Keurig Brewer B60 Owners Manual

USING YOUR BREWER
OWNER’S MANUAL: Getting the most from your new 
Special Edition B60  Keurig® Brewer
COMMENT UTILISER VOTRE CAFETIÈRE
MANUEL D’UTILISATION : Tirez le meilleur de votre   
nouvelle cafetière Édition spéciale B60 de Keurig
® 

3
IMPORTANT SAFEGUARDS Safe Operation & Use
2
WARNING TO USERS AND PARENTS
1. DO NOT permit children to use brewer unless there 
is adult supervision.  Brewer dispenses very hot water.
2. SPECIAL NOTICE FOR HOT COCOA USERS:    
IMMEDIATELY AFTER USING A HOT COCOA K-CUP,   
RUN a Hot Water Brew Cycle  without a K-Cup to avoid 
the possibility of clogging the exit needle.  DO NOT assume 
the next user will do this. 
When using electrical appliances, basic   
safety precautions should be followed,...

3
CAUTION: There are two sharp needles that puncture the K-Cup® portion pack, 
one above the K-Cup Holder and the other in the bottom of the K-Cup Holder. To 
avoid risk of injury, do not put your fingers in the K-Cup Assembly Housing.
CAUTION: There is extremely hot water in the K-Cup Holder during the 
brew  process. To avoid risk of injury, do not lift the Handle or open the K-Cup 
Assembly Housing during the brewing process.
SHORT CORD INSTRUCTIONS:
 A short power supply cord is provided to 
reduce...

Set-Up
Helpful Hints 
1.  
Keep your Brewer turned “ON” at all times.   
To brew a fresh cup of coffee, tea or hot cocoa 
anytime you want, we suggest you keep your 
Brewer turned “ON” all the time. However, the 
Brewer is fully programmable so you can set it 
to turn on and off automatically to match your  schedule. Or, if you prefer, set the Brewer to   
automatically turn off after a period of time. 
Follow the simple instructions on pages 10–12 
to make using the Brewer convenient for you.
2.    For...

5
11 :
5 6AM
READY
TO BREW
MENU
Features  Special Edition — Model B60 Brewer
A
B
M
C
IN
LK
J
H
E
F
GDT
R
S
0PQ
A.  Water Reservoir Lid
B. Water Reservoir
C. Water Reservoir 
Lock Tab Slots
D.  Handle
E. Funnel
F. K-Cup® Portion Pack 
Holder (E and F are the   
K-Cup Holder Assembly) 
G.  Lid
H. K-Cup Portion 
Pack Assembly   
Housing
I.  Housing
J. Drip Tray Plate
K. Drip Tray
L. Drip Tray Base
M. Vent
N. Power Cord
O. Small Cup Button 5.25 oz.
P. Small Mug Button 7.25 oz.
Q. Large Mug Button 9.25 oz.
R....

67
SECTION 1  Set-Up & First Brew
Setting Up Your Brewer
1.  
Unwrap cord and plug the Brewer into 
a grounded outlet. Remove all pieces of   
packing tape and clear plastic sticker   
from LCD display.
2. Place a large mug (10 oz. min) on the 
    Drip Tray Plate.
3.   
Remove the Water Reservoir from Brewer 
by first removing Lid from Reservoir (fig. 1), 
then lifting Reservoir straight up and away   
from Brewer (may be tight), (fig. 2). Rinse   
with fresh water.
IMPORTANT: You cannot use your Keurig...

67
Ready to Brew Your First Cup
 1.  
LCD Control Center will indicate 
“READY TO BREW”. 
2. Place a cup or mug on the Drip Tray Plate.
3.   Lift the Handle and the K-Cup Holder  
will open toward you (fig. 6).
4.   Select a K-Cup® portion pack.NOTE: Do not remove the foil lid or
puncture the K-Cup.
5.   
Place a K-Cup portion pack in the 
K-Cup Holder (fig. 7). 
CAUTION: There are two sharp needles that
puncture the K-Cup, one above the K-Cup Holder 
and the other in the bottom of the K-Cup Holder. 
To...

89
7.  
Choose the brew size of coffee, tea or hot cocoa 
by pressing the button that indicates your 
choice. The Large Mug choice will yield a 9.25 oz.  serving, the Small Mug choice will yield a 7.25 oz. 
serving, and the Small Cup choice will yield   
a 5.25 oz. serving. 
NOTE: If you do not push the Brew Buttons in 
60 seconds, the LCD Control Center will return   
to “READY TO BREW” and the Brew Buttons will   
be disabled to prevent accidental activation.   
Re-activate the Brew Buttons by raising...

89
Adding Water
The LCD Control Center of your Brewer will  indicate when the water level in the Water   
Reservoir is low or if the Water Reservoir has  been removed by displaying the words “ADD 
WATER” (fig. 8). The blue light in the Water 
Reser voir will also blink when water needs to  be added. The Brewer will not allow you to brew   
when “ADD WATER” is displayed.
The Water Reservoir can be filled in two ways. 
1. 
 
Lift off the Water Reservoir Lid and pour  water directly into the Water Reservoir...

1011
SECTION 2  Controls & Indicators (LCD Control Center)
Setting the Clock
Setting the clock is optional. When the clock is set, the time will appear in the LCD Control Center. 
NOTE: You must set the clock if you will be using the 
On/Off Time programming feature.
1. 
Press the Menu Button.
2.  
The word “OFF” will appear at the bottom 
of the LCD Control Center to indicate that   
the clock is not set. The programming options  will appear on the LCD Control Center with a 
small arrow pointing to “SET...