L.A.R. Grizzly Big Boar 50BB Rifle User Manual

LOADING 
 
 
CAUTION:  TO REDUCE THE RISK OF UNINTENTIONAL DISCHARGE, LOAD LIVE AMMUNITION INTO THE 
RIFLE ONLY WHEN YOU ARE READY TO SHOOT. 
 
 
LOADING THE RIFLE 
 
 
1. CAUTION:  READ THE SECTION OF SAFETY INSTRUCTION COMPLETELY ON PAGES 4 TO 6. 
 
 
2. Use only ammunition recommended (see page 1) for your rifle and the caliber that corresponds. 
3. With the shell holder end up, hold the bolt in one hand as illustrated b\
elow.  Place a round into the shell 
holder. 
 Illus. No. 3 Loading the Bolt...

UNLOADING 
 
Unloading The Rifle: 
 
 
CAUTION:  REMEMBER TO UNLOAD THE RIFLE IMMEDIATELY AFTER USE AND PRIOR TO CLEANING AND 
STORAGE TO MINIMIZE THE RISK OF ACCIDENTAL DISCHARGE. 
 
 
1.  Be sure you are familiar with the Safety Instructions, pages 4 to 6.  ALWAYS POINT THE RIFLE IN A 
SAFE DIRECTION.  DO NOT TOUCH THE TRIGGER AND ALWAYS KEEP YOUR HANDS AWA\
Y FROM 
THE MUZZLE. 
 
2.  With the rifle pointed in a safe direction, make sure the trigger block \
safety is in the safe position.  If it is...

CAUTION:  IF YOUR RIFLE FAILS TO FIRE, CONTINUE HOLDING IT POINTED TOWARD THE TARGET OR SAFE, 
OPEN AREA AND WAIT 30 SECONDS.  IF A HANGFIRE  (slow ignition) HAS OCCURRED, THE ROUND SHOULD 
FIRE WITHIN 30 SECONDS.  IF THE ROUND DOESN’T FI RE, REMOVE IT AND EXAMINE ITS PRIMER.  IF THE 
FIRING PIN INDENT ON THE PRIMER IS LIGHT,  OFF CENTER OR NON-EXISTENT, HAVE YOUR GUN 
EXAMINED BY A QUALIFIED GUNSMITH.  IF THE FIRING PIN INDENT ON THE PRIMER APPEARS NORMAL 
(when compared with similar previously fired r...

Maintenance: 
 
As with any piece of fine equipment, keeping your Grizzly Big Boar clean and well lubricated will prolong its useful life.  
This section is intended to assist you in the maintenance of your Big Bo\
ar, so that it will perform better, be safer and 
last longer. 
 
 
CAUTION:  CHECK TO BE SURE THAT THE RIFLE IS UNLOADED BEFORE STRIPPING AND CLEANING TO 
AVOID ACCIDENTAL FIRING. 
 
 
 
STRIPPING FOR CLEANING 
 
1.  Make sure your rifle is unloaded and be sure you are  familiar with the...

Cleaning procedure: 
 
1.  CAUTION:  MAKE SURE THAT THE RIFLE IS UNLOADED! 
2.  Strip the rifle for cleaning as described above. 
3.  Attach a cotton flannel patch to the end of the cleaning rod, insert it in the rifle’\
s breech and pass the rod and patch down the barrel.  Repeat this step, changing the patch each time u\
ntil it comes out clean. 
 
Note:   Avoid any contact by the cleaning rod against the mu zzle, as any wear caused by the contact will reduce 
accuracy. 
 
4.  Inspect the barrel...

SERVICE AND REPAIRS 
 
If your Big Boar Rifle should need repair or  adjustment, (after MAKING SURE IT IS UNLOADED) take it or send it to \
the L.A.R. Authorized Warranty Service Center , 4133 West Farm Road, West Jordan, Utah 84088. 
 
IMPORTANT:  If you make any unauthorized adjustments or us e unauthorized parts, L.A.R. will not assume 
responsibility for the proper functioning of your G50BB rifle. 
 
NOTE:  There are various Federal and State laws, and local  ordinances, which regulate the Dealer in...

 
 
OWNER’S FIREARM RECORD 
 
 
Grizzly Big Bore Model:…………………………………………\
………………………… 
 
Serial No: _____________________ Purchase Date: _______/________/_______\
 
 
Purchased From: ……………………………………\
……………………………………… 
 
Purchase Price: ……………………………………\
……………………………………….. 
 
 
 
 
 
 
WARRANTY STATEMENT 
 
The Grizzly Big Boar Rifle was manufactured usi ng high quality materials and precise methods to 
give accurate, dependable performance.  We warrant the exercise of reasonable care in 
manufacturing, but make...

 
 
 
 
 
(16)