Land Rover Discovery Series Ii 01my In Car Entertainment Nas Rover Manual

							Security Code

Security Cod eSECURITY CODE INFORMATION
To reduce the risk of theft, Discovery 
radio/cassette and CD players are programmed 
with a four digit security code. Once activated, 
this code prevents the unit from functioning if it 
is illegally removed from the vehicle. There are 
10,000 different codes - making your radio 
equipment valueless to a thief unless he has the 
correct one. In addition, each unit is further 
protected by a time delay penalty system that 
effectively defies even the most systematic 
attempt to break the code.
NOTE: If an incorrect code is entered, a one 
minute time delay is imposed before a second 
code can be attempted. Each time a wrong code 
is entered, the time delay doubles (2 min, 4 min, 
8 min, etc.) making theft a very unattractive 
proposition.
On delivery of the vehicle you were supplied with 
a Security Information card. This card contains a 
record of the four digit security code, as well as 
the unit’s unique serial number. The serial 
number is also stamped into the metal side of the 
unit and, in the event of theft, would confirm 
proof of ownership.
It is VERY IMPORTANT that you keep a safe 
record of the security code and heed the 
following advice:
•NEVER keep a record of the security code in 
the car.
•If you lose your code number, contact the 
nearest Land Rover dealer, who will be able to 
obtain this information for you. 
ENTERING THE SECURITY CODE
If the code has not already been entered, or 
power to the set has been interrupted, the code 
MUST be entered before the set will operate. 
Enter the code as follows:
•Switch on the radio (‘CODE’ appears in the 
display). Press pre-set button 1.
•Press either the up or down tuning button 
(highlighted in illustration) until the first digit 
of the security code appears in the display. 
Press pre-set 1 to store the first digit in the 
units memory.
•Use either tuning button to select the second 
digit of the code (until the correct digit 
appears in the display). Press pre-set 1 to 
store the second digit.
•Select the third digit, again using the tuning 
buttons (until the correct digit is displayed). 
Press pre-set 1 to store the third digit.
•Select the final digit (the display now shows 
the full four digit code). Press pre-set 1 to 
store the final digit.
If the correct code has been selected, a two-tone 
bleep will sound and the radio will operate.
If an incorrect code has been entered, the first 
time delay period commences. During the delay 
period, ‘Err’ or ‘WAIT’ appears in the display - DO 
NOT switch off. At the end of the delay period, 
‘CODE’ reappears in the display and you can then 
enter the correct code. Remember; the time 
delay period doubles each time an incorrect code 
is entered.
IMPORTANT
Your vehicle was delivered with the security 
code disabled, if you wish to have the code 
activated, consult your Land Rover dealer.
ICE0085