Juiceman JM503 JM503 User Manual

Model JM503
INSTRUCTIONMANUAL
LIMITED ONE-YEAR WARRANTY
Warranty Coverage: This product is warranted to be free from defects in materials or
workmanship for a period of one (1) year from the original purchase date. This product
warranty is extended only to the original consumer purchaser of the product and is not
transferable. For a period of one (1) year from the date of original purchase of the
product, our Repair Center will, at its option, either (1) repair the product or (2) replace
the product with...

NOTES
18
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should
always be followed including the following:
1. Read all instructions.
2. To protect against risk of electrical shock do not put cord, plugs,
or appliance in water or other liquid.
3. Close supervision is necessary when any appliance is used by or 
near children.
4. Unplug from outlet when not in use, before putting on or taking
off parts, and before cleaning.
5. Avoid contacting moving parts.
6. Do not operate...

17
TROUBLESHOOTING(Continued)
POSSIBLE CORRECTION
Improper fit between the Filter Basket and Hub can cause
parts of the Juice Bowl to rub against the Filter Basket. If this
is the case, call Consumer Service at (800) 233-9054.
Try a different wall outlet. Also let Juicer sit for about an hour
without turning it on; moisture may have collected on the
circuit board, causing machine to shut off. Make sure that the
Pulp Basket is properly aligned against the Juicer so that the
internal magnetic switch is...

16
TROUBLESHOOTING
POSSIBLE CORRECTION
Try juicing slower, as wet produce is more likely to build up
in the Lid. To release pulp, lightly tap on the side of the Lid.
Empty Pulp Basket if full.
Filter Basket may not have been seated correctly, causing it to
become unseated during use. Call Consumer Service at (800)
233-9054.
Snug seating is desirable. To insert, try seating the Filter
Basket on a different Hub position. To remove, turn Juice
Bowl in a clockwise direction.
This may be an isolated situation...

STORAGE
Store the Juicer in its box or in a clean, dry place. Never store the
Juicer while it is still plugged in.
Always use the Cord Storage Wrap located on the underside of the
Juicer. Never wrap cord tightly around appliance. Do not put any
stress on cord where it enters the unit, as this could cause cord to fray
and break.
15
POLARIZED PLUG
This appliance has a polarized plug (one blade is
wider than the other). To reduce the risk of electric
shock, this plug is intended to fit into a polarized...

•TO CLEAN THE FILTER BASKET:
Use a brush to make sure the tiny holes in the mesh filter are not
clogged. This can be accomplished by holding the Filter Basket
under a running faucet while brushing the mesh filter screen from
both inside and outside the Filter Basket.
NOTE:Occasionally
, the removable parts may be washed in a
dishwasher, only if
they are placed on the top shelfof the dishwasher.
However, washing with warm (not hot) tap water on a daily basis
should be sufficient.
REMOVING TOUGH STAINS
Due...

This appliance requires little maintenance. It contains no user
serviceable parts. Do not try to repair it yourself. Any servicing
requiring disassembly must be preformed by a qualified appliance
repair technician.
CLEANING YOUR JUICER
THE JUICER SHOULD BE CLEANED AFTER EVERY USE...
•Make sure that the Juicer is unplugged from the outlet; then follow
the DISASSEMBLY INSTRUCTIONS.
•
TO CLEAN THE MOTOR BASE:
Do not immerse the Motor Base in water or spray it with water.
Clean only by wiping with a damp...

STEP ONE:  Remove Clamps
Firmly grasp the hinge-end of the Clamp
and pull out to unlock; then lift the top of
the Clamp up/out to unhook from the
Clear Lid. Repeat for the opposite Clamp.
STEP TWO:  Remove Clear Lid
Grasp the Clear Lid by the Feed Tube; lift
and remove from the Juice Bowl. Make
sure to hold the Food Pusher in place if it
is being stored inside the Feed Tube.
STEP THREE:  Remove Juice Bowl   
Grasp the sides of the Juice Bowl with
both hands. With the Filter Basket still
inside, carefully...

STEP FOUR: Lock Clamps
Rest the hook-end of the Clamp into position
on the Clear Lid; then firmly pull down on
the Clamp while pushing in on the hinge-end
until it locks securely into place. Repeat for
the opposite Clamp.
STEP FIVE:  Position Pulp Basket
Place the Pulp Basket under the Clear lid
beneath the Pulp Ejection Opening. The Pulp
Basket will fit snugly against the side of the
Motor Base.
NOTE: The Pulp Basket has an internal
magnetic switch for added safety. The Juicer
will not operate if the...

STEP ONE: Place Juice Bowl
Place Juice Bowl on top of the Motor Base so
that the Juice Spout is to the front (over the
intended part of the Juicer Base). Align the
four grooves on the underside of Juice Bowl
with the four posts on top of the Motor Base.
Lower the Juice Bowl onto the Motor Base so
that the grooves fit onto the posts, rotating
slightly if necessary.
STEP TWO: Place Filter Basket
With both hands, grasp the rim of the Filter
Basket and center it over the Motor Base Hub.
Carefully lower the...