LG Gr P247 Jylw Owners Manual
Have a look at the manual LG Gr P247 Jylw Owners Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 1069 LG manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
11 Introduction Identification of parts •Parts, features, and options vary by model. Your model may not include every option. NOTE Freezer CompartmentRefrigerator Compartment Milk product corner LED LampAutomatic Icemaker Shelf Shelf Shelf Door rack Drawer(2) Door rack Lower coverShelf Can Server Refreshment center Nano charcoal deodorizer Egg Box LED Lamp Filter (Optional) Door Rack Door Rack Door Rack Fresh compartment Fresh compartment Vacuum fresh compartment Because opening or closing the door or the home bar of the refrigerator may cause injury to the person around it, be careful, please. Opening or closing the door may cause feet or hands to be caught in the chink in door or the child to be get hurt by the corner. Do not put any living animal in the refrigerator.
12 Installation 1. Place your appliance where it is easy to use. 2. Avoid placing the unit near heat sources, direct sunlight or moisture. 3. To ensure proper air circulation around the fridge -freezer, please maintain sufficient space on both the sides as well as top and maintain at least 2 inches (5 cm) from the rear wall. 4. To avoid vibrations, the appliance must be leveled. 5. Dont install the appliance below 5 ∞C. It may cause affect the performance. Select a good location Where to Install Disposal of the old applianceThis appliance contains fluid (refrigerant, lubricant)and is made of parts and materials which are reusable and/or recyclable. All the important materials should be sent to the collection center of waste material and can be reused after rework (recycling). For take back, please contact with the local agency.
13 Installation Door removal Electric Shock Hazard Disconnect electrical supply to refrigerator before installing. Failure to do so could result in death or serious injury. If your access door is too narrow for the refrigerator to pass through, remove the refrigerator door and pass the refrigerator laterally. Remove the lower cover by lifting upward and then pull up the feed water tube while pressing area shown in the figure to the right.Remove lower cover and then feed water tube Remove the freezer compartment door Remove the refrigerator door 1) Removing the hinge cover by loosening the screws. Separate all connection wires except for the earth line after. 2) Remove the keeper by rotating it counter clockwise () and then lifting the upper hinge up (). 3) Remove the freezer compartment door by lifting it upward. This time, the door should be lifted enough for the feed water pipe tube to be completely pulled out. 1) Loosen the hinge cover screws and remove the cover. Remove connection wire, if any, except for the earth line. 2) Remove keeper by rotating it clockwise () and then remove the upper hinge by lifting it up (). 3) Remove the refrigerator compartment door by lifting it up. •If a tube end is deformed or abraded, cut the part away. NOTE •When removing the upper hinge, be careful that the door does not fall forwards . NOTE •Move the refrigerator compartment door passing through the access door and lay it down, but be careful not to damage the feed water pipe tube. NOTE Lower cover Lower hinge Lower hingeKeeper Feed water tube Connection wires Hinge cover Upper hinge Keeper Upper hinge Ground Line Upper hinge Connection wires WARNING
14 Installation Door replacement Feed water pipe installation Pass the refrigerator laterally through the access door as shown in the right figure. Automatic ice maker operation needs water pressure of 147~834 kPa (1.5~8.5 kgf/cm2) (That is, an instant paper cup (180 cc) will be fully filled within 3 sec.). If water pressure does not reach the rating 147 kPa (1.5 kgf/cm2) or below, it is necessary to purchase a separate pressure pump for normal automatic icing and cool water feed. Keep the total length of the feed water pipe tube within 8 m and be careful for the tube not be bent. If the tube is 8 m or longer it may cause trouble in water feed owing to the drain water pressure. Install the feed water pipe tube at a place free from heat. Connect to potable water supply only. Refer to instructions with water filter kit for installation. Mount them in the reverse sequence of removal after they pass through the access door. Pass the refrigerator Before installation 1 2 3 4 5 M a x F R Z T E M PR E F T E M P M i n5 4 3 2 1 M a x WARNING
15 Installation Height adjustment - When the height of the door may not be leveled when the floor is not leveled. When the freezer door is lower – Use the (-) driver or spanner to turn the groove or nut of the height adjustment screw on the left to the counterclockwise direction to level the door. When the fridge door is lower – Use the (-) driver or spanner to turn the groove or nut of the height adjustment screw on the right to the clockwise direction to level the door. The refrigerator doors will close smoothly by heightening the front side by adjusting the height adjusting screw. If the doors do not close correctly, performance may be affected.When the floor is not leveled When the fridge door is lower than the freezer door while using the refrigerator, level the doors. 1. Use the tool for adjustment on the wide side to turn nut ( ) in the clockwise direction to loosen the keeper nut. 2. Use the tool for adjustment on the narrow side to turn the adjustment hinge pin in ( )clockwise direction or ( ) counterclockwise direction to adjust the height of the fridge and freezer doors. 3. After aligning the height of the door, turn the keeper nut in counterclockwise direction tightly. When the fridge door is lower than the freezer door After leveling the door height Keeper nut Adjustment hinge pin Tool for adjustment Up Down Height difference Height difference When using the driverWhen using the spanner Next1. Wipe off all dust accumulated during shipping and clean your appliance thoroughly. 2. Install accessories such as the ice cube box, cover evaporating tray, etc., in their proper places. They are packed together to prevent possible damage during shipping. 3. Connect the power supply cord (or plug) to the outlet. Dont double up with other appliances on the same outlet. Do not force too hard to level the height. The hinge pin can be pulled out. (Adjustable range of height is a maximum of 2 (5 cm))CAUTION
