LG Ga B399 Ueqa Owners Manual

							
Operation
51

Features
Install
Water Dispenser 
Please assemble the Valve Assembly after correctly
adjusting it with a Door Hole.
Filling ofWater Tank
Drinking
1. After turning the Handle Tank backward with the
    Water Tank installed at the Door, Open the CapTank (Small) 
    and then fill water using a kettle etc.
    * Fill water while watching a sight glass on the front
      of the Water Tank.
    * Water up to 3,0 L can be filled.
2. Press and fix the Cap Tank (Small).
3. After filling spring water, fix the Handle Tank at
    a proper position.
1. Press the Dispenser Pad with a cup.
2. If pressing the Pad, water inside of the Dispenser is supplied.
3. If slowly removing a cup from the Pad, water will not fall down.
WarningDo not use other beverage (milk, juice, carbonated
beverage etc) than spring water. Especially beverage
including grain must not be used (may result in failure).
Fill with potable water only.
Dispenser Pad
Handle Tank
Water Tank
Drip Tray
Valve Assembly
Cap Tank (Small)
Cap Tank (Big)
Grille
GA-F3*9B*QA;Models:GA-F4*9B*QA
 
						

							
Suggestions
 on food storage
52

Storing Food• Do not store food which goes bad easily at lowtemperature, 
  such as banana, and melon.
• Always allow hot food to cool to room temperature. 
  Never put hot food into refrigerator and freezer chambers. 
  It could spoil other food, and lead to higher electricity loss.
• When storing the food, use a container with a lid. 
  Thisprevents moisture from evaporating, and helps food 
  tokeep its taste and nutrients.
• Do not block air vents with food. Smooth circulation of cold 
  air keeps fridge-freezer temperature even.
• Do not open the door frequently. Frequent opening the 
  doors warm up temperature in the chambers which leads 
  to spoil other products & electricity loss.
• To adjust the temperature control easily, do not storefood 
  near the temperature control dial.
• Never keep too many foods in door rack, as this maystop 
  the door from fully closing.
• Do not store bottles in the freezer compartment - they may 
  break when frozen.
NoteIf you keep the fridge-freezer in a hot, and humid place,
frequently open its door or put a lot of vegetables in it,
dew may form in it, which has no effect on its
performance.
Remove the dew with dust cloth free from care.
 
						

							
Suggestions on food storage
53

To ensure good air circulation in the appliance, insert
the freezer drawers all the way.
If large quantities of food are to be stored in the freezer 
the middle drawer of the freezer compartment can be 
taken out of the appliance and food can be stored right 
over the food stacked in the lower drawer.
To remove one of the freezer drawer do the following: 
1) Pull the drawer until it stops;
2) Lift the front part up and remove the drawer.
Dont apply a overwhelming effort and brute force on
drawer and shelves - it could damage the refrigerator!
Removing / Installing freezer drawers
·
·
·
Warning
·
To install a freezer drawer back into the freezer do 
the same steps in reverse order: 
3) Put the drawer on the guides at the angle of 45 °;
4) Lower the front part to one level with the guides;
5) Push the drawer until it stops.
    Make sure that the angle of the drawer is not skewed.  

12
4
53
 
						

							
Care andMaintenance
54

Power Failure
General Information
• 1~2 hour power failure does no harm to the foods stores. 
  Try to avoid opening and closing the door too frequently.
If You Move
Anti-CondensationPipe
• Take out foods from the fridge-freezer and firmly fix 
   the loose items with tape.
• Turn the leveling screws until they stop before moving
   the fridge-freezer. Otherwise the screw may scratch
   the floor or the fridge-freezer cannot move.
• The Anti-Condensation
  pipe is installed around the
  front side of fridge-freezer
  as well as on the partition
  between fridge compartment 
  and freezercompartment to 
  prevent dewing, which is 
  heating during the operation 
  of compressor.
• Especially after installation
  or when ambienttemperature 
  is high, the fridge-freezer may 
  feel hot,which is quite normal.
Anti-Condensation Pipe
Refrigerator work features
As a result of thermal strain for components of a 
refrigerator appliance can be heard crackling noise that is 
not a defect and doesn’t affect efficiency of the appliance. 
This special sound when the thermo-regulator and 
compressor and turned on is a normal state, which 
appears during the working process of appliance’s 
electric installation.
The gas refrigerant produces a slight noise even when 
the compressor is not running (this is not a defect). 
While refrigerator appliance working process can be heard:
- flick of the temperature relay;
- murmur of refrigerant flowing round cycle;
- cracking noise because of the materials deformation by 
  temperature.
All that is not defect and doesn’t affect efficiency of 
the appliance.
Caution
 
