Kenmore Power Miser 6 Owners Manual

21
8. Clean the area around the element opening. Remove any
sediment from or around the element opening, inside the
tank.
9. If you are cleaning the element you have removed, do so by
scraping or soaking in vinegar or a de-liming solution.
Replacement elements must (1) be the same voltage and (2)
no greater wattage than listed on the model rating plate affixed
to the water heater.
10. A new gasket should be used in all cases to prevent a
possible water leak. (See Element Gasket in the “Repair
Parts List...

22
18. Replace access panel.
19. Turn “ON” electric power to water heater.
                      
FIGURE 41.
Drain Valve Washer Replacement
.
NOTE: For replacement, use a 17/32 x 13/64 x 1/8 thick
washer available at your nearest hardware store. For
ordering a replacement washer, refer to the “Repair Parts
List” section.
• Before beginning turn “OFF” the electrical power supply to
the water heater.• Follow “Draining” instructions. See “Draining” section.
• Turning counter clockwise, remove the hex cap...

23
Start Up Conditions
THERMAL EXPANSION
Water supply systems may, because of such events as high
line pressure, frequent cut-offs, the effects of water hammer
among others, have installed devices such as pressure
reducing valves, check valves, back flow preventers, etc...to
control these types of problems. When these devices are not
equipped with an internal by-pass, and no other measures are
taken, the devices cause the water system to be closed. As
water is heated, it expands (thermal expansion) and...

24
D. An excess of active hydrogen in the tank. This is caused by
corrosion protective action of the anode.
Smelly water may be eliminated or reduced in some water
heater models by replacing the anode rod (s) with one of less
active material, and then chlorinating the water heater tank and
all hot water lines. Contact the local Sears Service Center for
further information concerning an Anode Replacement Kit
#9001453 and this Chlorination Treatment. Anode replacement
and chlorination of the tank are not...

25
2. Make sure the electrical supply to your water heater is
“ON”.
3.  Check for loose or blown fuses in your water heater circuit.
Circuit breakers weaken with age and may not handle
their rated load and should be replaced.
4.  Make certain the disconnect switch, if used, is in the “ON”
position.
5. Check to see the electric service to your house has not
been interrupted. If this is the case, contact the electric
company.
6.  Is the thermostat set to the desired temperature? See
“Temperature...

26
LEAKAGE CHECKPOINTS
Read this manual first. Then before checking the water heater
make sure the electric supply has been turned “OFF”, and never
turn the electric supply “on” before the tank is completely full of
water.
Use this guide to check a “Leaking” water heater. Many
suspected “Leakers” are not leaking tanks. Often the source of
the water can be found and corrected.
If you are not thoroughly familiar with electric codes, the water
heater, and safety practices, contact your local Sears Service...

27
KENMORE POWER MISERTM 6
ELECTRIC WATER HEATERS
NOTE:A
UPPER ELEMENT: These water heaters are equipped with 3800 watt
elements.
LOWER ELEMENT: These water heaters are equipped with factory installed
convertible elements, which can be operated at 3800 watts or 5500
watts. Convertible elements are not offered as replacement parts.
ELEMENT ORDERING INFORMATION: If a replacement 3800 watt, 240
volt element is needed, order part no. 9000049 replacement element. If,
at the time of installation, the water...

28
Now that you have purchased this water heater, should a need ever
exist for repair parts or service, simply contact any Sears Service
Center or call 1-800-4-MY-HOME
® (1-800-469-4663). Be sure to provide
all pertinent facts when you call or visit.
All Parts listed may be ordered from any Sears Service Center and by
calling 1-800-366-PART (1-800-366-7278).
If the parts you need are not stocked locally, your order will be
electronically transmitted to a Sears Repair Parts Distribution Center
for...

29
Now that you have purchased this water heater, should a need ever
exist for repair parts or service, simply contact any Sears Service
Center or call 1-800-4-MY-HOME
® (1-800-469-4663). Be sure to provide
all pertinent facts when you call or visit.
All Parts listed may be ordered from any Sears Service Center and by
calling 1-800-366-PART (1-800-366-7278).
If the parts you need are not stocked locally, your order will be
electronically transmitted to a Sears Repair Parts Distribution Center
for...

30
NOTES