Lawn Mower 8211 0225 06 Stiga Tornado Operators Manual
Here you can view all the pages of manual Lawn Mower 8211 0225 06 Stiga Tornado Operators Manual . The Stiga manuals for Lawn Mower are available online for free. You can easily download all the documents as PDF.
Page 1
DEUTSCHD 8211-0225-06 Tornado
Page 2
SVENSKAS ADD FULL FULL ADD 3x 1. 7.8. 2. 4. XTE 50 6. XTE 50 3. LS 45 5. LS 45 31 2 STOP 0,15 l. ADD FULL H N I
Page 3
SVENSKA S 10.9. 11 .12. LS 45 13. XTE 5014. 0,75 mm 15.16. 40 Nm
Page 4
SVENSKAS 17.
Page 5
ENGLISHGB SYMBOLS The following symbols are displayed on the ma- chine in order to remind you about the safety pre- cautions and attention necessary when using the machine. The symbols mean: Warning! Read the Instruction Book and Safety Manual before using the machine. Warning! Keep spectators away. Beware of objects being flung out. Warning! Do not put hands or feet under the cover of the machine when it is run- ning. Warning! Before starting any repair work, remove the spark plug cable from the spark...
Page 6
ENGLISHGB 3. If the lawnmower is equipped with a throttle le- ver, set throttle leverNin full throttle position (fig. 7). 4. When starting a cold engine: Press down the primer fully three times (fig. 5,6). When starting a warm engine the primer does not need to be used. If the engine stops due toa lack of petrol, refill and press down the primer 3 times. 5. Press in the Start/Stop-loop H against the steer- ing. Note that the Start/Stop loop H must be kept pressed-in to prevent the engine from stop- ping...
Page 7
ENGLISHGB Note that you should clean the area under the tim- ing gear casing once or twice a year. Set at the low- est mowing height. Slacken the screws and remove the timing gear casing (fig. 9). Clean with a brush or compressed air. The inside of the drive wheels should be cleaned once a season. To clean a wheel, remove the hub cap, screw, washer, and wheels. Brush or blow the gear and the gear ring on the wheel to clean them from grass and dirt (fig. 10). Remount the wheel. BATTERY (Tornado 51 SE)...
Page 8
ENGLISHGB ADJUSTMENT OF THE CLUTCH WIRE If the drive cannot be engaged or disengaged, it may be that the clutch wire needs adjusting. Adjust as follows: 1. Remove the transmission cover by unscrewing the screws S (fig. 9). 2. When the clutch loop is released it should be possible to pull the mower backwards without any resistance. If this is not the case, loosen the locking nut U and screw in the nipple T until the mower can be moved backwards (fig. 15). 3. When the clutch loop is pressed in approx. 2 cm...