						

							
Care and Maintenance
55

 

12
134

• To Remove the shelf from refrigerator, at first – lift up it (1), 
   and then – pull it out side (2). In case of wrong removing 
   of the shelf, the damages of inner surfaces of refrigerator 
   possible.
• To install shelf into refrigerator follow similar: lift up 
   front side of the shelf at the angle (3) and then insert 
   it inside (4). In case of wrong installing of the shelf, 
   the damages of inner surfaces of refrigerator possible.
Remove/Installshelf
LampReplacement
1. Unplug the power cord from the outlet.
2. Remove fridge shelves.
3. To remove the lamp cover, insert type 
    driver in the underside of the lamp 
    cover and pull it out forwards.
4. Turn the lamp counterclockwise.
5. Assemble in reverse order of 
    disassembly. Replacement lamp must 
    be the same specification as original.
6. MAXIMUM rated input of lamp should 
    not to exceed 20 W.
Warning
       
						

							
Рекомендации по хранению продуктов
56
Care and Maintenance

      Removing/Installing bottom drawerof refrigerator
NoteWarranty does not cover mechanical damage (cracks, 
chips, dents and etc.) caused by the breaking of the rules 
of storage, transportation, operation, maintenance of 
the refrigerator, or application too much physical force.
4) To install the drawer back, do the same steps 
    in the reverse order. 
Make sure that the angle of the drawer is not skewed.
Improper removing or installation can damage the interior 
parts of the refrigerator.
To remove the bottom drawer from the refrigerator do 
the following: 
1) Remove the lower basket from the door by lifting it up; 
2) Pull the drawer until it stops and slightly lifting it up pull 
    it to take it out; 
 
3) Lift the front part of the drawer cover and pull it to remove;
Warning

3
4
1
2
       
						

							
Care and Maintenance
57

Check that the power cord is not damaged, power plug
has not overheated, and that the power plug is tightly
inserted into the outlet.
Cleaning
Before Cleaning
After Cleaning
Warning
Be sure to unplug the power.
As above.
Clean the outside of the fridge-freezer with a soft cloth
soaked with hot water or liquid detergent. If you use a
detergent, be sure to wipe it with a clean wet cloth.
Exterior
Interior
Grille and DripTray
Exterior Dispenser
Cap Tank(Big & Small)
Water Tank1. Lift the Water Tank up by pressing the fixing Lever
    on the bottom of Water Tank and then remove it.
2. After removing the Cap Tank (Big), clean and fully
    rinse the inside/outside part of the Water Tank by
    using neutral cleansing agent.
Wipe moisture etc out outside of Dispenser and on the
Dispenser Pad using a cloth.
Remove the Grille, wipe moisture out around the Door
part and the Drip Tray using a clean cloth.
Clean and fully rinse the Cap Tank (Big & Small) by using
neutral cleansing agent.
Especially for the groove part of the Cap Tank, it is
convenient to cleanse it by using a small brush.
Clean and fully rinse the Valve Assembly by using a
small brush. Rinse it while operating the bottom part of
the valve assembly. Always fix the Sealing Rubber
separated for cleansing at the existing position
(may result in water leakage).
Be sure to dry the appliance with a cloth after washing
it with water.
Do not use abrasive, petroleum, benzene, thinner,
hydrochloride acid, boiling water, rough brush, etc, as
they may damage parts of the fridge-freezer.
Valve Assembly
 
						

