LG Gc B419 Weqk Owners Manual

							Energy-Saving Method
23
Energy-Saving Method
•  Install the fridge in a shady,cool and well-ventilated place.
•  Do not open and close the door frequently if not  necessary.
•  Please do not keep the door open for a long time,  close door in the shortest time.
•  Allow hot food to cool prior to storing.
•  Too much food are not advised to be put in. Enough  space should be kept for cool air circulating freely.  
•  Do not set the temperature of refrigerator lower than  needed.Do not put the food near the temperature 
sensor. 
•  Food need’t store is not advised to be put in.
•  Place the deep-frozen food for thawing intorefrigerator;  they can be used for cooling the refrigerator.
(Applicabe to some models only) 
•  Clean up the back cover and anti-condensation pipe  termly (once a year) to make sure heat exchange in gear. 
  (Applicabe to some models only)
•  Do not block air vents with food. ( Applicabe to some models only)
 
						

							Suggestions on food storage
Storing Food
Storing Food
•Do not store food which goes bad easily at low
temperature, such as banana, and melon.
•Allow hot food to cool prior to storing. Placing hot
food in the fridge-freezer could spoil other food, and
lead to higher electric bills.
•When storing the food, use a container with a lid. This
prevents moisture from evaporating, and helps food to
keep its taste and nutrients.
•Do not block air vents with food. Smooth circulation of
cold air keeps fridge-freezer temperature even.
•Do not open the door frequently. Opening the door
lets warm air enter the fridge-freezer, and cause
temperature to rise.
•
To adjust the temperature control easily, do not store
food near the temperature control dial.
•Never keep too many foods in door rack, as this may
stop the door from fully closing.
•Do not store bottles in the freezer compartment - they
may break when frozen.
•Do not refreeze food that has been thawed. This
causes loss of taste and nutrition.
NoteIf you keep the fridge-freezer in a hot, and humid
place, frequently open its door or put a lot of
vegetables in it, dew may form in it, which has no
effect on its performance.
Remove the dew with dust cloth free from care.
24
 
						

							Care and Maintenance
Power Failure
General Information
•1~2 hour power failure does no harm to the foods
stores. Try to avoid opening and closing the door too
frequently.
Lamp Replacement
If You MoveAnti
Condensation Pipe•Take out foods from the fridge-freezer and firmly fix
the loose items with tape.
•Turn the leveling screws until they stop before moving
the fridge-freezer. Otherwise the screw may scratch
the floor or the fridge-freezer cannot move.
•The Anti-Condensation
pipe is installed around the
front side of fridge-freezer
as well as on the partition
between fridge
compartment and freezer
compartment to prevent
dewing.
•Especially after installation
or when ambient
temperature is high, the fridge-freezer may feel hot,
which is quite normal.
Anti-CondensationPipe
25
•Lamp
If LED lamp is damaged,it should be replaced 
by the service center in stead of on your own. Use a DC12V 0.75W LED lamp broad.
 
						

							Care and Maintenance
Before Cleaning
Cleaning
Be sure to unplug the power.
InteriorAs above.
After CleaningCheck that the power cord is not damaged, power plug
has not overheated, and that the power plug is tightly
inserted into the outlet.
Be sure to dry the appliance with a cloth after washing
it with water.
Do not use abrasive, petroleum, benzene, thinner,
hydrochloride acid, boiling water, rough brush, etc, as
they may damage parts of the fridge-freezer.
ExteriorClean the outside of the fridge-freezer with a soft cloth
soaked with hot water or liquid detergent. If you use a
detergent, be sure to wipe it with a clean wet cloth.
26
 
						

							27
Trouble Shooting
Trouble Shooting
Problem
Fridge-Freezer
does not operate
Before calling for service, check this list.
It may save you both time and expense.
This list includes common occurrences that are not
the result of defective workmanship or materials in
this appliance.
Possible Causes
• Power plug may be unplugged from the electric outlet.
Plug it in securely.
• House fuse has blown or circuit breaker has tripped.
Check and/or replace fuse and reset circuit breaker.
• Power cut. Check house lights.
Fridge or Freezer
Compartment
Temperature too warm• Temperature control not set on proper position. Refer to Temperature Control section.
• Appliance is placed close to heat source.
• Warm weather-frequent door openings.
• Door left open for a long time.
• Package holding door open or blocking air duct in freezer compartment.
Vibration or
Rattling or
Abnormal Noise• The floor on which the fridge-freezer is installed may be uneven or the fridge-freezer may be
unstable.
Make it even by rotating the leveling screw.
• Unnecessary objects placed in the back side of the fridge-freezer.
Frost or Ice
Crystals on frozen Food• Door may have been left ajar or package holdingdoor open.
• Too frequent or too long door openings.
• Frost within package is normal.
Moisture forms on Cabinet Surface• This phenomenon is likely to occur in a wet space.Wipe it with a dry towel.
 
