LG Gr B459 Blca Owners Manual

							Introduction
12
w w 
 Warning
• This fridge-freezer must be properly installed and
located in accordance with the Installation
Instruction before it is used.
• Never unplug your fridge-freezer by pulling on the
power cord.Always grip plug firmly and pull straight
out from the outlet.
• When moving your appliance away from the wall, be
careful not to roll over or damage the power cord.
• After your fridge-freezer is in operation, do not
touch the cold surfaces in the freezer compartment,
particularly when hands are damp or wet.Skin may
adhere to these extremely cold surfaces.
Important Safety Instruction
Precaution
 
						

							Introduction
13
The supply plug of the refrigerator-freezer should be
placed in easy accessible position for quick disconnection
in emergency.
If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified
person in order to avoid a hazard.
Dont store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
In the event of an electric short circuit, grounding
(earthing) reduces the risk of electric shock by providing
an escape wire for the electric current. In order to prevent
possible electric shock, this appliance must be grounded.
Improper use of the grounding plug can result in an
electric shock. Consult a qualified electrician or service
person if the grounding instructions are not completely
understood, or if you have doubts on whether the
appliance is properly grounded.
Important Safety Instruction
Accessibility of
Supply Plug
Supply Cord
Replacement
Danger
Dont store
Grounding
(Earthing)
Risk of child entrapment. 
Before you throw away your old refrigerator or freezer:
Take off the doors. 
Leave the shelves in place so that children may not easily
climb inside.
 
						

							Introduction
14
This appliance contains a small amount of isobutane
refrigerant (R600a), natural gas with high
environmental compatibility, but it is also
combustible. When transporting and installing the
appliance, care should be taken to ensure that no
parts of the refrigerating circuit are damaged.
Refrigerant squirting out of the pipes could ignite or
cause an eye injury. If a leak is detected, avoid any
naked flames or potential sources of ignition and air
the room in which the appliance is standing for
several minutes.
In order to avoid the creation of a flammable gas air
mixture if a leak in the refrigerating circuit occurs, the size
of the room in which the appliance may be sited depends
on the amount of refrigerant used. The room must be
1m
2in size for every 8g of R600a refrigerant inside the
appliance. The amount of refrigerant in your particular
appliance is shown on the identification plate inside the
appliance.
Never start up an appliance showing any signs of
damage. If in doubt, consult your dealer.
Important Safety Instruction
w w 
 Warningw w
Keep ventilation openings, in the appliance enclosure
or in the built-in structure, clear of obstruction.
w w
Do not use mechanical devices or other means to
accelerate the defrosting process, other than those
recommended by the manufacturer.
w w
Do not damage the refrigerant circuit.
w w
Do not use electrical appliances inside the food
storage compartments of the appliance, unless they
are of the type recommended by the manufacturer.
w w
The refrigerant and insulation blowing gas used in the
appliance require special disposal procedures. When
disposal, please consult with service agent or a
similarly qualified person.
 
						

							Introduction
15
• If the wall socket is loose, do not insert the power
plug.
It may cause electric shock or fire.
• Never unplug your refrigerator by pulling on the
power cord. Always grip plug firmly and pull it
straight out from the outlet.
You may disconnect a wire and cause a short circuit.
• Do not use a wet or damp cloth when cleaning the
plug. Remove any foreign matter from the power
plug pins.
Otherwise, there is a risk of fire.
• After unplugging the appliance, wait for at least
five minutes before plugging it again to the wall
socket.
Abnormal operation of the freezer may cause material
damage.
• If the appliance is not to be used for a long time,
pull out the power plug.
Any deterioration in the insulation may cause fire.
• Do not let children touch or play with the control
panel on the front of the appliance.
• The refrigerant used in fridge/freezer and the
gases in the insulation material require special
disposal procedures. Ensure that none of the pipes
on the back of the appliances are damaged prior
to disposal.
Important Safety Instruction
w w 
 Caution
 
						

