LG Gr P227 Zdaw Owners Manual
Have a look at the manual LG Gr P227 Zdaw Owners Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 1069 LG manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
2 Entry Important safety instruction Identification of parts Where to install Door removal Door replacement Feed water pipe installation Height adjustment Starting Adjusting the temperatures and functions Refreshment center (Applicable to some models only) Shelf (Applicable to some models only) Wine holder (Applicable to some models only) Egg box (Applicable to some models only) Humidity control in the vegetable compartment Convert into a vegetable or meat compartment (Applicable to some models only) Deodorizer (Applicable to some models only) Miracle Zone Temperature Transition Corner (Applicable to some models only) Temperature Change at Miracle Zone (Applicable to some models only) Miracle Zone (Applicable to some models only) Location of foods Storing foods How to dismantle parts General information Cleaning Trouble shooting When replacing PANEL……. Table of contents Introduction Installation Operation Suggestion on food storage Care and maintenance3 3 4 5 6 7 7 8 9 14 15 15 15 16 16 16 17 17 17 18 19 20 22 22 23 28 9 The working life of this set is 7 years since the date of delivery to consumer. RfromRFridgeNManual…comRManuals
Entry The model and serial numbers are found on the inner case or back of refrigerator compartment of this unit. These numbers are unique to this unit and not available to others. You should record requested information here and retain this guide as a permanent record of your purchase. Staple your receipt here. Date of purchase : Dealer purchased from : Dealer address : Dealer phone no. : Model no. : Serial no. : Before it is used, this refrigerator must be properly installed and located in accordance with the installation instructions in this document. Never unplug your refrigerator by pulling on the power cord. Always grip plug firmly and pull it straight out from the outlet. When moving your appliance away from the wall, be careful not to roll over the power cord or to damage it in any way. After your refrigerator is in operation, do not touch the cold surfaces in the freezer compartment , particularly when your hands are damp or wet. Skin could adhere to these extremely cold surfaces. Unplug the power cord from the power outlet for cleaning or other requirements. Never touch it with wet hands because you can get an electric shock or be hurt. Never damage, process, severely bend, pull out, or twist the power cord because damage the power cord may cause a fire or electric shock. You have doubts on whether the appliance is properly grounded. Never place glass products in the freezer because they may be broken due to expansion when their contents are frozen. Never allow your hands within the ice storage bin of the automatic ice maker. You could be hurt by the operation of the automatic ice maker. The appliance is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with the appliance. Never allow anyone to climb, sit, stand or hang on the refreshment center door. These actions may damage the refrigerator and even tip it over, causing severe personal injury. If possible, connect the refrigerator to its own individual electrical outlet to prevent it and other appliances or household lights from causing an overload that could cause a power outage. The refrigerator-freezer should be so positioned that the supply plug is accessible for quick disconnection when accident happens. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. Do not modify or extend the Power Cord length. It will cause electric shock or fire. Introduction 3 Important safety instruction Don’t use an extension cord Accessibility of Supply Plug Supply Cord Replacement Warning
4 Introduction DANGER: Risk of child entrapment. Before you throw away your old refrigerator or freezer : Take off the doors but leave the shelves in place so that children may not easily climb inside. The appliance is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with the appliance. Don’t store or use gasoline or other flammable vapor and liquids in the vicinity of this or any other appliance. In the event of an electric short circuit, grounding (earthing) reduces the risk of electric shock by providing an escape wire for the electric current. In order to prevent possible electric shock, this appliance must be grounded improper use of the grounding plug can result in an electric shock. Consult a qualified electrician or service person if the grounding instructions are not completely understood, or if you have doubts on whether the appliance is properly grounded. Identification of parts •Parts, features, and options vary by model. Your model may not include every option. NOTE Child entrapment warning Don’t store warning Grounding (Earthing) warning Freezer CompartmentRefrigerator Compartment Milk product corner Lamp Shelf Nano-Carbon (Optional) Lamp Automatic Icemaker Shelf Shelf Door rack Drawer (2 or 3) Door rack Lower coverShelf Refreshment center (Optional) Can Server (Optional) Egg Box Vegetable Drawer (1 or 2) Door Rack Wine holder (Plastic or wire) Door Rack Conversion switch (Meats/Vegetables) (Optional) Snack drawer (Optional) Shelf (Folding or Normal) Miracle Zone (Optional) Fresh compartment (Optional) Humidity switch
