dispenser model - Type 1
NOTE Your model may not include every option.ay Type - 3 and Type - 4: The control display is operated by touch. Excessive 
moisture on the display panel may cause a malfunction. Please keep display clean  and dry.
Refreshment Center
Water/Ice output
Dispenser push switch
Function display board
Optional
Type-1
Type-2
Type-3
Type-4
ENGLISH
 


Display Power Saving Mode
Display Power Saving Mode
Display Power Saving Mode
Operation
*Dispenser model - Type 2
NOTE
• Your model may not include every option.
Refreshment Center 
Button
Refreshment Center
(Applicable to some 
models only) Water/Ice output
Dispenser push switch
Dispenser Lamp (hidden)
on
Function display board Optional
Type-1
Type-2
Type-3
ENGLISH
ENGLISH
 


	
 

	
 

Operation
This function save the display power
You can adjust temperature of the fridge and freezer compartments Display panel will automatically turn off in 20 seconds and turn on again when you 
open the door or press the button again. Press the FREEZER and EXPRESS FRZ. buttons simultaneously and hold them for 
5 seconds until the Ding sounds. All LED/LCDs will then turn ON, then OFF. When 
the power saving mode is activated, the display will remain off until the next time 
the door...


Display Power Saving Mode
Operation
*Dispenser model - Type 3
Water/Ice output
Type 1
Type 2
Type 3Dispenser push switch
Dispenser Lamp (hidden)Refreshment Center 
Button
Refreshment Center 
(Applicable to some 
models only)
NOTE
• Your model may not include every option.
• The control display panel is operated by touch. Excessive moisture on the display 
panel may cause a malfunction. Please keep display panel clean and dry.
on
ENGLISH
ENGLISH
 


A
Operation
Display Power Saving Mode
You can adjust temperature of the fridge and freezer compartments
Freezer Compartment temperature adjustment
Refrigerator Compartment temperature adjustment Press the FREEZER and EXPRESS FRZ. buttons simultaneously and hold them for 
5 seconds until the Ding sounds. All LED/LCDs will then turn ON, then OFF. When 
the power saving mode is activated, the display will remain off until the next time 
the door is opened. Then, it will come on whenever a door is...