LG Gr P247 Jhle Owners Manual

11
Introduction
Identification of parts
•Parts, features, and options vary by model. Your model may not include every option.
NOTE
Freezer 
CompartmentRefrigerator 
Compartment
Milk product corner
LED LampAutomatic
Icemaker
Shelf
Shelf
Shelf
Door rack
Drawer(2)
Door rack
Lower coverShelf
Can Server
Refreshment center
Nano charcoal deodorizer
Egg Box LED Lamp Filter (Optional)
Door Rack Door Rack Door Rack
Fresh compartment Fresh compartment 
Vacuum fresh
compartment
Because opening or closing the door or...

12
Installation
1. Place your appliance where it is easy to
use.
2. Avoid placing the unit near heat sources,
direct sunlight or moisture.
3. To ensure proper air circulation around the
fridge -freezer, please maintain sufficient
space on both the sides as well as top and
maintain at least 2 inches (5 cm) from the
rear wall.
4. To avoid vibrations, the appliance must
be leveled.
5. Dont install the appliance below 5
∞C. It may cause affect the performance. 
Select a good
location
Where to Install...

13
Installation
Door removal
Electric Shock Hazard 
Disconnect electrical supply to refrigerator before
installing. Failure to do so could result in death or
serious injury.
If your access door is too narrow for the
refrigerator to pass through, remove the refrigerator door and pass the
refrigerator laterally. 
Remove the lower cover by lifting upward and then pull up the feed water tube
while pressing area shown in the figure to the right.Remove lower
cover and
then feed water
tube
Remove the
freezer...

14
Installation
Door replacement
Feed water pipe installation
Pass the refrigerator laterally through the access
door as shown in the right figure.
Automatic ice maker operation needs water pressure of 147~834 kPa
(1.5~8.5 kgf/cm2) (That is, an instant paper cup (180 cc) will be fully filled 
within 3 sec.).
If water pressure does not reach the rating 147 kPa (1.5 kgf/cm2) or below, it is
necessary to purchase a separate pressure pump for normal automatic icing and cool
water feed.
Keep the total...

15
Installation
Height adjustment
- When the height of the door may not be
leveled when the floor is not leveled. 
When the freezer door is lower –
Use the (-) driver or spanner to turn the
groove or nut of the height adjustment
screw on the left to the counterclockwise
direction to level the door. 
When the fridge door is lower –
Use the (-) driver or spanner to turn the
groove or nut of the height adjustment
screw on the right to the clockwise
direction to level the door. 
The refrigerator doors...

16
Operation
Refreshment Center
Function display board
Display Power Saving Mode 
•Your model may not include every option.
NOTE
Starting
When your refrigerator is first installed, allow it to stabilize at normal operating
temperatures for 2-3 hours prior to filling it with fresh or frozen foods. 
If operation is interrupted, wait 5 minutes before restarting.
Adjusting the temperatures and functions
  

17
Operation
This function save the display power 
Press the             and               buttons simultaneously and hold them for 5
seconds until the Ding sounds. All LED/LCDs will then turn ON, then OFF.
When the power saving mode is activated, the display will remain off until the
next time the door is opened. Then, it will come on whenever a door is opened
or a button is pressed and remain on for 20 seconds after the last door opening
or button selection. To deactivate the power saving mode, press...

18
Operation
The automatic icemaker can automatically make 6 cubes at a time, 25~35
pieces per day. This quantity may vary by circumstance, including ambient
temperature, door opening, freezer load. etc.
Icemaking stops when the ice storage bin is full.
If you dont want to use the automatic icemaker, turn the icemaker switch to
OFF.If you want to use automatic icemaker again, change the switch to ON.
Automatic 
icemaker
•It is normal that a noise is produced when ice drops into the ice storage bin....

19
Operation
Ice is lumped together
When ice is lumped together, take the ice lumps out of the ice storage bin,
break them into small pieces, and then place them into the ice storage bin
again. 
When the ice maker produces too small or lumped together ice, the amount
of water supplied to the ice maker need to adjusted. Contact the service
center.
❈If ice is not used frequently, it may lump together.
Power failure
Ice may drop into the freezer compartment. Take the ice storage bin out and
discard all...

Operation
20
This button stops operation of different button.
 Locking or Release is repeated
whenever the               is pressed more
than 3 seconds.
 If you use the               button, none of
the other buttons will work until you
unlock them.
Lock
LOCKUNLOCK
 There is a replacement indicator light
for the water filter cartridge on the
dispenser.
 The water filter should be replaced
every six months.
 The filter light comes on to let you
know when to replace filter.
 After replacing the...