Lawn Mower 8211-7060-70 85 Combi, 95 Combi, 105 Combi For Mountfield 2000 And 4000 Series Instruction Manual

8211-7060-70
85 Combi, 95 Combi, 105 Combi
for Mountfield 2000 and 4000 series 

2
125 Combi Pro
4000 series 4WD, 2000 series
ABC(D)
4000 series 2WD
A B C
4000 series 2WD
GF E
4000 series 2WD
3
5 
71
4
6 
82 

3
2000 series
17”16”
1/3
11
13
159 
12
14
1610  

4
90°
PP Q
Q
45 Nm
19
 
 17
20
  18  

5
ENGLISHEN
1 GENERAL
This symbol indicates WARNING. Seri-
ous personal injury and/or damage to 
property may result if the instructions 
are not followed carefully.
You must read these instructions for use 
and the machine’s safety instructions 
carefully.
1.1 SymbolsThe following symbols appear on the machine. 
They are there to remind you of the care and atten-
tion required in use.
This is what the symbols mean:Warning!
Read the instruction manual and the safety 
manual before using the machine....

6
ENGLISHEN
3 ASSEMBLY
3.1 Assembly1. Place the deck in position in front of the ma-
chine.
2. Check that the deck mounts are installed on the 
machine as follows.
4WD 4000-series and 2000-series:
• Washer (3:D). Only machines up to and in-
cluding 2006.
• Deck mount (3:C).
• Washer (3:B).
• Circlip (3:A).
2WD 4000-series:
• Deck mount (4:G).
• Washer (4:F).
• Lock pin (4:E).
3. Screw the arms into each other. See fig. 5.
4. Remove the belt cover (6:H) by loosening the 
screw 6:I. 
5. Set the maximum...

7
ENGLISHEN
4.3 Mowing adviceIn order to achieve optimum mowing results, fol-
low the advice below:
• Cut frequently.
• Run the engine at full throttle.
• The grass should be dry.
• Use sharp blades.
• Keep the underside of the cutting deck clean.
4.4 Composting/rear ejection
The deck can cut grass in two ways:
• Compost the grass into the lawn.
• Eject the grass behind the deck.
The deck is set for composting on delivery. In or-
der to eject the grass behind the deck, the plug in 
fig. 15 must be...

8
ENGLISHEN
5.5 Blades
5.5.1 Safety
To reduce the risk of accidental injury in the event 
of a collision and to protect important parts in the 
cutting deck, a force limiter is integrated as fol-
lows.
• Shear bolts between blades and blade bar.
• Torque limiting between gear wheels and blade 
shaft.
• Possibility of positive drive belt slipping on the 
plastic gear wheels.
5.5.2 Replacing blades
Wear protective gloves when changing 
blade(s) to avoid cutting yourself.
Check that the blades are always...

Manufactured by GGP Sweden AB