						

							Trouble Shooting
Problem Possible Causes
Moisture collects inside
• Too frequent or too long door openings.
•In humid weather, air carries moisture into fridge 
when doors are opened.
Fridge has odor•Foods with strong odors should be tightly 
covered or wrapped.
•Check for spoiled food.
•Interior needs cleaning.
Refer to CLEANING section
Door not closingproperly• Food package is keeping door open.Move packages that keep door from closing.
• Fridge-freezer is not level. Adjust the leveling screws.
• The floor on which the fridge-freezer is  installed may be uneven or the fridge-freezer
 may be unstable.
Slightly raise the front side with the leveling screw.
Interior light does
not work• No power at outlet.
• Light lamp needs replacing.Refer to the Lamp Replacement section
1. When this crossed-out wheeled bin symbol  is attached to a
    product it means the product is covered by the European
    Directive 2002/96/EC.
2. Al  electrical and electronic products should be disposed of
l
   
 separately from the municipal waste stream via designated
    collection facilities appointed by the government or the local
    authorities.
3. The correct disposal of your old appliance will help prevent
 
    potential negative consequences for the environment and 
    human health.   
4. For more detailed information about disposal of your old 
    appliance, please contact your city office, waste disposal 
    service or the shop where you purchased the product.  
Disposal of your old appliance
28
 
						

							To Reverse the Doors
Precaution
1.
2.
3.
4.
How to Reverse the Door
1.To separate the door handle     of the left side, separate 
the door cap     and unscrew the screw     in counterclockwise
direction.Separate the door handle    of the freezer in the
same order. 
2
1
3
4
2.After unscrewing the screw     of the right hinge cover    
on the top, separate the right hinge cover    to separate 
the connecting cable    .Separate the bolt    fixating the 
upper right hinge     , and carefully separate the refrigerator 
door    . Remove the left cover    .
556
8
7
1019
9
29
Your fridge-freezer is designed with reversible doors,so that they may o\
pen from either
the left or right hand side to suit your kitchen design.Before reversing the door, first of all,you should take out food and acc\
essories like
shelves or trays which are not fixed in the fridge-freezer.
Use Torque Wrench or Spanner to fix or remove the bolt.
Do not lay the fridge-freezer down.This will cause problems.
Be careful not to drop the doors in disassembling or 
assembling.
3.After separating the upper left cap     of the separated
refrigerator door    , carefully take off the top cap    and
pull the cable     to connect to the hole on the leftside. 
Set the separated top cap    at the regular position and
set the cap     on the cable hole on the right side. Loosen 
the screw         under the cold room door     , move it  
to the left of the stopper         , and then connect it.11
13
1012
11
12
32
31
10
4.Use a sharp gimlet or knife to disconnect the cap    from 
the cover front    , loosen the screw    , and then move 
the cable    to the left to be mounted. Disconnect the cable    
    and the door switch    from the disconnected cover front
    , swap the position of the disconnected cable    and door 
switch    with the cap    , mount them, fix them with the 
screw    , and then install the cap    .      15
14
18
14
3840
16
38
16
39
15
40
21
4
32
32
10
11
1213
3132
56
798
10
1615
14
18
19
3840
39
4344
43
44
 
						

							Move the separated door handle     to the right and fixate the
screw     on the right position to attach the door cap    .Move
the door cap     on the right side to the left and attach it. Attach
the freezer door handle     in the same method as the refrigerator Loosen the bolt     of the Hinge Middle     , remove the Hinge
Middle    , and lift up the freezer door     to separate it.
(When separating the refrigerator door, separate the bush
together.)Separate the hinge cover  
  and set it on the separated
part of middle hinge    . After unscrewing the screw connected
to the bottom cover    connect the cover cap    on the right side.
Loosen the bolt     connected to the lower hinge     . Unscrew 
the screw          fixating the door stopper        at the 
NoteReversing the doors is not covered by the warranty.
1
32
412
41
4132
32
30
21
2526
21
20
21
24
5.
35
bottom of the freezer door    ,and fixate it on the hole on 
the left side with the door stopper        .and then ,move 
the upper cap     to the right and cover it. 
6.Set the separate lower hinge     and put it in the bag,take 
out the lower left hinge     of the bag and set the lower 
left hinge    on the bottom hole of the left side of the 
freezer then tighten the bolt    .After fixating the bottom 
cover     at the regular position,align the freezer door  
on the pin of lower hinge      to attach it properly. Turn over
the separated middle hinge      and sheet hinge      to 
assemble them. And set the bush     and washer      together 
to tighten the bolt     . (When tightening the bolt, be 
careful not to cause an scratch on the cap decor on top of 
the freezer door).
8.
door handle    .1 
7.
30
24
20
21
223523
21
45
27
20
25
30
33
26
25
303132
37
367
642
9
10
4344
27
28
After assembling the door by aligning the hinge hole on the 
bottom of the refrigerator door     and the pin of the 
middle hinge     , take out the upper left hinge cover   
and the left hinge     of the bag, After connecting the cable    , 
tighten the bolt     to screw the screws      to the left hinge 
cover    Take the right cap    out of the bag and clean up the 
wire, then install it on the right side of the refrigerator top.
27283143324430
33
3143
2845
45
45272530
2122352320
10
2136
37
4236
967