LG Ga 479 Bspa Owners Manual

							
41
Installation
Installation
Starting
1. Select a good location.
    Place your fridge-freezer where it is easy to use. 
2. Avoid placing the unit near heat sources, 
    direct sunlight or moisture.
3. To ensure  proper air circulation around the fridge -freezer,
    please maintain sufficient space on both the sides as well as
    top and  maintain at least 2 inches (5 cm) from the rear wall.
4. Please, do not remove the round stickers on the back side 
    of the refrigerator. They are  performing decoration functions 
    by closing technological holes.  
5. To avoid vibration, the unit must be leveled. If required, adjust
    the leveling screws to compensate for the uneven floor.
    The front should be slightly higher than the rear to aid in door
    closing. Leveling screws can be turned easily by tipping the
    cabinet slightly.     
    Turn the leveling screws counterclockwise (       ) to raise
    forward  part  of  a  refrigerator,  clockwise (       ) to lower it.
6. Before use clean your fridge-freezer thoroughly.
7. Install accessories such as ice cube box, etc., in their 
    proper places. They are packed together to prevent 
    possible damage during shipment.
8. Connect the power supply cord (or plug) to the outlet.
    Dont  double up with other appliances on the same outlet.
When your fridge-freezer is installed, allow it 2-3 hours at normal
operating temperature prior to filling it with fresh or frozen foods.
If power plug is disconnected, allow 5 minutes delay
before restarting.
Your fridge-freezer is now ready for use.
The appliance is designed to operate in a limited range 
of ambient temperature, depend on climatic zones. You are 
not allow to go for any lower, either from the top of the range. 
Climatic class of your appliance marked on the Label 
specification with technical description in inner side of the 
refrigeration compartment.
Climatic classAdmissible ambient 
temperature
+10  С  до  32  С 
+18  С  до  43  С 
+18  С  до  38  С 
+16  С  до  32  С 
SN
N
T
ST
o
o
o
o
o
o
o
o
Climatic class
 
						

							
Operation
Your fridge-freezer has controls that let you regulate the
temperature in the fridge and freezer compartments.

TemperatureAdjustmentButtonforRefrigeratorCompartment
TemperatureAdjustmentButtonforOptiFreshZoneCompartment
ON/OFFPowerButton
TemperatureAdjustmentButtonforFreezerCompartment
SuperFreezerButton
VacationButton
< Exterior Type 1 >
< Exterior Type 2 >
MinMax

TemperatureAdjustmentButtonforRefrigeratorCompartment
LockButton
ON/OFFPowerButton
TemperatureAdjustmentButtonforFreezerCompartment
SuperFreezerButton
VacationButton

Adjusting the
temperatures and
functions

2242
Display Panel For
Temperature Control
Model: GA-4*9B**A
< Exterior Type 1 >
Model: GA-4*9U**A
 
						

							
TheinitialTemperatureoftheFreezerandRefrigerator
Compartment is -21°Cand4°Crespectively. You cannow
adjustthe temperatureof the compartmentsasyouwant.
Operation

When youpressthetemperaturecontrolbutton,
the temperatureoftheFreezerorRefrigerator
part is changeby1degree.

•When youpress the temperature control buttons,
the temperatureof Refrigerator and Freezer
compartmentisrepeatedin thefollowing order.
Refrigeration
Compartment :
3→4→5→1→2
FreezerCompartment :
3→4→5→1→2
•Lowernumbermeanshigher temperature setting
ineachcompartment
•
How to adjust the
temperature in the
refrigerator and
freezer compartment

2243
< Exterior Type 2 >
< Exterior Type 1 >
The initial temperature:
- of  freezer  compartment       3 
- of refrigerator compartment      3    →
→
< Exterior Type 2 >
< Interior Type > 
Model: GA-4*9U**A
Model: GA-4*9B**A
For  all  models
 
						

							
44
NoteThe actual inner temperature varies depending on the
food status, as the indicated setting temperature is a
target temperature, not actual temperature within
refrigerator. Refrigeration function is weak in the
initial time. Please adjust temperature as above after
using refrigerator for minimum 2~3 days.

When you press the temperature control
button, the temperature of the Freezer or
Refrigerator part is change by 1 degree.
•  When you press the temperature control
buttons, the temperature of Refrigerator and
Freezer compartment is repeated in the
following order. Refrigeration 
Compartment : 
4
→•→2→•→8
Freezer Compartment : 
-21→•→-24→•→-18
• Lower number means higher temperature
setting in each compartment 
• The initial temperature of freezer and
refrigerator compartment is -21 and 4
respectively.
When you press the temperature control
buttons, the temperature of Refrigerator
and Freezer compartment is repeated in
the following order. 
Refrigeration Compartment : 
3→4→5→1→2

< Interior Type >
< Exterior Type 2 >
< Exterior Type 1 >
Model: GA-4*9U**A
For  all  models
Operation
 
