LG Gc P207 Wvka Owners Manual

2
Entry
Important safety instruction
Identification of parts
Where to install
Door removal
Door replacement
F
Height adjustment
eed water pipe installation
when the freezer door does not align with the height of the refrigerator\
 door
Starting
Adjusting the temperatures and functions
Refreshment center (Applicable to some models only)
Shelf (Applicable to some models only)
Wine holder (Applicable to some models only)
Egg box (Applicable to some models only)
Humidity control in the vegetable...

Entry
The mode\b and se\fia\b n\iumbe\fs a\fe found on t\ihe inne\f case o\f back \iof \fef\fige\fato\f
compa\ftment of this \iunit. These numbe\fs \ia\fe unique to this unit\i and not
avai\bab\be to othe\fs. Y\iou shou\bd \feco\fd \fequested info\fmation \ihe\fe and \fetain
this guide as a pe\fma\inent \feco\fd of you\f pu\fchase. Stap\be you\f \feceipt he\fe.
Date of purchase : 
Dealer purchased from :
Dealer address :
Dealer phone no. :
Model no. :
Serial no. :
Before it is used, this refrigerator...

4
Introduction
 

1. Place your appliance where it is easy touse.
2. Avoid placing the unit near heat sources, direct sunlight or moisture.
3. To ensure proper air circulation around the fridge -freezer, please maintain sufficient
space on both the sides as well as top and
maintain at least 2 inches (5 cm) from the
rear wall.
4. To avoid vibrations, the appliance must be leveled.
5. Dont install the appliance below 5 °C. It may cause affect the performance. 

5
Select a good
location

Where to Install
Disposal of theold...

6
          noitallatsnI
 

Door replacement
Feed water pipe installation
Pass the refrigerator laterally through the access
door as shown in the right figure.
Automatic ice maker operation needs water pressure of 147~834 kPa (1.5~8.5
kgf/cm2) (That is, an instant paper cup (180 cc) will be fully filled within 3 sec.).
If water pressure does not reach the rating 147 kPa (1.5 kgf/cm2) or below, it is
necessary to purchase a separate pressure pump for normal automatic icin\
g and
cool water feed.
Keep the total length of the feed...

8
Installation
Height adjustment
The refrigerator doors will close smoothly by heightening the front side by adjusting
the height adjusting screw. If the doors do not close correctly, performance may be
affected.
After leveling the
door height

Next1. Wipe off all dust accumulated during shipping and clean your appliance thoroughly.
2. Install accessories such as the ice cube box, cover evaporating tray, etc., in their
proper places. They are packed together to prevent possible damage during shipping....

9
Starting
When your refrigerator is first installed, allow it to stabilize at norm\
al operating
temperatures for 2-3 hours prior to filling it with fresh or frozen foods. 
If operation is interrupted, wait 5 minutes before restarting.


\b	

\f \f	


\b	

\f
\b	


  
	 


	 
  


	 
  


\b	

\f \f	
\f\f

Adjusting the temperatures and functions
•Your model may not include every option.
NOTE

Operation
 

10
Operation

Display Power Saving Mode 
This function places the display into power saving mode until the next t\
ime the door
is opened. 
Press the FREEZER and EXPRESS FRZ. buttons simultaneously and hold them \
for 5
seconds until the Ding sounds. All LED/LCDs will then turn ON, then OFF.\
 When the
power saving mode is activated, the display will remain off until the ne\
xt time the
door is opened. Then, it will come on whenever a door is opened or a but\
ton is
pressed and remain on for 20 seconds...