JVC Lt Z26sx5 Instructions

LT-Z32/26SX5 / LCT1869-001A-H / All Cover
Cover01
WIDE LCD PANEL TVINSTRUCTIONS
LT-Z32SX5
LT-Z26SX5
ENGLISH
LCT1869-001A-H
LCT1869-001A-H_Cover.fm  Page 1  Thursday, May 19, 2005  4:17 PM
 

LT-Z32/26SX5 / LCT1869-002A / All Cover
Cover02
LT-Z32&26SX5_Eng.book  Page 2  Wednesday, May 18, 2005  5:54 PM
 

1
ENGLISH
LT-Z32/26SX5 / LCT1869-002A / English
Thank you for buying this JVC LCD flat television.
To make sure you understand how to use your new TV, please read this manual thoroughly before you 
begin. (“LCD” stands for Liquid Crystal Display.)
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS 
APPLIANCE TO RAIN OR MOISTURE.
WARNING
• Fingers may be trapped under the TV causing injuries. 
Hold the TV at the bottom in the middle, and do not 
allow it to tilt up or down.
WARNING
• The TV may...

2
LT-Z32/26SX5 / LCT1869-002A / English
ENGLISH
Failure to take the following precautions may cause damage to the television 
or remote control.
DO NOT block the TV’s ventilation openings or holes.
(If the ventilation openings or holes are blocked by a newspaper or cloth, etc., the heat may not be 
able to get out.)
DO NOT place anything on top of the TV.
(such as cosmetics or medicines, flower vases, potted plants, cups, etc.)
DO NOT allow objects or liquid into the cabinet openings.
(If water or liquid...

3
ENGLISH
LT-Z32/26SX5 / LCT1869-002A / English
„Cleaning the screen
The screen is coated with a special thin film to reduce reflection. If this film is damaged, uneven 
colours, discolouration, scratches, and other problems that cannot be repaired may occur. Pay 
attention to the following when handling the screen.
• Do not use glue or adhesive tape on the screen.
• Do not write on the screen.
• Do not allow the screen to come in contact with any hard objects.
• Do not allow condensation to form on the...

4
LT-Z32/26SX5 / LCT1869-002A / English
ENGLISH
CONTENTS
Setting up your TV ...................................5
Installation .................................................. 5
Using the stand .......................................... 5
Removing the terminal covers ................... 6
Connecting the aerial and video cassette 
recorder (VCR) ....................................... 7
Connecting the power cord to the AC 
outlet....................................................... 8
Putting the...

5
ENGLISH
LT-Z32/26SX5 / LCT1869-002A / English
Setting up your TV
• When you install the TV on the wall, only use a JVC wall mounting unit (optional) which is 
designed for this TV.
• Make sure that the TV is installed on the wall by a skilled installer.
Installation
Cautions for installation
• Install the TV in a corner on a wall or on the floor so as to keep cords out of the way.
• The TV will generate a slight amount of heat during operation. Ensure that sufficient space is 
available around the TV...

6
Setting up your TV
LT-Z32/26SX5 / LCT1869-002A / English
ENGLISH
Removing the terminal covers
There are connection terminals behind the covers on the left and right of the rear of the TV. 
Remove these two covers before connecting an antenna or VCR.
• Leave the covers off if they do not fit properly. Do not force to replace the covers. Doing so 
may cause damage to the connection cables and the covers.
„Cable holder
A cable holder which is used to keep the 
connection cables tidy is attached to the...

Setting up your TV
7
ENGLISH
LT-Z32/26SX5 / LCT1869-002A / English
Connecting the aerial and 
video cassette recorder (VCR)
Caution
• Turn off all the equipment including the 
TV before connecting anything.
• Aerial cable is not supplied. Use a good 
quality 75-ohm coaxial cable.
• Read the manual that came with the VCR 
before connecting.
If not connecting a VCR (follow 1):
Connect an aerial cable to the aerial 
socket on this TV.
If connecting a VCR:
1 Connect the aerial cable to the 
aerial input...

8
Setting up your TV
LT-Z32/26SX5 / LCT1869-002A / English
ENGLISH
Connecting the power cord to 
the AC outlet
Insert the AC plug on the power cord from 
the TV into AC outlet.
Caution
• Operate only from the power source 
specified (AC 110 – 240 V, 50/60 Hz) 
on the unit.
• Remove the AC plug from the outlet to 
completely disconnect the TV from the 
power supply.
Putting the batteries into the 
remote control
Use two AA/R6 dry cell batteries.
Insert the batteries from the - end, making 
sure the + and...