16 Operation Refreshment Center Function display board Display Power Saving Mode •Your model may not include every option. NOTE Starting When your refrigerator is first installed, allow it to stabilize at normal operating temperatures for 2-3 hours prior to filling it with fresh or frozen foods. If operation is interrupted, wait 5 minutes before restarting. Adjusting the temperatures and functions
17 Operation This function save the display power Press the and buttons simultaneously and hold them for 5 seconds until the Ding sounds. All LED/LCDs will then turn ON, then OFF. When the power saving mode is activated, the display will remain off until the next time the door is opened. Then, it will come on whenever a door is opened or a button is pressed and remain on for 20 seconds after the last door opening or button selection. To deactivate the power saving mode, press the and buttons simultaneously and hold them for 5 seconds until the Ding sounds. The actual inner temperature varies depending on the food status, as the indicated setting temperature is a target temperature, not actual temperature within refrigerator. Refrigeration function is weak in the initial time. Please adjust temperature as above after using refrigerator for minimum 2~3 days. Freezer Compartmenttemperature adjustment Setting temperature Setting temperature Refrigerator Compartmenttemperature adjustment You can adjust temperature of and freezer room and refrigerator room. Freezer control Display power saving Refrigerator control HfromHFridgeBManualEcomHManuals
18 Operation The automatic icemaker can automatically make 6 cubes at a time, 25~35 pieces per day. This quantity may vary by circumstance, including ambient temperature, door opening, freezer load. etc. Icemaking stops when the ice storage bin is full. If you dont want to use the automatic icemaker, turn the icemaker switch to OFF.If you want to use automatic icemaker again, change the switch to ON. Automatic icemaker •It is normal that a noise is produced when ice drops into the ice storage bin. NOTE •Do not insert your hands in to the Icemaker in operation. It may cause to injure you. Power Switch Feeler Arm •Reference : Hold your cup in place for a couple of seconds after dispensing ice or water so the last few drops go in to your cup instead of the floor. Dispenser useSelect among crushed ice, water, and cubed ice and press the push switch with a glass or other container. After dispenser is usedThe water collector has no self-drainage function, so it should be cleaned regularly. Remove the cover by pulling the front of the water collector cover and dry it with a cloth. Water Light the water lamp by pressing the selection button. Crushed Ice Light the crushed ice lamp by pressing the selection button.Cubed Ice Light the cubed ice lamp by pressing the selection button. WARNING
19 Operation Ice is lumped together When ice is lumped together, take the ice lumps out of the ice storage bin, break them into small pieces, and then place them into the ice storage bin again. When the ice maker produces too small or lumped together ice, the amount of water supplied to the ice maker need to adjusted. Contact the service center. ❈If ice is not used frequently, it may lump together. Power failure Ice may drop into the freezer compartment. Take the ice storage bin out and discard all the ice then dry it and place it back. After the machine is powered again, crushed ice will be automatically selected. The unit is newly installed It takes about 12 hours for a newly installed refrigerator to make ice in the freezer compartment. When ice maker does not operate smoothly Please select this function for prompt freezer. OFF➝ON➝OFF is repeated whenever pressing button. The arrow mark graphic remains at the On status after flickering 4 times when selecting Special Refrigeration On. Prompt freezer function automatically turns off after a fixed time passes. Express freezer 11 On Off Hold the ice maker cover with both hands and pull it toward you while pressing the button on part (1).How to disassemble the automatic icemaker - Do not disassemble the ice maker unless it is necessary. - Hold the ice storage bin using both hands so that it does not fall. - Do not touch the ice dispenser with your hand or tool. - Because the ice maker can operate by opening the freezer door, please take precaution. - When you want to use the ice bucket space as the storage space, make sure to use it by turning off the ice maker after removing the ice bucket. WARNING
Operation 20 This button stops operation of different button. Locking or Release is repeated whenever the is pressed more than 3 seconds. If you use the button, none of the other buttons will work until you unlock them. Lock LOCKUNLOCK There is a replacement indicator light for the water filter cartridge on the dispenser. The water filter should be replaced every six months. The filter light comes on to let you know when to replace filter. After replacing the filter, press and hold the filter button more than 3 seconds to reset the indicator. Filter condition (filter replacement cycle) display function Dispenser light This button turn the dispenser light in the dispenser on an off. The dispenser light function is turned ON or OFF by pressing button. On Off The other functionsDoor open warning 3 times of warning sounds at the interval of 30 seconds if a minute passes with the door of refrigerator and the hombar door opened or completely closed. Please contact with the local service center if warning continue to sound even after closing the door. Diagnosis (failure detection) function Diagnosis function automatically detects failure when failure is found in product during the use of refrigerator. If failure occurs at product, it does not operate though pressing any button and normal indication is not done. In this case, do not turn power off but immediately contact with the local service center. A lot of time are need for service engineer to detect the failed part if turning it off.