LG Gr B359 Blqa Owners Manual

							
Care and Maintenance
Power Failure
General Information
•1~2 hour power failure does no harm to the foods
stores. Try to avoid opening and closing the door too
frequently.
Lamp Replacement
1.Unplug the power cord from the
outlet.
2.Remove fridge shelves.
3.To remove the lamp cover, insert 
type driver in the underside of
the lamp cover and pull it out
forwards.
4.Turn the lamp counterclockwise.
5.Assemble in reverse order of
disassembly.
Replacement lamp must be the same specification as
original.
• You must check the O-RING, which is made by rubber and prevent electric spark.
If You Move
Anti
Condensation
Pipe
•Take out foods from the fridge-freezer and firmly fix
the loose items with tape.
•Turn the leveling screws until they stop before moving
the fridge-freezer. Otherwise the screw may scratch
the floor or the fridge-freezer cannot move.
•The Anti-Condensation
pipe is installed around the
front side of fridge-freezer
as well as on the partition
between fridge
compartment and freezer
compartment to prevent
dewing.
•Especially after installation
or when ambient
temperature is high, the fridge-freezer may feel hot,
which is quite normal.
Anti-Condensation
Pipe
23
 from  Manual• 
						

							
Care and  Maintena nce
Before Cleaning
Cleaning
Be sure to unplug the power.
InteriorAs above.
After CleaningCheck that the power cord is not damaged, power plug
has not overheated, and that the power plug is tightly
inserted into the outlet.
Be sure to dry the appliance with a cloth after washing
it with water.
Do not use abrasive, petroleum, benzene, thinner,
hydrochloride acid, boiling water, rough brush, etc, as
they may damage parts of the fridge-freezer.
ExteriorClean the outside of the fridge-freezer with a soft cloth
soaked with hot water or liquid detergent. If you use a
detergent, be sure to wipe it with a clean wet cloth.
24
 
						

							
Trouble Shooting
Trouble Shooting
Problem
Fridge-Freezer
does not operate
Before calling for service, check this list.
It may save you both time and expense.
This list includes common occurrences that are not
the result of defective workmanship or materials in
this appliance.
Possible Causes
• Power plug may be unplugged from the electric
outlet.
Plug it in securely.
• House fuse has blown or circuit breaker has tripped.
Check and/or replace fuse and reset circuit breaker.
• Power cut. Check house lights.
Fridge or Freezer
Compartment
Temperature too
warm
• Temperature control not set on proper position. Refer to Temperature Control section.
• Appliance is placed close to heat source.
• Warm weather-frequent door openings.
• Door left open for a long time.
• Package holding door open or blocking air duct in freezer compartment.
Vibration or
Rattling or
Abnormal Noise
• The floor on which the fridge-freezer is installedmay be uneven or the fridge-freezer may be
unstable.
Make it even by rotating the leveling screw.
• Unnecessary objects placed in the back side of the fridge-freezer.
Frost or Ice
Crystals on frozen
Food
• Door may have been left ajar or package holdingdoor open.
• Too frequent or too long door openings.
• Frost within package is normal.
Moisture forms on
Cabinet Surface
• This phenomenon is likely to occur in a wet space. Wipe it with a dry towel.
25
 from  Manual• 
						

							
Trouble Shooting
ProblemPossible Causes
Moisture collects
inside
• Too frequent or too long door openings.
•In humid weather, air carries moisture into fridge when
doors are opened.
Fridge has odor•Foods with strong odors should be tightly covered or
wrapped.
•Check for spoiled food.
•Interior needs cleaning.
Refer to CLEANING section
Door not closing
properly
• Food package is keeping door open.
Move packages that keep door from closing.
• Fridge-freezer is not level. Adjust the leveling screws.
• The floor on which the fridge-freezer is installed may be uneven or the fridge-freezer may be
unstable.
Slightly raise the front side with the leveling screw.
Interior light does
not work
• No power at outlet.
• Light lamp needs replacing.Refer to the Lamp Replacement section
1. When this crossed-out wheeled bin symbol  is attached to a
    pro
duc t it means the product is covere d by the European
    Directive 200
2/9 6/EC.
2. All electrical and electronic products should be disposed
 of
    separately from the municipal waste stream via designa
ted
    collection facilities appointed by the government or the lo
cal
    author
iti es.
3. The correct disposal of your old appliance will help prevent
 
    potential negative consequences for the environment and 
    human health.   
4. For more detailed information about disposal of your old 
    appliance, please contact your city office, waste disposal 
    service or the shop where you purchased the product.  
    
