Land Rover Range Rover On Board Telephone Lm 2nd Edition Rover Manual

SIM Card
10
SI M C a rdSIM CARD INSERTION/REMOVAL
Press the release button on the handset cradle. 
The handset will swing upwards and can then be 
removed from the vehicle.
The handset can also be inserted with the keys 
facing downwards. This will prevent the keys 
from being operated inadvertently.
Remove the SIM card holder from the handset.
If you have a small SIM card, it must be placed 
into the card holder with the gold chip facing 
upwards as shown.Replace the SIM card holder in the direction of...

11
SIM Card
Radio switch
The handset is connected with the base station in 
the vehicle by radio link. This limits the out-of-car 
use to a distance of 30 metres. This link can be 
switched off for workshop purposes. When 
using your car phone, ensure that the switch 
above the SIM card always remains in position 
‘1’ (to the right).
H4250 

Replacing Batteries
12
Re plac ing B a tte riesCHANGING THE BATTERIES
Inserting rechargeable batteries
1.Remove the lid of the battery compartment. 
Press the base of the handset between the 
two electrical contacts and simultaneously 
slide the cover upwards.
2.Remove the old batteries, if fitted. Insert 
two new batteries of the same type.
3.The installed arrangement of the batteries is 
shown by a sticker in the battery 
compartment.
4.Fit the cover and press to close it.
Approved battery types
Use...

13
Codes
C ode sPIN (Personal Identification Number)
Entering PIN
Each time you switch on the car phone, you are 
requested to enter your PIN. 
After the phone is switched on, the display shows 
‘Please enter PIN’.
For example, enter ‘1234’ (only asterisks appear 
in the display) and either confirm with the display 
controls 
or
 press the hash key.
NOTE: Your card is blocked if you enter an 
incorrect PIN three times in succession.
Resetting PIN block
To reset your blocked PIN you require the PUK 
code...

Codes
14
Changing the PIN code
• Call up the main menu.
•Select ‘SETTINGS 7’ and confirm.
•Select ‘PIN Settings’ and confirm.
•Select ‘Alter PIN’ and confirm.
Display shows ’ Please Enter PIN:’
and, for example, enter ‘1234’
•‘ALTER’ select.
Display shows:
‘Please Enter PIN Again:’
and, for example, enter ‘5678’
and either confirm with the display controls 
or 
 press the hash key.
Display shows:
‘Please Repeat Input’
Enter ‘5678’ and confirm again.
PIN2
Some service providers supply SIM cards with a...

15
Codes
Equipment code
The equipment code protects your vehicle phone 
against unauthorised manipulations of the 
system settings.
Enter the equipment code before the following 
functions can be used:
•Delete entire phone book.
•Loan phone.
•Preventing new SIM.
•Call screening.
•Permit only numbers from the phone book.
•Permit only the last ten numbers from the 
redial list.
NOTE: If you enter the equipment code 
incorrectly three times in succession, the above 
functions will no longer be available....

Codes
16
AUTHORISATION
Deleting entire phone book
You can delete all entries in the entire phone 
book with a single command.
To ensure that you cannot do this inadvertently 
or that it cannot be done by an unauthorised 
person, the phone code must be entered as a 
safeguard.
Restricting use by third parties
Use of the phone, e.g. if lent to another person, 
can be restricted with the ‘Loan Phone’ function:
1.the theft protection is activated, i.e. the 
phone cannot be used with a different SIM 
card....

17
Codes
Restricting choice of numbers
The function ‘Except Tel.’ can be used to restrict 
the choice of available numbers that can be 
dialled to only those in the phone book. 
To initiate:
•Call up the main menu .
•Select ‘BLOCKS 3’ and confirm.
•Select ‘Except Tel.’ and confirm.
Display shows:
‘Except Tel. Off’
•Select ‘ALTER’.
Display shows:
‘Phone Code: Please Enter’.
•Enter phone code (your equipment code) and 
confirm.
Permit only last ten numbers
The function ‘Except Last 10’ can be used to...

Codes
18
Permit only emergency call
All outgoing calls except to the emergency 
service number (112) can be barred.
• Call up the main menu.
•Select ‘BLOCKS 3’ and confirm.
•Select ‘Network Barrings’ and confirm.
•Select ‘All Calls Out’ and confirm.
Display shows:
‘All Calls Out 

Blocked’.
•Enter the password for network barring and 
confirm.
Do not permit incoming calls
All incoming calls can be barred.
• Call up the main menu.
•Select ‘BLOCKS 3’ and confirm.
•Select ‘Network Barrings’ and confirm....

19
Handset Operation
Handset OperationKEY LOCK
If it is not possible to make inputs via your 
handset, the key lock is active. This means that 
no keys can be accidentally activated while you 
are driving. However, calls to emergency 
services can be made even when the key lock is 
active.
To activate the key lock:
• Call up the main menu.
•Select ‘LOCAL SETTINGS 8’ and confirm.
•Select ‘Keys’ and confirm.
•Select ‘Key Lock’ and confirm.
In the stand-by mode, this is shown in the 
display as  .
The key...