Lawn Tractor 8211 0288 04 Stiga Villa Royal President Senator Master Operators Manual

STIGA VILLA
ROYAL
PRESIDENT
SENATOR
MASTER
8211-0288-04 

VILLA
1.
3 2
13
1
792A
8
5
1.
2a. Master
1
75
10
2A
8
2b. Senator
2B
14
6
1011
57
2c. President2d. Royal
79
5
1
2B
4 

VILLA
V-R-REGL
12
N
N
95
OPEN
N
N
3. President - Royal
8.Royal 7. Master - Senator - President
9. Master - Senator - President
10. Royal4.
5.6. 

VILLA
0.75 mm
11. Master - Senator - President12. Royal
14. Master - Senator - President
13.
15.16.
17.
18. 

VILLA 

6
ENGLISHGB
GENERAL
This symbol indicates WARNING. Per-
sonal injury and/or damage to property
may result if the instructions are not
followed carefully.
You must read these instructions for
use and the accompanying pamphlet
“SAFETY INSTRUCTIONS” careful-
ly, before starting up the machine.
SYMBOLS
The following symbols appear on the machine.
They are there to remind you of the care and atten-
tion required in use.
This is what the symbols mean:
Wa r n i n g !
Read the instruction manual and the safety...

7
ENGLISHGB
1. Pedal released – service brake
not activated.
2. Pedal depressed halfway –
forward drive disengaged. Serv-
ice brake not activated.
3. Pedal fully depressed – for-
ward drive disengaged. Service
brake fully activated.
3. PARKING BRAKE
An inhibitor that can lock the brake pedal in the de-
pressed position.
Depress the brake pedal fully. Move the
inhibitor to the right and then release the
brake pedal.
The parking brake is released by pressing the brake
pedal. The spring-loaded inhibitor...

8
ENGLISHGB
There are two positions:
1.Forward position – power take-off dis-
engaged.
2. Backward position – power take-off en-
gaged.
10. POWER TAKE-OFF
(Senator – Royal)
Switch for engaging/disengaging the electromag-
netic power take-off for operating cutting decks
and front-mounted accessories. Two positions:
1. Press the right part of the switch – the
power take-off is engaged. The symbol
will light up.
2. Press the left part of the switch – the
power take-off is disengaged.
11. CUTTING HEIGHT...

9
ENGLISHGB
STARTING AND OPERATION
ENGINE CASING
To inspect and maintain the engine and battery, re-
move the engine casing.Theenginemustnotbe
running when the casing is removed.
Dismantling:
1. Fold up both casing locks at the rear edge
(fig. 4).
2. Pull the engine casing back a little first. Then lift
it off.
Assembly:
1. Fold the seat forward.
2. Align the casing’s upper, front pins with the
slots in the front engine casing (fig. 5). Leave ap-
prox. 2 cm clearance.
3. Guide both conical side pins into...

10
ENGLISHGB
Withthe engine runningandthe driver sittingon
the seat, check as follows:
- selectagear,liftyourweightofftheseat–the
engine should stop (applies to Master, Senator).
- press the drive pedal so that the machine starts
to move, release the drive pedal – the machine
should stop (applies to President, Royal).
- engage the power take-off, lift your weight off
the seat – the power take-off should be disen-
gaged.
Do not use the machine if the safety sys-
tem is not working! Take the machine
to a...