Disposal of your old appl iance
26
 from  Manual• 
						

							
To Reverse the Doors
Precaution
1.
2.
3.
4.
How to Reverse the Door
1.To separate the door handle    of the left side, sep arate the
door cap    and unscrew the screw     in counter clockwise
direction.Separate the door handle    of the freeze r in the
same order. (You do not need to follow the above p rocedure
for the hidden  handle.)
2
1
3
4
2.After unscrewing the screw    of the right hinge co ver    on
the top, separate the right hinge cover    to sepa rate the
connecting cable    .Separate the bolt    fixating the upp
er
right hinge    ,and carefully separate the refrigerator d oor    .
3.After separating the upper left cap     of the separated
refrigerator door    , carefully take off the top c ap    and
pull the cable     to connect to the hole on the left  side. Set
the separated top cap    at the regular position and  set the
cap     on the cable hole on the right side.Loosen the  screw
     under the cold room door     , move it to the left of  the
stopper    , and then connec t it.
5
5
6
8
11
13
7
10
10
9
12
11
12
32
31
10
21
4
32
32
27
Your fridge-freezer is designed with reversible doors,so that they may open from either
the left or right hand side to suit your kitchen design.
Before reversing the door, first of all,you should take out food and accessories like
shelves or trays which are not fixed in the fridge-freezer.
Use Torque Wrench or Spanner to fix or remove the bolt.
Do not lay the fridge-freezer down.This will cause problems.
Be careful not to drop the doors in disassembling or assenbling
.
10
11
1213
31
32
56
798
10
4.Use a sharp gimlet or knife to disconnect the cap    from the 
cover front    , loosen the screw    , and then move the cable 
    to the left to be mounted. Disconnect the cable    and the 
door switch    from the disconnected cover front    , swap the 
position of the disconnected cable    and door switch    with 
the cap    , mount them, fix them with the screw    , and then 
install the cap    .15
14
18
1438
40
16
38
1639
15
40
1615
19
14
18
3840
39
 
						

							
NoteReversing the doors is not covered by the warranty.
1
32
38
2
1
38
3832
32
30
21
2526
21
20
29
27
3231
3331
30
28
21
24
5.Loosen the bolt     of the Hinge Middle     , remove the Hinge
Middle    , and lift up the freezer door     to separat e it.
(When separating the refrigerator door, separate the b ush
35
together.)Separate the hinge cover    and set it on the sep arated
part of middle hinge    . After unscrewing the screw con nected
to the bottom cover    connect the cover cap    on the right  side.
Loosen the pin    in counterclockwise direction and move  to the
hole on the left side to tighten in clockwise direction.  Loosen
the bolt     connected to the lower hinge    . Unscrew the  screw
    fixating the door stopper    at the bottom of the freeze r door
    , and fixate it on the hole on the left side with th e door
stopper    .And then, move the upper cap     to the rig ht and
cov
er it. 
27
2335
28
29
2122
20
25
6.Set the separate lower hinge     on the bottom hole of t he left
side of the freezer, and tighten the bolt    . After fixati ng the
bottom cover    at the regular position, align the freezer  door
30 
on the pin of lower hinge     to attach it properly. Tur n over
the separated middle hinge     and sheet hinge    to as semble
them. And set the bush     and washer     together to t ighten
the bolt    . (When tightening the bolt, be careful not to  cause
an scratch on the cap decor on top of the freezer doo
r).
8.Move the separated door handle     to the right and fixa te the
screw     on the right position to attach the door cap     .Move
the door cap     on the right side to the left and attach it.  Attach
the freezer door handle     in the same method as the refrig erator
door handl
e     .
10
21
37
36
9
19
76
7.After assembling the door by aligning the hinge hole  on the
bottom of the refrigerator door    and the pin of the  middle
hinge    , connect properly to the hold of the upper left  hinge
    included in the owner’s manual. After connecting the  cable
    , tighten the bolt     to screw the screws    to the left  hinge
cover    included in the owner’s manual. Move the hinge  cover
     attached on the left side to the right and atta ch it.
28
24
20
21
223523
21
28
27
20
25
30
33
26
25
3027
2829
9
3132
37
367
619
9
10