Land Rover Important Information Rover Manual
Have a look at the manual Land Rover Important Information Rover Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 364 Land Rover manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
1IMPORTANT INFORMATION The following Declarations of Conformity are from the manufacturers of RF (Radio Frequency) equipment whose components are used in the manufacture of Land Rover vehicles. These manufacturers state that their components comply with relevant rules of the R & TTE (Radio and Telecommunication Terminal Equipment) directive. The directive requires the manufacturer of short range radio devices to self certify that RF parts fitted to Land Rover vehicles are fit for use and that the declarations are supplied with the vehicle documentation. If at a future date a technical inspection is required, the declarations will provide all necessary information. Also included are Type Approval details for Land Rover Defender and Freelander radio frequency remote control locking systems. The table indicates which countries have approved the systems and includes the official test approval number. Publication Part No. LRL 0454ENG © Land Rover 2001
2 CONTENTS
Declaration of Conformity
Defender3
Freelander4-6
Discovery II7-8
Range Rover9-10
Radio Frequency Remote Control Type Approvals
Defender and Freelander11
3 DECLARATION OF CONFORMITYThis declaration is the responsibility of the manufacturer I authorised representative within the Community: TRW Automotive Electronics 45, College Road Perry Bar Birmingham, B44 8DU UNITED KINGDOM (Name / Address) This certifies that The 433,92MHz Transmitter designated: 17TN and The 125KHz Immobilizer designated: 10AS (Product identification) complies with the essential protection requirements of R&TTE Directive 1999/5/EC on the approximation of the laws of the Member States relating to Radio Spectrum Matters, EMC and Electrical Safety. This declaration applies to all specimens manufactured in accordance with the technical documentation described in the annex II. TRW Automotive Electronics keep this documentation at the proposal of the relevant national authorities of any Member State for inspection purpose. Assessment of compliance of the product with the requirements relating ‘to the essential requirements acc. to Article 3 R&TTE was based on Annex II and Annex IV of the Directive 1999/5/EC and the following standards: Radio Spectrum:EN 300220-1 & EN 300 330 (Identification of regulations / standards) EMC:EN 300 683 & EN 300 489 Part 1 & 3 (Identification of regulations / standards) Safety:EN 60950, ISO 3795 (based on FMVSS 302) (Identification of regulations / standards) The designated products 17TN and 10AS are not submitted to harmonised standards. These devices are licence exempt and distributed in the European countries which will apply the R&TTE directive: Austria, Belgium, Denmark, Estonia, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and UK. (Place, date)(Signature) Birmingham, England 20/02/2001 JOHN BURGESS
4 DECLARATION OF CONFORMITY This declaration is the responsibility of the manufacturer I authorised representative within the Community: TRW Automotive Electronics 45, College Road Perry Bar Birmingham, B44 8DU UNITED KINGDOM (Name / Address) This certifies that the following designated product 17TN&8RCv3 (Product identification) complies with the essential protection requirements of R&TTE Directive 1999/5/EC on the approximation of the laws of the Member States relating to Radio Spectrum Matters, EMC and Electrical Safety. This declaration applies to all specimens manufactured in accordance with the technical documentation described in the annex II. TRW Automotive Electronics keep this documentation at the proposal of the relevant national authorities of any Member State for inspection purpose. Assessment of compliance of the product with the requirements relating to the essential requirements acc. to Article 3 R&TTE was based on Annex IV of the Directive 1999/5/EC and the following standards: Radio Spectrum:EN 300 220-1 (Identification of regulations / standards) EMC:EN 300 683 (Identification of regulations / standards) Safety:EN 60950 & ISO 3795 (based on FMVSS 302) (Identification of regulations/ standards) The Transmitter 17TN and 8RCv3 are 433.92 MHz radio equipment not submitted to harmonised standards. This device is licence exempt and distributed in the European countries which will apply the R&TTE directive: Austria, Belgium, Denmark, Estonia, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and UK. (Place, date)(Signature) Birmingham, England 20/02/2001 JOHN BURGESS
5 DECLARATION OF CONFORMITY We, Dynex Semiconductor Doddington Road Lincoln Lincolnshire LN6 3LF England declare that the following Car Alarm Mass Movement Sensors: DA5819-001, DA5819-002 meet the intent of the EMC Directive 89/336/EEC and the Low Voltage Directive 73/23/EEC. Compliance was demonstrated by conformance to the following specifications, which have been listed in the Official Journal of the European Communities. EMC (Requirements of ETS 30683) Emissions a)EN 55022 Enclosure b)EN 55022/CISPR 16-1 DC power in/out Immunity a)EN 6 1000-4-3 RF electro magnetic field (80 - 1000 MHz) b)EN 6 1000-4-2 Electrostatic discharge c)EN 61000-4-6 RF common mode (current clamp injection 0.15-80 MHz) d)ISO 7637 Parts 1 and 2 Transients and surges SAFETY EN 60950MERVYN K. HOBDEN Technology Leader — Sensor Products Group Date:21/02/01