							Introduction
16
Identification of Parts
If you find some parts missing from your unit, they
may be parts only used in other models.Note
Removable
Glass Shelf
Multi-air Flow Duct
Vegetable Drawer
(Optional)
Used to keep fruits
and vegetables, etc.
fresh and crisp.
Ice Tray
Freezer
Compartment
Leveling Screw
Display
Utility Corner 
Handle
Reversible HINGE-LOWER
(Ice Homebar Model)
Basket Door Egg Tray
Water Tank 
(Optional)
2   Bottle
Basket Door 
 
						

							Installation
17
1. Select a good location.
Place your fridge-freezer where it is easy to use.
2. Avoid placing the unit near heat sources, 
direct sunlight or moisture.
3. To ensure proper air circulation around the fridge -
freezer, please maintain sufficient space on both the
sides as well as top and maintain at least 2 inches (5
cm) from the rear wall. 
4. To avoid vibration, the unit must be leveled.
If required, adjust the leveling screws to compensate
for the uneven floor.
The front should be slightly higher than the rear to aid
in door closing. 
Leveling screws can be turned easily by tipping the
cabinet slightly.
Turn the leveling screws counterclockwise(        ) to
raise the unit, clockwise(        ) to lower it.
5. Clean your fridge-freezer thoroughly and wipe off all
dust accumulated during shipping.
6. Install accessories such as ice cube box, etc., in their
proper places. They are packed together to prevent
possible damage during shipment.
7. Connect the power supply cord (or plug) to the outlet.
Dont double up with other appliances on the same
outlet.
When your fridge-freezer is installed, allow it 2-3 hours to
stabilize at normal operating temperature prior to filling 
it with fresh or frozen foods.
If power plug is disconnected, allow 5 minutes delay
before restarting.
Your fridge-freezer is now ready for use.
Installation
Starting
 
						

							Operation
18
• Your Refrigerator-freezer has controls that let you
regulate the temperature in the Refrigerator and freezer
compartments. These controls are on the top of the
Refrigerator-freezer.
• The initial Temperature of the Freezer and Refrigerator
Compartment is -20°C and 3°C respectively. 
You can now adjust the temperature of the
compartments as you want.
Temperature Control
Refrigerator
Freezer
 
						

							Operation
19
• This function makes the fridge-freezer work
in a power saving mode which is useful
when you are away on holiday, by reducing
energy consumption as much as possible. 
Pressing ‘VACATION’ starts operation with
lamp ON and pressing it again stops the
operation.
• This function is used when you want to
freeze the foods quickly. Press the EXPRESS
FRZ. (Express Freezer) button once, and then
the quick freeze operation starts with the
lamp it.
• The EXPRESS FRZ. operation takes about 3 hours. When
its operation ends, it automatically returns to the
normal state. If you want to stop the quick freeze
operation, press the EXPRESS FRZ. button once more,
the lamp goes out, and the EXPRESS FRZ. operation
stops and the refrigerator returns to the normal state.Vacation
Express Frz.
 
						

							Operation
20
This function allows you to check for operational
problems. If you think you have a problem with your
fridge-freezer, then press the temperature control button:
- If the indicate lights move up or down, then there is no
problem with your fridge-freezer.
- If the indicate lights do not move up or down, then
please leave the power connected and call your nearest
service agent.
When the door of the fridge is left opened for a while,
the alarm sounds.
• To make ice cubes, fill the ice
tray to the water level and
place it in the freezer.
• If ice cubes are required fast,
press the EXPRESS FRZ.
button.
• To remove ice cubes, 
hold the tray at its ends and
twist gently.
Defrosting takes place automatically.
The defrosting water flows down to the evaporating tray
and is evaporated automatically. Self Test
Ice Making Door Alarm
Defrosting
To remove ice cubes easily, run water on the tray before
twisting.Tip
 
						

							Operation
21
• Please assemble the VALVE ASSEMBLY after correctly
adjusting it with a DOOR HOLE.
Water Dispenser (Optional)
Features
Install
HANDLE TANK
COVER BUCKET CAP TANK
WATER TANK
DÉCOR PANEL
VALVE ASSEMBLY 
DISPENSER PAD
GRILLE