Lawn Mower Stiga Silex 500-G Silex 500R-G Instructions Manual

STIGA
Silex 500-G
Silex 500R-G
8214-2210-80
BRUKSANVISNING
KÄYTTÖOHJEET
BRUGSANVISNING
BRUKSANVISNING
GEBRAUCHSANWEISUNG
INSTRUCTIONS FOR USE
MODE D’EMPLOI
GEBRUIKSAANWIJZING
ISTRUZIONI PER L’USO
INSTRUCCIONES DE USO
INSTRUÇõES DE UTILIZAÇÃO
INSTRUKCJA OBS£UGI
»HC“P”K÷»fl œOÀ‹«Œ¬¿“EÀfl
NÁVOD K POU®ITÍ
HASZNÁLATI UTASÍTÁS
NAVODILA ZA UPORABOSV .... 4
FI ... 10
DA .. 16
NO . 22
DE ... 28
EN... 35
FR.... 41
NL... 49
IT..... 56
ES .... 63
PT ... 70
PL .... 77
RU... 84
CZ .. 92
HU .. 98
SL ..105 

2
C AB D
E
HK
J
G
F
K F GJ
A
F
G B
1
23 

3
E CD
F
G
H
I
J
12
34
4
6
85
7 

35
ENGLISHGB
1 SYMBOLS
The following symbols can be found on the rotary 
cultivator/in these instructions. These will provide 
a reminder of the care and attention that is required 
during operation. If any symbol is missing, has 
been damaged or is illegible, it must immediately 
be replaced with a new one.
This is what the symbols mean:
Warning! Read the owner’s manual before 
operating the machine.
Warning! Rotating blade.
Warning! This symbol highlights impor-
tant text in these instructions. Risk of...

36
ENGLISHGB
• Wear tightly fitting clothes and heavy-duty 
shoes which completely cover the feet.
• The tank should only be half full when operat-
ing on slopes. Petrol can leak out.
• The engine must be stopped in the following 
circumstances: 
• When the machine is left unattended 
• Before the machine is filled up with petrol 
• Always make sure you have a good footing, es-
pecially on slopes. 
• Check that no one is in front of you or beside 
you when starting the blades. Keep a steady 
grip on the...

37
ENGLISHGB
3.6 Cable for reverse controlOnly applies to 500R-G.
The cable is marked R.
1. Hook the cable in the reverse control (1:C) and 
insert the cable in the gap in the cable housing’s 
mounting on the left handle.
2. Adjust the cable sleeve if necessary.
3.7 Drive cable1. Hook the cable in the drive control (1:D) and in-
sert the cable in the gap in the cable housing’s 
mounting on the left handle.
2. Adjust the cable sleeve if necessary.
3.8 Front protectionInstall the front protection (5:J)....

38
ENGLISHGB
4.11 Cutting disc (1:K)Nobody must be close to the dangerous 
cutting discs during operation.
The cutting discs are on respective rotor 
axles and are designed to border the working area 
and facilitate control of the machine.
4.12  ChokeThe choke must never be activated dur-
ing operation. This will damage the en-
gine.
See the accompanying engine manual.
The choke must be activated at cold starts.
4.13  Starting handle
See the accompanying engine manual.
Handle for starting the engine....

39
ENGLISHGB
5.2.1 Starting the engine from cold
1. Put the choke in position “CHOKE”. See the 
accompanying engine manual.
2. Set the throttle (1:A) in the “START” position.
3. Hold the handle with one hand and slowly pull 
the starter handle with the other hand. See the 
accompanying engine manual. When the starter 
mechanism engages, quickly and forcefully pull 
the starter handle until the engine starts.
NOTE! Do not pull the cord hard to its stop po-
sition and do not release it in the pulled out...

40
ENGLISHGB
3. Wash the pre-filter (foam rubber) in liquid de-
tergent and water. Then carefully twist the filter 
out and allow to dry.
4. When the pre-filter is dry, reinstall the filter in 
reverse order.
The filters must be replaced if very dirty or defec-
tive.
7.3 Spark plugSee the accompanying engine manual.
The sparkplug must be replaced in the following 
cases. 
• When the electrodes are burnt.
• If the porcelain insulator indicates damage.
• If the rotary cultivator is difficult to start.
The...