6 Konformitätserklärung gemäß dem Gesetz über Funkanlagen und Telekommunikationsendeinrichtungen (1999/5/EG) Declaration of conformity in accordance with the radio and telecommunications terminal equipment acc (1999/5/EC) Hersteller: manufacturer: BMW AGAnschrift: Address:D-80788 MünchenProdukt: Product: EWS mit x für beliebige Ziffem / x for any figureDer Hersteller erklärt, daß dieses Produkt bei bestimmungsgemäßer Verwendung den Anforderungen des Artikel 3 der Richtlinie 1999/5/EG (R&TTE) entspricht und konform ist mit I The manufacturer declares that this product complies with the essential requirements of article 3 of the directive 1999/5/EC and is in conformity with: Dokument-Nr. Document No.Titel TitleAusgabe/ Ausgabedatum Edition / Date of issueEN 300330 V 1.2.2Electromagnetic compatibility and Radio spectrum Matters (ERM); Short Range Devices (SRD); Technical characteristics and test methods for radio equipment in the frequency range 9 kHz to 25 MHz and inductive loop systems in the frequency range 9 kHz to 30 MHz1999-05-06München, 27.02.2001 Martin Kaltenbrunner Dieter Stoll Development engineer Vehicle Regulations; Product Certification Active safety
7 DECLARATION OF CONFORMITYThis declaration is the responsibility of the manufacturer / authorised representative within the Community: Supplier Connaught Electronics Ltd. Supplier Address Dunmore Road, Tuam Co. Galway, Ireland This certifies that the following designated product RECEIVER 433MHz PART No.1824 (Product identification) complies with the essential protection requirements of R&TTE Directive 1999/5/ EC on the approximation of the laws of the Member States relating to Radio Spectrum Matters, EMC and Electrical Safety. This declaration applies to all specimens manufactured in accordance with the technical documentation described in the annex II. Connaught Electronics Ltd. keep this documentation at the proposal of the relevant national authorities of any Member State for inspection purpose. Assessment of compliance of the product with the requirements relating to the essential requirements acc. to Article 3 R&TTE was based on Annex IV of the Directive 1999/5/ EC and the following standards: Radio Spectrum:EN 300 220-1 (Identification of regulations / standards) EMC:EN300 683 (Identification of regulations / standards) Safety:EN 60950 (Identification of regulations / standards) (Place, date)(Signature) Tuam, Ireland 22/02/2001
8DIVISION SYSTÈMES D’ACCEÈS 42,rue le Corbusier 94042 Créteil Cedex - France Tel : 01 56 71 53 00 Fax : 01 5671 53 71DECLARATION OF CONFORMITYWe, VALEO Sécurité Habitacle 42, Rue Ie Corbusier~94042 CRETEIL — France hereby declare, At our sole responsibility, that the following product conforms to the Essential Requirements of the Radio and Telecommunications Terminal Equipment Directive 1999/5/EC in accordance with the tests conducted to the appropriate requirements of the relevant standards, as listed herewith. Product: Remote Control Systems and Immobiliser systems Model/Type Number: Valtx03 / Valrx03 and Valtkt03 Directive and Standards used: Radio EN 300-220 and EN 300-330 EMC 95/54/EC, ISO 7637-1 : 1990 Safety EN 60065 Year of affixing CE marking:2000 CE marking:Countries intended for use: All EU+EFTA Countries. VALEO ELECTRONIQUE Siege Social 2.avenue Fernand Pouillon 94042 Créteil Cedex France S A. au capital de 10.479.765 Euros 606 020 071 RCS Créteil APE 343 Z
9 DECLARATION OF CONFORMITY This declaration is the responsibility of the manufacturer / authorised representative within the Community: Supplier Connaught Electronics Ltd. Supplier Address Dunmore Road, Tuam Co. Gaiway, Ireland This certifies that the following designated product RECEIVER 433MHz PART No. 0861 (Product identification) complies with the essential protection requirements of R&TTE Directive 1999/5/ EC on the approximation of the laws of the Member States relating to Radio Spectrum Matters, EMC and Electrical Safety. This declaration applies to all specimens manufactured in accordance with the technical documentation described in the annex II. Connaught Electronics Ltd. keep this documentation at the proposal of the relevant national authorities of any Member State for inspection purpose. Assessment of compliance of the product with the requirements relating to the essential requirements acc. to Article 3 R&TTE was based on Annex IV of the Directive 1999/5/EC and the following standards: Radio Spectrum:EN 300 220-1 (Identification of regulations I standards) EMC:EN300683 (Identification of regulations I standards) Safety:EN 60950 (Identification of regulations / standards) (Place, date)(Signature) Tuam, Ireland 22/02/2001
10 DECLARATION OF CONFORMITY This declaration is the responsibility of the manufacturer / authorised representative within the Community: Supplier Connaught Electronics Ltd. Supplier Address Dunmore Road, Tuazn Co. Gaiway, Ireland This certifies that the following designated product TRANSMITTER 433Mhz PART No. 6050 (Product identification) complies with the essential protection requirements of R&TTE Directive 1999/5/EC on the approximation of the laws of the Member States relating to Radio Spectrum Matters, EMC and Electrical Safety. This declaration applies to all specimens manufactured in accordance with the technical documentation described in the annex H. Connaught Electronics Ltd. keep this documentation at the proposal of the relevant national authorities of any Member State for inspection purpose. Assessment of compliance of the product with the requirements relating to the essential requirements acc. to Article 3 R&TTE was based on Annex IV of the Directive 1999/5/EC and the following standards: Radio Spectrum:EN 300 220-1 (Identification of regulations I standards) EMC:EN300683 (Identification of regulations I standards) Safety:EN 60950 (Identification of regulations I standards) The Transmitter 6050 is a 433.92 MHz radio equipment not submitted to harmonised standards. This device is licence exempt and distributed in the European countries which will apply the R&YI7E directive: Austria, Belgium, Denmark, Estonia, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and UK. (Place, date)(Signature) Tuam, Ireland 22/02/2001