Lawn Tractor 8211 0276 03 Stiga Park Pro20 Pro16 Royal President Senator Operators Manual

STIGA PARK
PRO 20
PRO 16
ROYAL
PRESIDENT
SENATOR
8211-0276-03 

PARK
1920
346
5
1
16
1.2.
3. 

PARK
11
9 10
7
11
9 14
7
15
14
8
9
16
15 7 13
12
18
17
2
7
1411
9
1411
8
9
16
15 7 13
4. Senator 5. President
6. Royal 7. Pro 16
8. Pro 20 

PARK
10.
12.
14. Royal
16.11 .
13. Senator - President
15.Pro16-Pro20
17. Royal 

PARK
0.75 mm
18. Pro 16 - Pro 2019. Senator - President
20. Royal
21. Pro 16 - Pro 20
22. Pro 20 Cat23.
24. Senator - President
25.Pro16-Pro20 

PARK
MAX
26.
27.
28.29a. President - Royal
29b. Pro 16 - Pro 20 

7
ENGLISHGB
GENERAL
This symbol indicates WARNING. Per-
sonal injury and/or damage to property
may result if the instructions are not
followed carefully.
You must read these instructions for use
and the accompanying pamphlet
“SAFETY INSTRUCTIONS“ careful-
ly, before starting up the machine.
SYMBOLS
The following symbols can be found on the ma-
chine to remind you of the care and attention that
are required during use.
The symbols mean:
Wa r n i n g !
Read the instruction manual and the safety
manual...

8
ENGLISHGB
3B. SERVICE BRAKE
(President - Royal - Pro16 - Pro20)
A pedal that acts upon the machine’s braking sys-
tem. There are 3 positions:
1. Pedal released – service brake
not activated.
2. Pedal depressed halfway –
forward drive disengaged. Serv-
ice brake not activated.
3. Pedal fully depressed – for-
ward drive disengaged. Service
brake fully activated.
4. PARKING BRAKE
An inhibitor that can lock the brake pedal in the de-
pressed position.
Depress the brake pedal fully. Move the
inhibitor to...

9
ENGLISHGB
4. Start position – the electric start motor
is activated when the key is turned to the
spring-loaded start position. Once the en-
gine has started, let the key return to oper-
ating position 3.
To turn on the spotlight, turn the key to position 2.
Note! If the key is turned from the stop position
to operating position 2, the spotlight is activat-
ed. This uses up battery power. Do not leave the
machine with the key in position 2 (applies to
Pro16-Pro20).
10. GEAR LEVER (Senator)
A lever for...

10
ENGLISHGB
Theswitchisusedtoadjustthecutting
height in continuously variable positions.
The contact used for connecting the cutting deck is
mounted on the right side, in front of the front tyre
(fig. 2).
17. REAR RAKE (Pro20)
The machine has been designed for electrical ad-
justment of a rear rake (available as an accessory).
Theswitchisusedtoraiseandlowerthe
rear rake.
Cables for connecting the rear rake are found at the
rear of the machine, to the left of the upper side of
the bumper. (Pro16 is...