LG Ga 449 Bsna Owners Manual

							
Important Safety Instruction
 Warning
Precaution•This fridge-freezer must be properly installed and
located in accordance with the Installation
Instruction before it is used.
•Never unplug your fridge-freezer by pulling on
the power cord.Always grip plug firmly and pull
straight out from the outlet.
•When moving your appliance away from the wall,
be careful not to roll over or damage the power
cord.
•After your fridge-freezer is in operation, do not
touch the cold surfaces in the freezer
compartment, particularly when hands are damp
or wet.Skin may adhere to these extremely cold
surfaces.
Introduction

42
 
						

							
43
Introduction
Important Safety Instruction
The supply plug of the refrigerator-freezer should be
placed in easy accessible position for quick disconnection
in emergency.
Accessibility of
Supply Plug
If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified
person in order to avoid a hazard.
Dont store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
In the event of an electric short circuit, grounding
(earthing) reduces the risk of electric shock by providing
an escape wire for the electric current. In order to
prevent possible electric shock, this appliance must be
grounded. Improper use of the grounding plug can result
in an electric shock. Consult a qualified electrician or
service person if the grounding instructions are not
completely understood, or if you have doubts on
whether the appliance is properly grounded.
Risk of child entrapment. 
Before you throw away your old refrigerator or freezer:
Take off the doors. 
Leave the shelves in place so that children may not
easily climb inside.
Supply Cord
Replacement
Danger
Dont store
Grounding
(Earthing)
 
						

							
Introduction
Important Safety Instruction

44
 Warning Keep ventilation openings, in the appliance enclosure
or in the built-in structure, clear of obstruction.
 Do not use mechanical devices or other means to
accelerate the defrosting process, other than those
recommended by the manufacturer.
 Do not damage the refrigerant circuit.
 Do not use electrical appliances inside the food
storage compartments of the appliance, unless they
are of the type recommended by the manufacturer. 
 The refrigerant and insulation blowing gas used in
the appliance require special disposal procedures.
When disposal, please consult with service agent or a
similarly qualified person.
This appliance contains a small amount of isobutane
refrigerant (R600a), natural gas with high
environmental compatibility, but it is also
combustible. When transporting and installing the
appliance, care should be taken to ensure that no
parts of the refrigerating circuit are damaged.
Refrigerant squirting out of the pipes could ignite
or cause an eye injury. If a leak is detected, avoid
any naked flames or potential sources of ignition
and air the room in which the appliance is standing
for several minutes.
In order to avoid the creation of a flammable gas air
mixture if a leak in the refrigerating circuit occurs, the
size of the room in which the appliance may be sited
depends on the amount of refrigerant used. The room
must be 1m2in size for every 8g of R600a refrigerant
inside the appliance. The amount of refrigerant in your
particular appliance is shown on the identification plate
inside the appliance.
Never start up an appliance showing any signs of
damage. If in doubt, consult your dealer.
 
						

							
45
Introduction
Important Safety Instruction
 Caution•If the wall socket is loose, do not insert the power
plug.
It may cause electric shock or fire.
•Never unplug your refrigerator by pulling on the
power cord. Always grip plug firmly and pull it
straight out from the outlet.You may disconnect a
wire and cause a short circuit.
•Do not use a wet or damp cloth when cleaning the
plug. Remove any foreign matter from the power
plug pins. 
Otherwise, there is a risk of fire.
•After unplugging the appliance, wait for at least
five minutes before plugging it again to the wall
socket.
Abnormal operation of the freezer may cause material
damage.
•If the appliance is not to be used for a long time,
pull out the power plug.
Any deterioration in the insulation may cause fire.
•Do not let children touch or play with the control
panel on the front of the appliance.
•The refrigerant used in fridge/freezer and the
gases in the insulation material require special
disposal procedures. Ensure that none of the pipes
on the back of the appliances are damaged prior
to disposal.
 