						

							
Opti Fresh Zone
Temperature
Transition Corner
(Optional)
Method to use
By pressing the button, store meat (at relatively low
conservation temperature) or other types of food to be
defrosted ,raw fish,etc...
The temperature of the Opti fresh zone’s compartment
is always okay.
Pressing “OPTI ZONE”  button start operation with lamp
ON and pressing it again stops the operation.
< Exterior Type 1 >< In selecting Opti Fresh Zone ON >
< In selecting Opti Fresh Zone OFF >

2245
< In selecting Opti Fresh Zone ON >
< In selecting Opti Fresh Zone OFF >
Model: GA-4*9B**A
Model: GA-4*9U**A
< Exterior Type 1 >
Operation
 
						

							
Super/Express • Please select this function for prompt freezer.
• This function is used when you want to freeze the
foods quickly. Press the “SUPER FRZ.” (Super Freezer)
once, and then the quick freezer operation starts
with the lamp on.
• The Super Freezer operation takes about 3 hours. 
When its operation ends, it automatically returns to the
previous temperature setting. If you want to stop the
quick freeze operation, press the “SUPER FRZ.” or 
goes out, and the Super Freezer or the Express Freezer
operation stops and the refrigerator returns to the
previous temperature setting.
• The arrow mark graphic remains at the “ON” status after
flickering for 4 times when selecting Super Freezer is
turned “ON”.

In selecting Super Feezer ONIn selecting Super Feezer OFF

2246
or the “EXPRESS FRZ.” (Express Freezer) button
the “EXPRESS FRZ.” button once more, the lamp
Freezer
Model: GA-4*9B**A
Model: GA-4*9U**A
Operation
 
						

							
Operation
Vacation

In selecting Vacation ONIn selecting Vacation OFF

NoteWhen the Vacation mode is “ON”, the other buttons
will not operate. When you come back from
vacations, press the vacation mode off so that other
buttons work and the refrigerator returns to previous
temperature setting.
This function makes the fridge-freezer work in a power
saving mode which is useful for when you are away on
holiday, by reducing energy consumption as much as
possible.
Pressing “VACATION” starts operation with lamp “ON”
and pressing it again stops the operation.

2247
Model: GA-4*9B**A
Model: GA-4*9U**A
 
						

							
Operation
Lock/
Child Lock
“ON / OFF”
Function
• ”Locking” or “Un-Locking” is repeated whenever
pressing the “LOCK”  or the “CHILD LOCK” button. 
or the “CHILD LOCK” button for 3 sec).
•  When “LOCK” or “CHILD LOCK” is activated, pressing 
the other buttons would not work.
Switching on and off the appliance
Switch off
• Press the “ON/OFF” button over 3 seconds to switch for
defrosting, cleaning and no use of long term.
• The outside lamp (display) is turned off.
• The inside lamp is “ON”, When open the door.
Switch on
• Press the “ON/OFF” button over 3 seconds to switch
the appliance.
In selecting Lock ONIn selecting Lock OFF

2248
(For “Locking” or “Un-Locking” press the “LOCK”
< Exterior Type 2 >
Model: GA-4*9B**A
Model: GA-4*9U**A
< Exterior Type 2 >
 
						

							
49
Operation
Door Alarm•When the door of the fridge is left opened for a while, the
alarm sounds. Please contact with the local service center if
warning continue to sound even after closing the door.
Ice Making• Fill water in ice making box of the ice making corner. If
water is fully filled the ice will not be separated well and
water can be dropped to make ice lumped.
• Ice will be dropped into the ice storage bin by rotating ice
separation handle of ice making compartment.
Note• Rotating the ice separation handle before ice is fully
frozen may cause the remaining water drop into the
ice storage bin to lump the ice together.

Defrosting• The refrigerator uses an automatic defrosting system.
Frost, forming on the back wall of the compartment
melts,  when the Cyclically working compressor is
switched off,  and turns to water drops. Melt water runs
down to the drain tray, gets to the container in the
compressor through the tube. It is necessary (at least once
in 3 months) clean the drain hole to ensure unobstructed
drainage of melt water to the container.
• To defrost and clean the freezing compartment,
unplugging the refrigerator or selecting ‘On/Off’ switch
and removing products from the freezing compartment.
Open the door of  the freezing compartment for 1 hour,
collect melt water with a sponge and wash the
compartment and rub it dry.
Tip• To remove ice
cubes easily, run
water on the tray
before twisting.
 
						

							
Operation

50
Half Shelf
(Optional)
Wine Rack
(Optional)
• To place high objects, for example, bottles, it is 
necessary to take out the front half of the shelf. 
Lift it a little and drag it to yourself. Make the same 
operations in the reverse order to restore to a full shelf.
• Bottles can be stored laterally with this wine corner.
Then you can invert the wine rack and place it on the
shelf.
This will enable more shelf-place.

ex) in using
ex) in not using