Land Rover Range Rover Tv Video System Rover Manual

TV & Video System
TV/Video - systeem
Système TV/Video
TV und Video - System
Sistema TV/Video
Sistema de TV/Video 

As part of Rover Cars environmental policy, this publication is printed on paper made from chlorine free pulp.
RANGE ROVER
TV/Video System
Publication Part No. LRL 0344ENGPu blis hed  by  Rov er Group  Afte r S ales  - T ech nica l C ommun ic atio n© Rover Group Limited 1999
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted in any form, electronic, mechanical, 
recording or other means without prior written permission from Rover Group Limited. 

.
Contents
No.
TV/Video System
INTRODUCTION...................................................................................  1
SWITCHING ON ...................................................................................  1
TV MONITORS.....................................................................................  2
TV REMOTE CONTROL ........................................................................  3
STORING TV STATIONS...

TV/Video System
1
TV\VIDEO SYST EMS
TV/Video SystemINTRODUCTION
The TV/Video System fitted to your vehicle has 
been chosen to give the occupants a more 
enjoyable journey.
Ensure that you and your passengers take time 
to read these instructions.
Portable radios and telephones
When using portable radios and telephones near 
the unit, picture or sound interference may 
occur. Do not use these devices near this unit.
SWITCHING ON
Turn the starter switch to position ‘I’.
NOTE:  It is not advisable to use...

TV/Video System
2
TV MONITORS
The TV monitors unlike conventional TV screens 
are Liquid Crystal Display (LCD) panels allowing 
for a compact, light weight design. Because of 
this, the following should be observed:
·Do not press on the monitor unit, this can 
distort the picture or damage the LCD panel.
·Clean the LCD panel with a slightly damp, 
soft cloth using a mild household detergent.
·Do not use solvents such as benzene, 
thinner, commercially available cleaners or 
antistatic spray.
·Do not use...

TV/Video System
3
TV REMOTE CONTROL
1.Navigation button (if fitted will display NAV 
in red)
2.TV/Video button
3.China/Hong Kong button (Not used)
4.Seek button
5.Display button
6.Auto memory button
7.Programme number buttons
8.Visual/Off button
9.Volume button (Not used)
10.Select button
11.+/- button
NOTE: The volume is adjusted by using the 
volume control on the Audio system or on the 
headphones and not the remote control.
Replacing the batteries
Battery life is approximately six months 
depending...

TV/Video System
4
STORING TV STATIONS
It is possible to store up to 12 TV stations. The 
stations are accessed via the number buttons.
TV stations are stored as follows:
·Switch on the TV/Video unit.
·Turn on a TV monitor.
·Press the TV/VIDEO button (1) until a TV 
programme appears on the display.
·Hold the A.MEM button (2) for two seconds 
to store the station
OPERATING THE TV
Viewing a TV station
NOTE: When using the remote control, always 
aim it at the sensor mounted in the switch panel 
above the...

TV/Video System
5
Viewing a Video
The video system only plays back cassettes 
recorded in PAL format.
·Switch on the TV/Video unit.
·Press the TV/VIDEO button (1) to select 
either VIDEO 1 or  VIDEO 2, whichever input 
the player is connected to.
·Each time the button is pressed it will change 
in a rotational order as follows:
TV, VIDEO 1, VIDEO 2, TV
·Press the PLAY button on the video unit to 
begin playback.
·The unit displays PAL in the upper left corner 
of the display for 5 seconds.Listening to...

TV/Video System
6
Adjusting the picture (rear screens only)
You can adjust the colour and brightness of the 
picture as follows.
·Switch on the TV/Video unit.
·Press SEL, button (1). Each time the button 
is  pressed the option changes.
·Press either the ‘+’ or ‘-’ buttons (2) to adjust 
the currently selected option.
·If no button is pressed within 5 seconds the 
function will cancel.
To restore the factory default settings, press and 
hold the SEL button for more than 2 seconds.Viewing the Satellite...