LG Gr P227 Zcat Owners Manual

20
Care and maintenance
How to dismantle parts
•Dismantling is done in the reverse sequence of assembly.
Be sure to unplug the power plug before dismantling and assembly.
Never apply severe force to dismantle parts. Parts may be damaged.
NOTE
•Not all bulbs will fit your refrigerator. 
Be sure to replace the bulb will one of the same size, shape and wattage.
•The dispenser lights are LEDs that can not be changed.
NOTE
Freezer
compartment
lamp
Freezer
compartment
shelf
Door rack and
support
Ice storage...

21
Care and maintenance
Insert the tool into the marked area () and push 
the tool to disconnect.
Use the tool with the flat tip such as (-) screw driver.
Turn the bulb counterclockwise. Max. 40 W bulb for
refrigerator is used and can be purchased at a
service center.Lamp in
refrigerator
compartment
Separate the bin () to upward.
Separate the upper rack of the refreshment
center and then pull out the refreshment
center cover 
().
The refreshment center can be removed
by pulling it upwards....

0 0 Suggestion on food storage
22
Care and maintenance
General information
Cleaning
During average length vacations, you will probably find it best to leave the refrigerator
in operation. Place freezable items in freezer for longer life.
When you plan not to operate, remove all food, disconnect the power cord, clean the
interior thoroughly, and leave each door OPEN to prevent odor formation.Vacation time
Power failure
If you move
Anti
condensation
pipe
Most power failures that are corrected in an hour or...

23
Care and maintenance
Trouble shooting
Before calling for service, review this list. It may save you both time and expense.
This list includes common occurrences that are not the result of defective
workmanship or materials in this appliance.
Possible cause
Refrigerator control is off.
Refrigerator is in defrost cycle.
Plug at wall outlet is disconnected.
Power outage. Check house lights.
Refrigerator is larger than the previous
one you owned.
Room or outside weather is hot.
Refrigerator has recently...

24
Care and maintenance
Refrigerator
compressor
does not run.
Occurrence
Temperatures are
too cold
Temperature in the
freezer is too cold
but the refrigerator
temperature is
satisfactory.
Temperature in the
refrigerator
is  too warm but
the freezer
temperature is
satisfactory.
Temperatures in
the refrigerator
or freezer are
too warm.
Temperatures
are too warm
Meat stored in
fresh meat
drawer freezes.Food stored in
drawers freezes.
Possible cause
Thermostat is keeping the  refrigerator
at a constant...

Care and maintenance
25
Sound and noise
Occurrence
Louder sound
levels when
refrigerator is on.
Louder sound
levels when
compressor 
comes on.
Moisture collects
on the inside walls
of the refrigerator.
Water/Moisture
/Ice outside 
refrigerator
Moisture forms
on the outside of
the refrigerator
or between doors.
Vibrating or
rattling noise.
Water/Moisture
/Ice inside
refrigerator
Possible cause
Today’s refrigerators have increased
storage capacity and maintain more
even temperatures.
Refrigerator is...

26
Care and maintenance
Odors in refrigerator
Occurrence
Door(s) will not
close.
Door(s) will not
close.
Drawers are
difficult to move.
Dispenser
Dispenser will not
dispense ice
Opening/Closing of
doors/Drawers
Possible cause
Food is touching shelf on top of the
drawer
Track that drawer slides on is dirty.
Ice storage bin is empty.
Freezer temperature is set too warm.
Household water line valve is not open.
Refrigerator or freezer door is not 
closed.
Refrigerator is not level. It rocks on the
floor when...

Care and maintenance
27
Dispenser will
not dispense
ice.
Ice dispenser
is jammed.
Occurrence
Water has an
odd taste
and/or odor. Dispenser will
not dispense
water.
Possible cause
Water has been in the tank for too long.
Unit not properly connected to cold
water line. 
This sound is normally made when automatically made ice is dropped into ice storage
bin. Volume may vary according to refrigerator’s location.
This sound is normally made when ice maker is supplied with water after dropping
the...

28
When replacing PANEL…….
1. Avoid damaging the Panel. If damaged, it may cause personal injury.
2. When using glass as a material for panel, tempered glass must be used. Ordinary
glass may cause personal injury if broken.
3. The total weight of the Panels (a, b, c) to be replaced should not weigh more than
15kg. If it overweight, the hinge strength may be decreased, resulting in door
Sagging etc.
4. The thickness of the Panel in the
Trim assembly is 3.2~3.5 mm.
5. Size of Panel (Width x Height)
Panel...

29
When replacing PANEL…….
1. Avoid damaging the Panel. If damaged, it may cause personal injury.
2. When using glass as a material for panel, tempered glass must be used. Ordinary
glass may cause personal injury if broken.
3. The total weight of the Panels (a, b, c, d) to be replaced should not weigh more
than 15kg. If it overweight, the hinge strength may be decreased, resulting in door
Sagging etc.
4. The thickness of the Panel in the
Trim assembly is 3.2~3.5 mm.
5. Size of Panel (Width x Height)...