Lawn Mower 8211 0224 09 Stiga Multiclip 48 51S Pro48 Pro51s Operators Manual

DEUTSCHD
MULTICLIP
8211-0224-09
48
51 S
PRO 48
PRO 51 S 

2
SVENSKA S
2.
3.
4.5.
1.
A
A
ED 

3
SVENSKAS
6. Briggs & Stratton LS 457. Honda
8. Briggs & Stratton XTE 60
ADD
FULL
FULL
ADD
0,15 l.
ADD
FULL
9. Briggs & Stratton Intek
10. Briggs & Stratton LS 4511. Briggs & Stratton XTE 60
3x
12. Honda
STOP
G
13. Multiclip 48/Pro 48, Briggs & Stratton
ADDFULL 

4
SVENSKA S
G
M
STOP
G
N
18. Multiclip 51 S/PRO 51 S
17.16. Pro 51 S
STOP
G
I
14. Multiclip 51 S, Briggs & Stratton15. Multiclip 48, Honda
21. Honda20. Briggs & Stratton XTE 60 / Intek
19. Briggs & Stratton LS 45 

5
SVENSKAS
40 Nm
HS
I
23. Multiclip 51 S
25. Multiclip 51 S, PRO 51 S
22.
0,75 mmBriggs & Stratton : 0,76 mm
Honda: 0,7-0,8 mm
24. PRO 51S
27.26. PRO 48, PRO 51 S
T
L K
P
K
26. PRO 51 S
U
V 

6
ENGLISHGB
SYMBOLS
The following symbols can be found on the ma-
chine to remind you of the care and attention that
are required during use.
The symbols mean:
Warning! Read the Instruction Book and
Safety Manual before using the machine.
Warning! Keep onlookers away. Beware
of objects being flung out.
Warning! Keep hands and feet clear of the
cutting deck when the machine is running.
Warning! Before starting any repair work,
remove the spark plug cable from the
spark plug.
IMPORTANT
Certain sections...

7
ENGLISHGB
Preferably use an environmentally friendly petrol,
i.e. alkylate petrol. This type of petrol has a com-
position that is less harmful to people and nature.
It has e.g. no lead additives, no oxygenators (alco-
hols and ethers), no alkenes and no benzene.
NOTE! If you change to environmental-
ly friendly petrol in an engine previously
run on ordinary lead-free petrol (95),
the petrol manufacturer’s recommenda-
tions must be followed carefully.
Ordinary lead-free 95 octane petrol can also be...

8
ENGLISHGB
By pressing down the handlebar so that the driving
wheels are raised slightly from the ground, turning,
reversing, moving round trees, etc., can be per-
formed without having to disengage the drive sys-
tem.
STOPPING THE ENGINE
The engine may be very warm immedi-
ately after it is shut off. Do not touch the
silencer, cylinder or cooling flanges.
This can cause burn injuries.
1.PRO 51S:Disengage the drive. Set the clutch
controlMto (fig. 16).
Honda:Close the fuel tap.
2. Release Start/Stop...

9
ENGLISHGB
OIL CHANGE
Change the oil when the engine is warm
and the fuel tank is empty. In order to
prevent burns, take care while draining
as the oil is hot.
Change the oil the first time after 5 hours of oper-
ation, and subsequently every 50 hours of opera-
tion or once a season. Remove the dipstick, tilt the
mower and let the oil run out into a container. Be
careful not to let any oil run on to the grass.
Fill with new oil: Use SAE 30 or SAE 10W-30 oil.
The crankcase holds approx. 0.55 litres. Fill...

10
ENGLISHGB
3. In this position, the springHshould be extend-
ed 6 mm from it’s unloaded position to provide
sufficient locking force in the transmission.
4. If the spring is not extended sufficiently, adjust
the wire nippleIat the handlebar.
5. First loosen the locking nut S and then adjust
the nippleI.
6. Set the clutch control to the position and
check that the transmission is disengaged by
rolling the mower forwards and backwards.
ADJUSTING DRIVE BELT
(Multiclip 51S, PRO 51S)
Check the belt tension...