Lenovo V 560 User Manual

							37
Lenovo V560/B560
1040 Hard disk drive
For access, remove these FRUs in order:
• “1010 Battery pack” on page 34
• “1030 Hard disk drive(HDD)/Memory/Mini PCI Express Card slot compartment cover” on page 36
Attention: 
•	 Do	not 	drop 	the 	hard 	disk 	drive 	or 	apply 	any 	physical 	shock 	to 	it.   The  hard 
disk  drive  is  sensitive  to  physical  shock.  Improper  handling  can  cause  damages 
and permanent loss of data.
•  Before removing the drive, suggest the customer to backup all the information on 
it if possible.
•  Never remove the drive while the system is operating or is in suspend mode.
Figure 4. Removal steps of hard disk drive
Remove the screw 1 and pull the tab up in the direction shown by arrow 2 to remove the hard disk drive from the slot.
21
StepScrew (quantity)ColorTorque
1M2 × 6 mm, flat-head, nylok-coated (1)Black1.6 kgfcm
When installing: Make sure that the HDD connector is attached firmly.  
						

							38
Lenovo V560/B560 Hardware Maintenance Manual
1050 Optical drive
For access, remove this FRU:
• “1010 Battery pack” on page 34
Figure 4. Removal steps of optical drive 
Remove  the  screw 1,  insert  a  screwdriver  into  the screw  hole  and  push  the optical drive in the direction shown by arrow 2. Pull the optical drive out in the direction shown by arrow 3.
1
StepScrew (quantity)ColorTorque
1M2 × 6 mm, flat-head, nylok-coated (1)Black1.6 kgfcm
2
3 
						

							39
Lenovo V560/B560
1060 DIMM
For access, remove these FRUs in order: 
• “1010 Battery pack” on page 34
• “1030 Hard disk drive(HDD)/Memory/Mini PCI Express Card slot compartment cover” on page 36
Figure 6. Removal steps of DIMM 
Release  the  two  latches  on  both  edges  of  the  socket  at  the  same  time  in  the direction shown by arrows 1, and then unplug the DIMM in the direction shown by arrow 2.
2
1
1
Note:  If  only  one  DIMM  is  used  on  the  computer  you  are  servicing,  the  card must  be  installed  in  SLOT-0  ( a  :  lower  slot),  but  not  in  SLOT-1  ( b  :  upper slot).
a
b
When installing: Insert the notched end of the DIMM into the socket. Push the DIMM firmly, and pivot it until it snaps into the place. Make sure that it is firmly fixed in the slot and difficult to be moved. 
						

							40
Lenovo V560/B560 Hardware Maintenance Manual
1070 PCI Express Mini Card for wireless LAN/WAN
For access, remove these FRUs in order:
• “1010 Battery pack” on page 34
• “1030 Hard disk drive(HDD)/Memory/Mini PCI Express Card slot compartment cover” on page 36
Figure 7. Removal steps of PCI Express Mini Card for wireless LAN/WAN
1
2
Disconnect the two wireless LAN cables (black, white) 1, and then remove the screw 2.
In  step 1,  unplug  the  jacks  by  using  the  removal  tool  antenna  RF  connector  
(P/N:  08K7159),  or  pick  up  the  connectors  with  your  fingers  and  gently  unplug them in the direction shown by arrows.
Notes: wireless LAN card has 2 cables in step 1.
  wireless LAN card in some models may have 3 cables in step 1.
StepScrew (quantity)ColorTorque
2M2 × 2.5 mm, flat-head, nylok-coated (1)White1.6 kgfcm 
						

							41
Lenovo V560/B560
Figure  7.  Removal  steps  of  PCI  Express  Mini  Card  for  wireless  LAN/WAN  (continued) 
Remove the card in the direction shown by arrow 3.
3
When installing:
In  models  with  a  wireless  LAN  card  that  has  two  antenna  connectors,  plug • the black cable (1st) (MAIN) into the jack labeled 1, and the white cable (2nd) (AUX) into jack labeled 2 on the card. 
In models with a wireless LAN card that has three antenna connectors, plug • the black cable (1st) (MAIN) into the jack labeled 1, the grey cable (3rd) into jack  labeled 3,  and  the  white  cable  (2nd)  (AUX)  into  jack  labeled 2  on  the card. 
						

							42
Lenovo V560/B560 Hardware Maintenance Manual
1080 Keyboard
For access, remove this FRU:
• “1010 Battery pack” on page 34
Figure 8. Removal steps of keyboard
Lift the keyboard cover with fingers in the direction shown by arrows 1.
Remove one screw 2.
1
1
1
2
StepScrew (quantity)ColorTorque
2M2 × 4 mm, flat-head, nylok-coated (1)White1.6 kgfcm 
						

							43
Lenovo V560/B560
Figure 8. Removal steps of keyboard (continued)
Lift  the  keyboard  a  little 3,  and  then  detach  the  connector  in  the  direction shown by arrows 4 5. 
3
4
5
When installing: Make sure that the FPC connector is attached firmly.  
						

							44
Lenovo V560/B560 Hardware Maintenance Manual
1090 Keyboard bezel
For access, remove these FRUs in order:
• “1010 Battery pack” on page 34
• “ 1 0 3 0   H a r d   d i s k   d r i v e ( H D D ) / M e m o r y / M i n i   P C I   E x p r e s s   C a r d   s l o t compartment cover” on page 36
• “1050 Optical drive” on page 38
• “1080 Keyboard” on page 42
Figure 9. Removal steps of keyboard bezel 
Remove four screws 1, twelve screws 2 and three screws 3 on the bottom.
2
33
22
22
2
2
2
2
2
1
2
2
1
3
StepScrew (quantity)ColorTorque
1M2.5 × 8 mm, flat-head, nylok-coated (4)Black3.0 kgfcm
2M2 × 6 mm, flat-head, nylok-coated (12)Black1.6 kgfcm
3M2 × 2.5 mm, flat-head, nylok-coated (3)White1.6 kgfcm 
						

							45
Lenovo V560/B560
Figure 9. Removal steps of keyboard bezel (continued)
Remove two screws 4. 
44
StepScrew (quantity)ColorTorque
4M2 × 4 mm, flat-head, nylok-coated (2)White1.6 kgfcm 
						

							46
Lenovo V560/B560 Hardware Maintenance Manual
Figure 9. Removal steps of keyboard bezel (continued) 
For V560:
Detach five FPC connectors in the direction shown by arrows 5 6. Unplug the microphone connector in the direction shown by arrow 6. 
6
6
5
6
5
For B560:
Detach three FPC connectors in the direction shown by arrows 5 6. Unplug the microphone connector in the direction shown by arrow 6.
6
5
6
65
When  installing:  Make  sure  that  all  the  FPC  connectors  and  the microphone connector are attached firmly.