							
Trouble Shooting
58

Problem
Fridge-Freezerdoes not operate
Before calling for service, check this list or 
call in Support service of clients. 
It may save your time and expense.
This list includes common occurrences that are 
not the result of defective workmanship or 
materials in this appliance.
Possible Causes
• Power plug may be unplugged from the electric outlet.
Plug it in securely.
• House fuse has blown or circuit breaker has tripped.
Check and/or replace fuse and reset circuit breaker.
• Power cut.
Check house lights.
Fridge or FreezerCompartmentTemperature too warm
• Temperature control not set on proper position. 
Refer to Temperature Control section.
• Appliance is placed close to heat source.
• Warm weather-frequent door openings.
• Door left open for a long time.
• Package holding door open or blocking air duct in 
  freezer compartment.
Vibration orRattling orAbnormal Noise
• The floor on which the fridge-freezer is installed may 
  be uneven or the fridge-freezer may beunstable.
Make it even by rotating the leveling screw.
• Unnecessary objects placed in the back side 
   of the fridge-freezer.
Frost or Ice• Door may have been left ajar or package holding 
  door open.
• Too frequent or too long door openings.
• Frost within package is normal.
Moisture forms onCabinet Surface
• This phenomenon is likely to occur in a wet space.
Wipe it with a dry towel.
 
						

							
Trouble Shooting
59

ProblemPossible Causes
Moisture collectsinside
• Too frequent or too long door openings.
• In humid weather, air carries moisture into fridge when
  doors are opened.
Fridge has odor• Foods with strong odors should be tightly covered or 
  wrapped.
• Check for spoiled food.
• Interior needs cleaning.
Refer to CLEANING section.
Door not closingproperly
• Food package is keeping door open.
Move packages that keep door from closing.
• Fridge-freezer is not level.
Adjust the leveling screws.
• The floor on which the fridge-freezer is installed may be 
   uneven or the fridge-freezer may be unstable.
Slightly raise the front side with the leveling screw.
Interior light doesnot work
• No power at outlet.
• Light lamp needs replacing.
Refer to the Lamp Replacement section.
1. When this crossed-out wheeled bin symbol  is attached to a
    product it means the product is covered by the Europe an    
    Directive 2002/96/EC.
2. All electrical and electronic products should be disposed of
    separately from the municipal waste stream via designated    
    collection facilities appointed by the government or the local    
    authorities.
3. The correct disposal of your old appliance will help prevent
    potential negative consequences for the environment and     
    human health.  
4. For more detailed information about disposal of your old
    appliance, please contact your city office, waste disposal     
    service or the shop where you purchased the product.   
Disposal of your old appliance
NoteFor more information about refrigerator service and use, 
you can find at the official site of LG at «Frequently 
Asked Questions» (www.lg.com/ru/refhelp).
 
						

							
60

1
4
32
32
1615
17
19
14
18
10
1213
31
32
56
798
10
19
10
3132
11
35
11

2
1
3
4
2.
55
6
87
10
9
3.
13
12
11
12
32
31
6.
15
14
18
14
15
1716
1716
35
3,4. For exterior        type display
2. For exterior     type display
4,5. For interior        type display
6. Only for exterior type display
32
4.
5.
19 
1. Only for models with     exterior door handles
10
30
To Reverse the Doors
Precaution
1. Before reversing the door, first of all,you should take out food and accessories 
    likeshelves or trays which are not fixed in the fridge-freezer.
2. Use Torque Wrench or Spanner to fix or remove the bolt.
3. Do not lay the fridge-freezer down.
4. Be careful not to drop the doors in disassembling 
    or assenbling. 
How to Reverse the Door
Your fridge-freezer is designed with reversible doors,so that they may o\
pen from either
the left or right hand side to suit your kitchen design.
To remove door handle     of  the refrigerator door    , 
first remove caps    , and then unscrew screws     in 
a direction of counter-clockwise. The handle     of 
the freezer door     removes in the same order. 
You do not need to follow up the above procedure 
for the hidden handle.
After unscrewing the screw     of cover hinge on 
the top    , take off cap hinge     and disconnect 
cable     (Only for the exterior display type models). 
Unscrew bolts    , which fasten upper hinge     , 
and carefully take off the refrigerator’s door     . 
Remove cap     .
Remove cap cover of door     (only for the exterior 
display type models), pull out cable     and install it 
into the opening on the opposite side of the door. 
Set the cap cover of door     in its place. 
Screw out the screw     located under the refrigerator 
door and move it emphasis on     to the opposite side. 
Fixate the screw     .
Move plastic caps     (for all types display)  and 
(only for of interior type display models) to the 
opposite side.
(Only for exterior type display). 
Press by the (-) screwdriver and separate caps     
of cover front     and unscrew screws        , remove 
cover front, then move cable     to the opposite side. 
After installation cover front     , screw by parts  
and cover it by caps     .
1.