1. Place your appliance where it is easy to use. 2. Avoid placing the unit near heat sources, direct sunlight or moisture. 3. To ensure proper air circulation around the fridge -freezer, please maintain sufficient space on both the sides as well as top and maintain at least 2 inches (5 cm) from the rear wall. 4. To avoid vibrations, the appliance must be leveled. 5. Dont install the appliance below 5°C. It may cause affect the performance. 5 Select a good location Where to Install Disposal of the old applianceThis appliance contains fluid (refrigerant, lubricant)and is made of parts and materials which are reusable and/or recyclable. All the important materials should be sent to the collection center of waste material and can be reused after rework (recycling). For take back, please contact with the local agency. Installation
6 Installation Door removal Failure to do so could result in death or serious injury. If your access door is too narrow for the refrigerator to pass through, remove the refrigerator door and pass the refrigerator laterally. Electric Shock Hazard Disconnect electrical supply to refrigerator before installing. Remove the lower cover by lifting upward, and remove clip, and then pull up the feed water tube while pressing area shown in the figure to the right. Remove lower cover and then feed water tube Warning Remove the freezer compartment door Remove the refrigerator door 1) Removing the hinge cover by loosening the screws. Separate all connection wires except for theearth line after. 2) Remove the keeper by rotating it counter clockwise ( ) and then lifting the upper hinge up ( ). 3) Remove the freezer compartment door by lifting it upward. This time, the door should be lifted enough for the feed water pipe tube to be completely pulled out. 1) Loosen the hinge cover screws and remove the cover. Remove connection wire, if any, except for the earth line. 2) Remove keeper by rotating it clockwise ( ) and then remove the upper hinge by lifting it up ( ). 3) Remove the refrigerator compartment door by lifting it up. •If a tube end is deformed or abraded, cut the part away. NOTE •When removing the upper hinge, be careful that the door does not fall forwards . NOTE •Move the refrigerator compartment door passing through the access door and lay it down, but be careful not to damage the feed water pipe tube. NOTE Lower cover Lower hinge Lower hingeKeeper Feed water tube Connection wires Hinge cover Upper hinge Keeper Upper hinge Earth line Upper hinge Connection wires
7 Installation Door replacement Feed water pipe installation Pass the refrigerator laterally through the access door as shown in the right figure. Automatic ice maker operation needs water pressure of 147~834 kPa (1.5~8.5 kgf/cm2) (That is, an instant paper cup (180 cc) will be fully filled within 3 sec.). If water pressure does not reach the rating 147 kPa (1.5 kgf/cm2) or below, it is necessary to purchase a separate pressure pump for normal automatic icing and cool water feed. Keep the total length of the feed water pipe tube within 8 m and be careful for the tube not be bent. If the tube is 8 m or longer it may cause trouble in water feed owing to the drain water pressure. Install the feed water pipe tube at a place free from heat. Connect to potable water supply only. Refer to instructions with water filter kit for installation. Mount them in the reverse sequence of removal after they pass through the access door. Pass the refrigerator Before installation Warning 1 2 3 4 5 Ma x FR Z TEM PR EF TEM P Min 5 4 3 2 1 Max
8 Installation Height adjustment Level the door by inserting flat (-type) driver into the groove of the left height adjusting screw and rotate it clockwise (). Level the door by inserting flat ( -type) driver into the groove of the right height adjusting screw and rotate it clockwise (). The refrigerator doors will close smoothly by heightening the front side by adjusting the height adjusting screw. If the doors do not close correctly, performance may be affected. If the freezer compartment door is lower than the refrigerator compartment door If the freezer compartment door is higher than the refrigerator compartment door After leveling the door height Next1. Wipe off all dust accumulated during shipping and clean your appliance thoroughly. 2. Install accessories such as the ice cube box, cover evaporating tray, etc., in their proper places. They are packed together to prevent possible damage during shipping. 3. Connect the power supply cord (or plug) to the outlet. Dont double up with other appliances on the same outlet.
9 (hidden)Refreshment Center Function display board Display Power Saving Mode Refreshment Center Button Operation •Your model may not include every option. NOTE Starting When your refrigerator is first installed, allow it to stabilize at normal operating temperatures for 2-3 hours prior to filling it with fresh or frozen foods. If operation is interrupted, wait 5 minutes before restarting. Adjusting the temperatures and functions