						

							
Introduction
Identification of Parts

46
NoteIf you find some parts missing from your unit, they
may be parts only used in other models. (i.e. the
“Miracle Zone” is not included in all models)
 
						

							
47
Installation
Installation
Starting
1.Select a good location. 
Place your fridge-freezer where it is easy to use.
2.Avoid placing the unit near heat sources, direct
sunlight or moisture.
3.To ensure  proper air circulation around the 
fridge -freezer, please maintain sufficient space on
both the sides as well as top and  maintain at least 
2 inches (5 cm) from the rear wall.
4.To avoid vibration, the unit must be leveled. If
required, adjust the leveling screws to compensate for
the uneven floor.
The front should be slightly higher than the rear to
aid in door closing.
Leveling screws can be turned easily by tipping the
cabinet slightly.
Turn the leveling screws counterclockwise(       ) to
raise the unit, clockwise(       ) to lower it.
5.Clean your fridge-freezer thoroughly and wipe off all
dust accumulated during shipping.
6.Install accessories such as ice cube box, etc., in their
proper places. They are packed together to prevent
possible damage during shipment.
7.Connect the power supply cord (or plug) to the
outlet. Dont double up with other appliances on the
same outlet.
When your fridge-freezer is installed, allow it 2-3 hours
to stabilize at normal operating temperature prior to
filling it with fresh or frozen foods.
If power plug is disconnected, allow 5 minutes delay
before restarting.
Your fridge-freezer is now ready for use.
 
						

							
Temperature Control
Display Panel For
Temperature Control
Your fridge-freezer has controls that let you regulate the
temperature in the fridge and freezer compartments.
Operation

48

< Exterior Type 1 >
< Exterior Type 2 >
< Interior Type> 

Adjusting the
temperatures and
functions
 
						

							
49
Operation
•The initial Temperature of the Freezer and Refrigerator
Compartment is -21°C and 4°C respectively. You can now
adjust the temperature of the compartments as you want.
NoteThe actual inner temperature varies depending on the
food status, as the indicated setting temperature is a
target temperature, not actual temperature within
refrigerator. Refrigeration function is weak in the
initial time. Please adjust temperature as above after
using refrigerator for minimum 2~3 days.

How to adjust the
temperature in the
refrigerator and
freezer compartment
• When you press the temperature control
button, the temperature of the Freezer or
Refrigerator part is change by 1 degree.
• When you press the temperature control
buttons, the temperature of Refrigerator and
Freezer compartment is repeated in the
following order. Refrigeration 
Compartment : 
4
→•→2→•→8
Freezer Compartment : 
-21→•→-24→•→-18
• Lower number means higher temperature
setting in each compartment 
• The initial temperature of freezer and
refrigerator compartment is -21 and 4
respectively.
• When you press the temperature control
buttons, the temperature of Refrigerator
and Freezer compartment is repeated in
the following order. 
Refrigeration Compartment : 
3→4→5→1→2
 
						

							
Operation

50
Opti Fresh Zone
Temperature
Transition Corner
(Optional)
Method to use
• By pressing the button, store meat (at relatively low
conservation temperature) or other types of food to be
defrosted ,raw fish,etc...
The temperature of the Opti fresh zone’s compartment
is always okay.
• Pressing “OPTI ZONE”  button start operation with lamp
ON and pressing it again stops the operation.

< Exterior Type 1 >
< In selecting Opti Fresh Zone ON >
< In selecting Opti Fresh Zone OFF >
 
						

							
51
Operation
Express Freezer
Vacation
• Please select this function for prompt freezer.
• This function is used when you want to freeze the
foods quickly. Press the EXPRESS FRZ. (Express Freezer)
button once, and then the quick freeze operation starts
with the lamp it.
• The Express Freezer operation takes about 3 hours. 
When its operation ends, it automatically returns to the
previous temperature setting. If you want to stop the
quick freeze operation, press the EXPRESS FRZ. button
once more, the lamp goes out, and the Express Freezer
operation stops and the refrigerator returns to the
previous temperature setting.
• The arrow mark graphic remains at the On status after
flickering for 4times when selecting Express Freezer is
turned “On”.

NoteWhen the Vacation mode is “ON”, the other buttons
will not operate. When you come back from
vacations, press the vacation mode off so that other
buttons work and the refrigerator returns to previous
temperature setting.
• This function makes the fridge-freezer work in a power
saving mode which is useful for when you are away on
holiday, by reducing energy consumption as much as
possible.
Pressing ‘VACATION’ starts operation with lamp ON
and pressing it again stops the operation.