Lawn Mower 8211 0315 03 Stiga Park Pro Diesel Operators Manual

STIGA PARK
PRO DIESEL
8211-0315-03 

PA R K
16
23
5
4
13
1. 2.
3. 

PA R K
117
8
13
12
6
10
9
15
14
1
G
H I
J
N D
K
M L F
E
4. 
6.
8. 9. 5. 
7.  

PA R K
GH
I
J
E, F
D
M
K
L
maxmin
10.
12. 14.
16.  11 .  
13. 
15. 
17.
1
3
2 

PA R K
18.19. 
20.  21. 
22.  23.
24. 25. 

ENGLISHGB
GENERAL
This symbol indicates WARNING. Per-
sonal injury and/or damage to property 
may result if the instructions are not 
followed carefully.
ASSEMBLY
To avoid injury and damage to people 
and property, do not use the machine 
until all the measures under “ASSEM-
BLY“ have been carried out.
ACCESSORIES BAG
The machine is supplied with a plastic bag contain-
ing components which must be installed prior to 
use. The bag contains (fig. 5):
Pos. No. Designation Dimension
D 1 Tension pin 6 x 36
E...

ENGLISHGB
SEAT
Install the seat on the seat bracket (fig. 10).
In the rear holes, the screws H should be used 
along with the shoulder washers G. Tighten the 
screws.
Then place the knobs I with the washers J in the 
front holes. 
The seat can be moved backwards or forwards. 
Place the seat in the desired position and then tight-
en the knobs properly.
The seat can be folded. If the machine is parked 
outside when it is raining, fold the seat forward to 
protect the seat cushion from getting wet.
A...

ENGLISHGB
To raise the implement, press the rear 
part of the switch. Release the switch 
in the required position.
To lower the accessory, press the 
front part of the  switch. The switch 
stays in the pressed position and the 
implement lifter is lowered until it 
reaches a floating position. This 
means that the implement can follow 
the contours of the ground.
The floating position, with the switch in the tilted 
forward position, is recommended for normal use. 
To secure the implement lifter, place...

ENGLISHGB
ating position 2.
When the key is turned from position 1 to position 
2, a warning buzzer for oil pressure can be heard. 
This buzzer will stop when the engine has been 
running for a few seconds. If the buzzer does not 
stop, turn off the engine and check the engine oil 
level.
NOTE! If the engine should stop for any reason, 
the key cannot be turned directly to position 3 
due to a mechanical ignition lock. To start the 
engine - turn the key back to position 1 and then 
to positions 2 and...

ENGLISHGB
16. CLUTCH RELEASE LEVER
A lever for disengaging the variable transmission. 
Enables the machine to be moved by hand without 
the help of the engine. There are two positions:1. Lever moved back – transmis-
sion engaged for normal opera-
tion.
2. Lever moved forward – trans-
mission disengaged. The ma-
chine can be moved by hand.
The machine may not be towed over long distances 
or at high speeds. The transmission could be dam-
aged. 
AREAS OF USE
The machine may only be used for the following...